顆粒固定的 的英文怎麼說

中文拼音 [kēlìgùdìngde]
顆粒固定的 英文
granulopectic
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  • 固 : Ⅰ形容詞（結實; 牢固; 堅硬） firm; hard; solid Ⅱ副詞1 （堅決地; 堅定地） firmly; resolutely 2 [書...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 顆粒 : 1 （小而圓的東西） pellet; bead; dust; anything small and roundish （as a bean pearl etc ）2 （一...
  1. Moreover, the presence of the activities of aerobes and anaerobes in the immobilized sludge is further conformed by specific activity experiments in aerobic and anaerobic conditions, and the microorganism community structure of the co - immobilized granular sludge in micro - aeration condition is also deduced

    厭氧好氧活性實驗也進一步證實了固定化顆粒污泥中厭氧、好氧菌活性的存在，並進一步推導出了微氧條件下氯酚固定化顆粒污泥的菌群結構。
  2. Glucose biosensors were then constructed by these nanocomposites, and their electrochemical properties had been explored. secondly, the self - assembled nanocomposite was formed by mwnts and biopolymer, and was used to study the electrochemical properties of nadh. and finally, the modified electrode which was formed by immobilizing small molecular onto electrode surface, was used to detect dsdna in the solution

    本論文首先，將多壁碳納米管（ mwnts ）與納米顆粒相結合，制備的納米復合材料用於構建葡萄糖生物傳感器，並研究了它的電化學性質;然後，將mwnts與生物聚合物自組裝制備的納米復合材料用於研究nadh的電化學性質;最後，本文還將小分子自組裝固定在電極表面，用於測定溶液中的dsdna 。
  3. Results : after cryofixation, basement membranes of skeletal muscle consisted of only one electron dense layer, t tubules were round, core cylinders were observed in terminal cisternae and there were thread - like protein particles on the membranes of terminal cisternae

    化學固定后，縫匠肌基膜由兩層組成：一層電子密度低，另一層電子密度高；橫小管為扁平狀或啞鈴狀；終池內僅有一些散在的電子密度高的顆粒，終池膜上有幾個腳狀突起伸向橫小管。
  4. First, a terminal double bond was introduced into 3 - amino - 9 - ethylcarbazole ( aec ) via methacryloyl chloride to obtain the compound, 3 - ( n - methacryloyl ) amino - 9 - ethylcarbazole ( mec ). second, mec was copolymerized with butyl methacrylate to prepare the mec - immobilized polymer particles. the resultant polymer particles were used as a fluorescence probe, which was almost free of dye leaching, and had higher photostability in comparison with free aec

    首先利用甲基丙烯酰氯向3 -氨基- 9 -乙基咔唑（ aec ）分子中引入末端雙鍵，得到帶末端雙鍵的熒光指示劑3 - （ n -甲基丙烯酰基）氨基- 9 -乙基咔唑（ mec ） ，然後通過乳液聚合技術將mec共價固定到聚甲基丙烯酸丁酯基體上，制得一種共價固定了mec的聚合物顆粒。
  5. Preparing a decolorizing material with grains formed by bacterial cells immobilized on bentonite base

    膨潤土基固定化細胞顆粒材料的研製
  6. For given solids and vessels the entrainment is very sensitive to gas velocity.

    對給定的固體顆粒和容器，其夾帶量對氣速非常敏感。
  7. Stable fluorescent labels bhhct - eu3 +, bpta - tb3 ", and europium nanoparticle were used to develop sandwich - type time - resolved fluoroimmunoassays for hbsag. fluorescence intensity was directly detected on the surface of the solid phase

    利用穩定的稀土標記物bhhct - eu3 + 、 bpta - tb3 +和銪納米顆粒建立夾心型固相時間分辨熒光免疫分析（ trfia ）直接定量測定乙肝表面抗原（ hbsag ）的新方法。
  8. 3. using scanning tunnel microscopy ( stm ) to observe microcosmic change between biomolecule and gold particle on the surface of lsaw biosensor during the process of probe immobilization and hybridization, also the naked gold membrane

    3 .利用掃描隧道顯微鏡觀察傳感器裸金膜表面、探針固定、核酸雜交過程中生物分子與金顆粒之間的微觀變化。
  9. The studies on flocculation parameters of high turbidity water are completed more integrally, including establishing the equation about the relationship between the covering ratio of flocculent on silt surface 6 and the surface area of silt particles s. the re - concentration law of thickener underflow is studies

    建立了一定沉速下，泥沙固體顆粒表面覆蓋率與泥沙顆粒表面積s間的函數關系式；較系統地完成了高濁度水絮凝參數的研究。研究了高濁度水沉澱池排泥的再濃縮規律。
  10. The products can be used in chemical. plastic, food and cement, etc. they have perfect characteristics about chemical stable, waterproof, seal up and good resistance. it s beautiful - looking, hard - using and easy - carrying

    本產品適用於化工、化學、塑料、食品、冶金粉末、礦砂等粉狀、顆粒狀、固體包裝，它具有良好的化學穩定性、防潮性、密封性、耐抗擊性，並具有質地挺括、美觀、經久耐用、易堆垛、便攜運等特點。
  11. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  12. Caculation is carried through adopting mechanism function of the first order reaction, f1 : f ( ) = l -. the results have good linear relativities, a, the precipitated fractions are excellently representative, and f1 is ascertained the most probably mechanism function of " phase precipitation. the electric field reduces activation energies of " phase precipitation and average sizes of " particles both in 2090 and 1420 alloys

    採用一級反應的模型函數f1 ： f （ ） = 1 - ，計算了相析出的動力學，計算結果具有良好的線性相關性，並且具有很好的代表性，確定f1為相析出的最概然機理函數；電場固溶使2090合金和1420合金升溫時效過程的相析出激活能有一定程度的減小，並減小了相顆粒的平均尺寸。
  13. During the trenching procedure, until concrete casting is taken, it is very crucial to maintain the stability of the trench wall, which relatives closely to geologic conditions, particle size, groundwater state, trenching skills and so on

    槽壁的穩定與地質結構、顆粒大小、地下水情況、施工工藝等因素有著密切的關系，泥漿固壁是保證槽孔穩定最有效的方法。泥漿固壁的機理和槽壁的穩定關系分析是一個非常復雜的問題。
  14. Compressed air - part 8 : test methods for solid particle content by mass concentration

    壓縮空氣.第8部分:用質量濃縮法測定固體顆粒含量的試驗方法
  15. Certain discrepancy remain between the simulation results and the experiment results, not only caused by the turbulent model, but also by the simplification of the inlet boundary condition and the mesh generation. modeling gas - particles interaction flows is complex. in this thesis, gas - phase transport equations coupled with the gas - particle interaction are derived based on the dsm turbulent models to handle the interaction of momentum and kinetic energy of turbulence between the gas and particles

    分離器內的固體顆粒運動採用涉及湍流擴散影響的隨機軌道模型和確定軌道模型，同時在湍流模型中加入了顆粒影響的源項，在流場計算的基礎上，模擬了不同直徑的顆粒在分離器內的運動規律及顆粒分離效率，並同理論和實驗得到的數據進行了比較。
  16. The results showed that the in - situ formed tibi particles which had a size of about 50nm, exhibited a homogenous dispersion in the copper matrix. moreover, the interface between the nanoscale particles and the copper matrix was clean, and there was no certain location relationship. due to their reinforcement, the tensile strength and hardness of the in - situ cu - tib _ 2 nanocomposite significantly improved

    通過光學顯微鏡、 tem 、 xrd等對cu - tib2原位復合材料進行了金相組織、微結構分析，原位復合材料的鑄態金相組織中彌散分佈著團簇狀的tib2顆粒；形變態金相組織中tib2顆粒呈纖維狀排列； tem觀察表明：在基體內存在著尺寸約為50nm 、彌散分佈的tib2顆粒，且tib2顆粒與基體之間界面清晰，但由於tib2結構與銅晶體結構的差別較大， tib2顆粒與基體之間無固定的位向關系；納米tib對銅基體有良好的增強作用。
  17. Compressed air for general use - test methods for solid particle content by mass concentration

    一般用途壓縮空氣.通過質量濃度測定固體顆粒含量的試驗方法
  18. Solid biofuels - methods for the determination of particle density

    固體生物燃料.顆粒密度的測定方法
  19. By the use of discrete phase model, the gas - solid two phase flow under different conditions were simulated. the trajectories of particles were obtained, and the influence of secondary air and particle diameter distribution were investigated. and by the compare of experimental results and numerical simulation results, the reference for the further study of numerical simulation of gas - solid two phase flow in cfb was supplied to some degree

    運用顆粒軌道模型對床內不同工況下的離散相顆粒軌跡進行了數值模擬，得出了二次風、床料粒徑分佈等因素對顆粒軌跡的影響情況，並通過模擬結果與實驗現象的對比，為循環流化床內氣固兩相流動的進一步數值模擬研究提供了一定的基礎。
  20. According with analyzing the forces acting on a particle, put forward the particle accurate motion trajectory which is determined by the certainty axial and radial force, as well as the uncertainty stochastic forces based on the above factors, the following motion characteristics between the solid and the liquid was analyzed, the following property of solid - liquid exists in all radial, axial and tangential directions

    摘要通過對旋流器內固體顆粒的受力分析，提出固體顆粒精確運動軌跡結構是由確定性的徑向力、軸向力以及不確定性的隨機力所決定，並對固體顆粒存在的隨機因素進行了分析。
分享友人
分享到 Line

分享到臉書