額定功率因數 的英文怎麼說

中文拼音 [édìnggōnglǜyīnshǔ]
額定功率因數 英文
rated power factor
  • 額 : 名詞1 （額頭） forehead:寬額 a broad forehead2 （牌匾） a horizontal tablet 3 （規定的數目） a sp...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 功 : 名詞1 （功勞） exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 因 : Ⅰ動詞[書面語] （沿襲） follow; carry on Ⅱ介詞1 [書面語] （憑借; 根據） on the basis of; in accord...
  • 數 : 數副詞（屢次） frequently; repeatedly
  1. Aimed at design index of input power 1. 5kw, most output rotate velocity 300rpm, and rating output rotate velocity 150rpm, considering factors of angle and ratio of transmission, on the basis of kinematics simulation, author optimized the kinematics parameters. in this paper, author has made some analysis and study to the primal assembly condition of transformer ' s sequential action in theory, designed structure dimension of the input and output transformer, and verified the corresponding strengthen. further, the structure, which is to key transmission components of velocity control system of the speed regulator, has been designed based on meeting operational sensitivity, precision and self - locking

    本文針對輸入功率為1 . 5kw ，最大輸出轉速，額定輸出轉速的無級變速器的設計要求，並考慮到傳動角及變速比等因素，在運動學模擬的基礎上，對運動學參數進行了優化；本文對變換器連續作用的初始裝配條件進行了理論分析與研究，對輸入、輸出變換器作了結構尺寸的設計，並進行了強度校核計算；本文還對變速器調速系統中主要傳動構件在滿足操作的靈敏度、精度、自鎖性的基礎上進行了結構設計；最後採用workingmodel3d軟體，進行虛擬樣機的計算機輔助模擬設計及運動學和動力學計算。
  2. Calibration of a wattmeter at rated voltage with 5 different current settings on one current range ( at one frequency and one power factor )

    按額定電壓，校正一個電流量程上有五個不同電流值的功率表（一個頻率及一個功率因數） 。
  3. The simulation results show that the power factor and efficiency of lim are much lower than that of rotary induction motor due to end effect and big air gap of lim. end effect force has a great influence on the thrust of lim. the performance of lim can be improved with the proper secondary structure, small air gap, big goodness factor or heavy load

    結果表明:受邊端效應及大氣隙影響，直線感應電機功率因數及效率較低;運行狀態下的邊端效應力對電機推力有較大影響;設計電機時選用合適的次級材料、減小氣隙、增大品質因數、增加負載都可提升電機的輸出性能，通過設計有效的控制演算法可使電機在額定滑差下具有較高的運行效率。
  4. The controlled object hyvp ( hydraulic pressure vibration platform ) has the property of big loading pressure and rating power, so it need considerable transmitted and control power, it also has the property of high - level math model, and narrow frequency width in closed - loop, and bad stability. this thesis is based on the hpvs in the “ tiema project ”

    被控對象（液壓振動臺）具有負載壓力和額定功率相當大的特點，因此要求傳輸和控制的功率要相當可觀;而且它還具有數學模型階數高、閉環頻帶寬度窄、穩定性差等特點。
  5. Full - sealed assembling capacitor is applied to ac power system 50 60hz with rated voltage of 6kv 10kv 35kv for improving power factor and quality of power grid, reducing transmission loss and raising the efficiency of power transmission transformation facilities

    全密封集合式並聯電容器，主要用於工頻50hz或60hz ，額定電壓6kv 10kv及35kv的交流電力系統中用來提高功率因數改善電網質量降低線路損耗，充分發揮輸變電設備效能。
  6. Full - sealed assembling capacitor is applied to ac power sys - tem 50 60hz with rated voltage of 6kv 10kv 35kv for improving power factor and quality of power grid, reducing transmission loss and raising the efficiency of transmission transformation faciliti - es. this type of capacitor has an assembling full - sealed struc - ture, and it is comprised of capacitor unit body, container, insula - ition cooling impregnant, outlet ceramic bushing, pressurereleas -

    額定電壓6kv 10kv及35kv的交流電力系統中用來提高功率因數改善電網質量，降低線路損耗，充分發揮輸變電設備效能。本產品為裝配式全密封結構。主要由器身波紋油箱絕緣冷卻油出線套管壓力釋放閥溫度控制器等部件組成。
  7. Starting current the meter can work corectly at rated voltage, rated frequency. when load currdnt is large then 0. 4 ib. power facotor : 1. running with no - load the meter use logic circuit to anti - creep

    啟動電流：在額定電壓額定頻率功率因數為1的條件下，當負載電流大於0 . 4 ib時電度表都能正常工作。
  8. As the object of the task, ups inverted by igbt with constant current adjusting and high power factor ( abbreviated to ups with constant current ) is known from others by : 1, high power factor as to the power system 2, constant current output at different level according to the demand ( from zero load to rating load )

    作為本課題的主體，高功率因數恆流調光igbt逆變ups （以下簡稱恆流ups ）具有其區別于普通ups的獨特之處： 1 、實現電網側的高功率因數2 、電源輸出為分級恆流（從零負載到額定負載） 。
  9. Power : put to say to, and the sum settle the power to is just valid index sign that evaluate the to put the function. it points within the scope of certain of the wave lose true, and the make longer a work can biggest power of the output s. enlarger while connecting into the box of the different resistance that exportation power can have different, usually the enlarger can mark clearly its sum to settle the exportation resistance ; for example a sum that set enlarger while loading a resistance to settle the exportation power to the, and load the resistance to may increase the the above. because the power there is method of various marks, some and illegal factory to can have intention to exaggerate the data, purchase or choose the hour to want with physically hear the to take in to distinct, comparison

    它是指在一定的諧波失真范圍內，功放長期工作所能輸出的最大功率。放大器在接入不同阻抗的音箱時的輸出功率會有所不同，通常放大器會標明其額定輸出阻抗例如一臺放大器在負載音箱阻抗為時的額定輸出功率為，負載阻抗為時就可能增加到以上。因為功率有多種標法，某些不法廠商會有意誇大數據，購買或選配時要以實際聽音加以區別比較。
  10. Basic calibration of a wattmeter will include tests at rated voltage and frequency with 5 different current settings on the current range ( unity power factor )

    功率表的基本校正工作包括對額定電壓及頻率在其電流量程（功率因數為一）的五個不同電流值進行測試。
分享友人
分享到 Line

分享到臉書