顯微光度計 的英文怎麼說
中文拼音 [xiǎnwéiguāngdùjì]
顯微光度計
英文
microdensimeter- 顯 : Ⅰ形容詞1 (明顯) apparent; obvious; noticeable; evident 2 (有名聲有權勢的) illustrious and inf...
- 光 : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
- 度 : 度動詞[書面語] (推測; 估計) surmise; estimate
- 計 : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
- 顯微 : microadiography
-
Equipment and instruments : electronic analytic balance, uv and vis spectrophotometer, 97rt fluorescence spectrophotometer, gas chromatograph spectrometer, high speed centrifugal machines, leica rm 2015 microtome, fluorescence microscopes, pcr amplifier, and so on
:電子分析天平、紫外可見光分光光度計、 97rt熒光分光光度計、氣相色譜儀(附4種檢測器) 、高速離心機、病理切片機、熒光顯微鏡、 pcr擴增儀等。Detection : carbon - sulfur analyzer, oxygen analyzer, glazing machine, rockwell ( vickers ) hardometer, profile projector, surfagauge, scan electron microscope, laser conductometer, magna - check, universal measuring instrument, metallograph and image analysis system, abrasion tester, universal test machine and other advanced analysis and detection equipment and instruments
檢測類:碳硫分析儀、氧分析儀、試驗室用拋光機、洛(維)氏硬度計、輪廊投影儀、表面粗糙度測量儀、掃描電鏡、激光熱導儀、磁力探傷機、萬能測量儀、金相顯微鏡及圖像分析系統、磨損試驗機、萬能試驗機及其它的先進的分析檢測設備和儀器等產品類。Optical microscopy and electron microscopy were employed to study the microstructure and ultrastructure of the leaves of low temperature germplasm and measure or count the lengths of diachyma cells, number of diachyma cells per unit leaf area, chloroplast number per diachyma cell, the number of diachyma cell layers and the number of granum lamella of low - temperature wheat germplasm
應用光學顯微鏡和電子顯微鏡研究了小麥低溫種質葉片顯微和超微結構,測量統計了葉肉細胞長度、單位面積葉肉細胞數目、單個葉肉細胞中的葉綠體數目、葉肉細胞層數和葉綠體基粒片層數。The components, microstructure, luminousness, thickness and surface topography of the films were analysised via xrd, uv ? vis, xps, ellipsometric examination and stm. the photocatalytic properties of these fims are characterized by the decomposition rate of methylene blue or rhodamine b. the effect of sputtering power, temperature, o2 mass flow, bias, w - doping and sputtering time on photocatalytic properties are discussed
採用x射線衍射儀、紫外-可見光分光光度計、 x光電子能譜儀、薄膜厚度測試儀及掃描探針顯微鏡等測試手段,研究分析了薄膜的組分、結構、透光率、膜厚和表面形貌等。And ad - link acl - 8112hg data acquisition card is used in gas road exchanging controlling to make this exchange reposefully in the system experiments, tests are given by system control programme
在預對準實驗方面,編制控製程序,利用光學顯微鏡測量對心和對缺口偏差,計算系統對準重復精度,結果達到了技術要求。All my samples with good orientation are prepared by rf sputtering. then we invest surface morphology and crystal structure, optical and electrical properties of zno films by afm, xrd, hall testing, ultraviolet - visible spectrum photometer and xps et al. zno films are fabricated on gaas substrate
本文用射頻反應磁控濺射制備了高度c軸擇優取向的zno薄膜,採用原子力顯微鏡( afm ) 、 x射線( xrd ) 、 hall測試儀、紫外?可見分光光度計和x光電子能譜等分析測試手段,研究了樣品的表面形貌、晶體結構、光學和電學性能等。Eight trapezoid labyrinth flow - channels are designed through modification to the cell dimension and the number of flow cells based on the parameterized structural design. integral emitter prototypes combining exterior hull and exterior flow - channel are built using rapid prototyping technique, and structural dimension of those flow - channel are measured by optical microscope, the measuring results showed that the design can completely meet the requirement of emitter accuracy
文中以參數化的設計思想,通過改變梯形迷宮流道單元尺寸和單元數設計了8種梯形迷宮流道,採用快速成形技術製作出外管與內迷宮流道一體化的滴頭原型;利用最小標注尺寸為50nm的光學顯微系統對滴頭流道結構尺寸進行了測量,分析結果顯示流道尺寸精度完全滿足滴頭的製作要求。Simultaneously with the micro - displacement started the processe of the grating sensor measuring the displacement and image collection of the system. the grating sensor ( length gauge ) measures the displacement of the dial gauge with surveying rod. it is delivered to the computer with a block k220 in real time and the dial image by ccd camcorder is shown on the computer screen with the image collection card in real time
在實現微量進給的同時,啟動系統的光柵位移測量過程和圖像採集過程,光柵傳感器(長度計)測得指示表測桿的位移量,由計數卡ik220實時傳送給計算機,由ccd攝像頭攝取的表盤圖像經圖像採集卡在計算機屏幕上得以實時顯示,最後通過對指示表指針位移計算處理與光柵傳感器測量的位移量進行比較,得到指示表受檢點的示值誤差。On the base of studying imaging theory of lens, the imaging theory of laser confocal scanning microscopy was analyzed in detail in this paper, and the advancement of that the optical fiber was applied to the system was described ; on the base of completed the demonstration for whole project, the experiment scheme was designed ; the relationship between the main parameters of key devices and the resolution was deduced, and the requirements of coupling efficiency and vignetting effects to optical system was analyzed ; the design of optical system and the planar scanning controlling circuit was completed ; a new method was put forward to resolved the inherent non - liner scanning problem of the galvanometer scanner by using software liner controlling in circuit design, and the perfect planar scanning was realized ; at last the low noise, high multiple and non - distortion amplify circuit of photoelectric detector was completed
本文在透鏡成像理論的基礎上,系統、深入地分析了共焦掃描顯微成像的機理,論述了應用單模光纖的激光共焦掃描顯微成像系統的優點;進行了總體方案的論證,並設計確定了單模光纖激光共焦掃描顯微成像系統的總體方案;從理論上推導分析了解析度要求與試驗系統中相關器件主要參數之間的關系,分析了系統耦合效率和漸暈現象對光學系統的設計要求;完成了方案中光學系統和二維掃描控制電路的設計,並在電路設計中採用了用軟體解決檢流計式光學掃描器(振鏡)非線性問題的新方法,能夠實現較為理想的二維模擬掃描;完成了高增益、低噪聲和低失真的探測接收系統的設計和調試。Fluorescence power transfer function, three - dimensional point spread function ( 3d - psf ) and three - dimensional optical transfer function ( sd - otf ) for the various fluorescent wavelength of the two kinds of fluorescence confocal scanning microscopy are calculated in this paper by using fourier imaging theory. the results show that the fluorescent wavelength has influence on imaging property of confocal microscopy such as spatial cut - off frequency, resolution and 3d - otf. there is a different missing - cone in the 3 - d space of otf when the ratio of excitation wavelength to fluorescent wavelength decreases
本文在sheppard和gumin等人的理論基礎上,利用fourier光學成像理論,討論了不同熒光波長對單光子和雙光子共焦顯微鏡成像特性的影響,導出了單光子和雙光子共焦顯微鏡的熒光功率傳輸函數、三維脈沖響應函數和三維光學傳遞函數,得到了它們在不同激發波長與熒光波長比值時具體的表達式,並且通過數值計算,得到了它們的曲線圖,結果表明:隨著激發波長與熒光波長比值的增加,焦斑的橫向分佈和縱向分佈變窄,橫向解析度和縱向解析度提高,系統的成像效果變好,當激發波長與熒光波長的比值下降到一定程度時,可以看到不同程度的失錐現象。The chief results and conclusion thus arrived at are as folloes : ( 1 ) the morphology and electrical properties of indium - tin - oxide ( ito ) films which were treated respectively by ethanol, naoh, sulfuric and oxygen plasma, were studied from microscopic view by atomic force microscopy, x - ray photoelectron spectroscopy and goniometer
( 1 )利用原子力顯微鏡、接觸角測試儀、紫外分光光度計從微觀角度研究了乙醇、氫氧化鈉、濃硫酸、氧等離子體處理對ito薄膜的表面性能和光電性能的影響。The thickness, microstructure and hardness of the samples were measured using microscope, sem and micro - hardness meter
利用電鏡、光學顯微鏡和顯微硬度計等分析儀器,對試樣的厚度、顯微組織和顯微硬度進行了檢測和分析。Automatic scanning microdensitometer
自動掃描顯微光密度計Zero - expansion models satisfy the request of space structures for they can possess high dimensional stability in temperature - change fields. the surface morphology, electrical conductivity and spectral reflectivity of al / kapton films before and after space environment simulated tests were
對于al / kapton薄膜試驗分別採用原子力顯微鏡、四探針電阻測量儀、紫外可見分光光度計測試其空間環境試驗后的表面形貌、面電導率、光學反射率。Optics microscope and pc connected by industry video camera of high resolution power, relied on specialized analyses soft to complete fiber diameter test
是通過高解析度的工業攝像機將光學顯微鏡與計算機相連,依靠專業的分析軟體來完成纖維直徑的測試。The sols is bright yellow and stable during a month and a half. silver sols are charaterized by a transmission electron microscopy ( tem ) and ultraviolet - visible spectrophotometer ( uv ). the result indicates that the silver particles are approximately spherical and monodispersed with an average diameter of ca. 15nm
溶膠呈亮黃色,貯存一個半月不發生凝聚,並用紫外分光光度計和透射電子顯微鏡對其研究,發現制得的納米ag為球狀粒子,粒徑為15nm 。Double beam microspectrophotometer
雙光束顯微分光光度計The tungsten oxide films with catalyst by two methods were characterized by x - diffractometer, tunnel scan - atomic force microscope, ft - ir, double - beam uv - vis - nir spectrophotometer and speediness volt - ampere cycle meter. as results of x - diffractometer, pt / wo3 sputtered film samples are crystal when annealed at 400 with distinct diffractive acuti - apices
本文分別用x衍射儀、隧道-原子力顯微鏡、傅立葉變換紅外光譜儀、雙束紫外可見分光光度計、快速伏安循環法等表徵了用以上兩種方法制備的三氧化鎢摻雜薄膜。Scanning microscope photometer
掃描顯微光度計The microstructures and physics properties of the sbn films were characterized by xrd, afm, sims, raman scattering, and spectrophotometer, electrical induced birefringence etc. the effects of growth parameters on the quality of sbn films were discussed, such as substrates, annealing temperature, and precursor solution, bufferlayer ( ksbn, mgo )
用x射線衍射儀( xrd ) 、原子力顯微鏡( afm ) 、二次離子質譜( sims ) 、受激拉曼散射、分光光度計、電致雙折射(自建系統)等方法對sbn薄膜的結構性能和物理性能進行了表徵。分享友人