頻率均衡器 的英文怎麼說

中文拼音 [bīnlǜjūnhéngqì]
頻率均衡器 英文
frequency equalizer
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 衡 : Ⅰ名詞1 （秤桿） the graduated arm of a steelyard2 （稱重量的器具） weighing apparatus3 （姓氏） a...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 頻率 : frequency; rate
  • 均衡 : 1 （平衡的） balanced; proportionate; harmonious; even 2 （平衡） equilibrium; equilibration; equ...
  1. The brief name ring, measures a device right high, inside, low and each segment scope for ability for even emersion of signal, pointing lowestly validity returning putting the frequency with tallestly validity returning put of the frequencying. request towards device rang contain both side, on is a scoping as far as possible breadth, can be namely frequency bottom that replay the is as far as possible low, and the upper limit is as far as possible high ; two is a frequency scope the inside is at all point to respond to as far as possible flat, avoided to appeared the big motion

    簡稱頻響，衡量一件器材對高中低各頻段信號均勻再現的能力，指最低有效回放頻率與最高有效回放頻率之間的范圍。對器材頻響的要求有兩方面，一是范圍盡量寬，即能夠重播的頻率下限盡量低，上限盡量高二是頻率范圍內各點的響應盡量平坦，避免出現過大的波動。
  2. Supervisor point is behind the postposition of power amplifier, optic signals coming from a tap of 99 : 1 enter into optic spectrum scan module, then the power levels which have been calculated by iterative algorithmic are sent to power control module to guide a set of tunable electronic attenuators

    此方案將監測點放在後置功率放大器的後面，從分束器中分出99 ： 1的光進入光頻譜掃描模塊，傳給功率控制模塊的光功率值經過選代演算法后計算出均衡后的功率值送到功率控制模塊的控制中心去調節電可調節衰減器。
  3. In wavelength conversion based on four - wave mixing ( fwm ) in soa, balance efficiency can be obtained in larger range when increasing saturation power of the optical amplifier and decreasing the saturation power of spectral hole burning and carrier heating

    而在基於soa的四波混頻（ fwm ）波長轉換中，在提高光放大器飽和功率的同時減小光譜燒孔（ shb ）和載流子加熱（ ch ）飽和功率可有效提高較大頻率間隔處的轉換效率，並保持其在較大頻率失諧范圍內的效率均衡。
  4. The following algorithms have been proposed and tested in the thesis : 1 frequency selective fading : combine the isomorphism between the input space and the output space and propose a new approach to blind equalization of the channel. compared with conventional methods, the new approach offers lower computational complexity, better performance, and more robust against the over - determination of the system order ; 2 time selective fading : a new approach to the equalization of time selective channel based on the zero - forced equalizer is proposed which is more simple in its structure of algorithm ; 3 time - varying channel : using the instantaneous mean value changes of the output signal to extract the information of channel variations and model it using ar model, kalman filter is then employed to track channel variations, it bears faster ability in tracking the variation of tv channels ; based on the isomorphism between the inputs and the outputs and some of the approaches using in mimo system, a new algorithm of equalization of simo time - varying channel is proposed, which also share the merits of being robust against the over - determination of the system order ; model the time - varying channel using the multi - resolution decomposition wavelets, and then a blind identification method based " on the model is proposed ; at last, a new model for equalization and identification of mimo system is proposed

    主要工作在以下幾個方面： 1 、針對頻率選擇性衰落通道：結合輸入輸出空間同構關系提出一種新的頻率選擇性通道均衡方法，與傳統方法相比，該方法計算量更小，收斂速度更快，性能更優，且對系統階次的過確定表現穩健，具有實際均衡應用價值； 2 、針對時間選擇性衰落通道：提出一種基於迫零均衡的時間選擇性通道均衡方法，演算法結構簡單； 3 、針對時變色散通道：利用瞬態均值曲線提取通道時變信息，對之ar建模，利用卡爾曼濾波器跟蹤時變通道抽頭變化，可以快速跟蹤通道變化；基於輸入輸出空間之間的同構關系以及多輸入多輸出系統的處理方法，提出了新的單輸入多輸出色散時變通道均衡與識別演算法，同樣具有對通道階次過確定保持穩健的優點；結合小波多解析度分析提出一種基於小波模型的通道盲識別演算法；研究時變的多輸入多輸出系統的盲均衡與盲反卷積問題，給出一種時變系統處理模型。
  5. In this paper, consulting the idea of software radio and using the three important theories of maximum mean power estimate ( mmpe ) for symbol synchronization algorithm, the kalman decision - feedback equalization ( dfe ) algorithm and the decision - feedback phase lock loop ( dfpll ) algorithm, a kind of low frequency digital demodulate scheme over high - frequency ( hf ) radio channels for 8psk signial is realized

    本文利用軟體無線電的思想，提出了一種hf通道8psk信號低頻采樣數字化解調方案。討論了實現該方案的三個核心演算法：最大平均功率定時同步演算法、判決反饋式鎖相環和卡爾曼均衡器，分析它們的基本理論，並進行了性能測試。
  6. In view of the shortcomings of the existing energy - saving hydraulic pumping units, a new hydraulic pumping unit with closed oil circuit is developed, which realizes speed control by using variable frequency hydraulic technology and implements load balance with accumulator

    摘要針對現有多種節能型液壓抽油機均存在裝機功率大、能耗高、自適應能力差等缺點，提出了一種以蓄能器平衡載荷的變頻液壓閉式節能抽油機。
  7. A kind of mud based on transversal equalizer is recommended, and the performance analysis of ds - cdma systems based on that mud has been done under synchronous channels. then the expression of output signal is deduced. also, the relations among sinr of output signal, snr and correlation matrix of spread code the least mean square error ( lms ) adaptive algorithm is applied to the mud

    論文引入基於橫向均衡結構的多用戶檢測器，用矩陣方法推導了awgn通道下、同異步系統中信號輸出表達式，依據最小均方差準則，討論了同步方式下檢測器的輸出信號干擾比與信噪比、擴頻碼相關陣以及用戶功率大小等因素間的關系。
  8. Analysis the sound quality effect by the frequency response of speakers. and put forward compensate the frequency response of speakers using equalizer. compressor, expander, limiter and noise gate are important for the audio system, this paper also introduce them, and describe how to use them

    然後簡單介紹了音頻系統和組成，敘述了揚聲器的頻率響應特性及其對音質的影響，提出使用均衡器補償揚聲器頻響特性的方法；動態范圍壓縮器、擴展器、限制器在音頻系統中也起著重要的作用，本文也對其做出了介紹，並闡述了它們的用途和使用方法。
  9. And it turns out that the bit error rate of passband equalizer is smaller than that of baseband equalizer, but the convergent stability of baseband equalizer is better than that of passband equalizer. at the same time, baseband equalizer can be implemented in hardware more easily than passband equalizer

    通帶均衡系統的誤碼率總是小於基帶均衡系統的誤碼率;但基帶均衡器收斂后的穩定性要比通帶均衡器好，且基帶均衡器的采樣頻率較低，易於硬體實現。
  10. The microwave solid - state power driver which consists of broadband mmic amplifier and the equalizer carried out by this method, can exhibits a gain of 30 db, saturated output power of 500 mw, and a gain equalizing factor over 12db in 6 - 18ghz. the solid - state power driver satisfies well the request of the mpm

    利用此方法實現的均衡器與寬帶mmic放大器所組成的微波固態放大驅動模塊，實現了在6 18ghz的頻率范圍內提供了約30db的增益、約500mw的飽和輸出功率和大於12db的增益調節量，很好的滿足了mpm對固態放大驅動模塊的指標要求。
  11. In order to enhance the performance of the chip equalizer, a new scheme of chip equalizer based on pilot cancellation is presented in this paper

    為了增強碼片均衡器的性能，本文提出了一種新的基於導頻抵消的碼片均衡器，給出了導頻抵消演算法及誤符號率的計算公式，導出了基於導頻抵消的碼片均衡演算法。
  12. The thesis is composed of 9 parts : the background, significance, main topics and innovations in the thesis are introduced in chapter 1 ; in chapter 2, the main function and performance of interface circuits are described from the view of system by using the example of gigabit ethernet ' s transceiver ; the transmission media ' s frequency characteristics and model are analyzed for the high - speed data transmission system in chapter 3 ; the line driver is presented in chapter 4 ; the equalization principles for high - speed data transmission system are introduced in chapter 5 ; a novel adaptive equalizer for 1000base - cx transceiver is presented in chapter 6 ; in chapter 7, a fixed equalizer for 2. 5gbps transceiver is described ; in chapter 8, layout design and measured results are discussed ; at last, the conclusions are drawn in chapter 9. during period of finishing the thesis, i read lots of literatures about the interface circuits in high - speed data transmission system, studied their principles and design techniques, and designed : 1 、 the line driver for 2. 5gbps baseband copper cable transceiver ; 2 、 the fixed equalizer for 2. 5gbps baseband copper cable transceiver ; 3 、 the fixed equalizer for 1. 5gbps sata ( serial at attachment ) transceiver ; 4 、 an adaptive equalizer for 1000base - cx transceiver

    論文由9部分組成：在第一章引言中介紹了論文的背景、意義、國內外研究現狀，以及論文的主要內容和創新；第二章以千兆位以太網為例，從系統的角度介紹了高速數據傳輸系統介面電路的主要功能和性能指標；第三章分析了高速數據傳輸系統的傳輸介質的頻率特性和模型；第四章描述了線驅動器的設計原理及其電路實現；第五章描述了高速數據傳輸系統的均衡原理；第六章描述了適用於1 . 25gbps基帶銅纜收發器系統的自適應均衡器的設計原理和電路實現；第七章描述了適用於2 . 5gbps基帶銅纜收發器系統和1 . 5gbps串列硬盤介面（ sata ）收發器系統的固定均衡器的設計原理及其電路實現；在第八章中分析了電路的版圖設計及晶元測試結果；最後，第九章總結了全文。在完成論文期間，查閱了大量的有關高速數據傳輸系統介面電路方面的文獻，較系統地學習了線驅動器、傳輸線和均衡器等方面的理論知識和電路設計原理，設計了用於： （ 1 ） 2 . 5gbps基帶銅纜收發器系統的線驅動器； （ 2 ） 2 . 5gbps基帶銅纜收發器系統的固定均衡器； （ 3 ） 1 . 5gbpssata系統的固定均衡器； （ 4 ） 1 . 25gbps基帶銅纜收發器系統的自適應均衡器。
分享友人
分享到 Line

分享到臉書