飛離速率 的英文怎麼說

中文拼音 [fēilísùlǜ]
飛離速率 英文
speed; outbound
  • 飛 : Ⅰ動詞1 （鳥、蟲等在空中活動） fly; flit 2 （利用動力機械在空中行動） fly 3 （在空中飄浮遊動） fly...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 飛離 : departure
  • 速率 : speed; rate; tempo
  1. In this paper, firstly the macro parameter of the series connection app was comprehensively analyzed, among which the trajectory location of the bullet emission and the terminal velocity of the bullet were mainly analyzed, and the feasibility of the series connection app to cope with explosive reactive armor was demonstrated. and then the macro design about the head of the series connection app was made, among which a particular analyse about the bullet " s launching process was made, from which we concluded the relation between the thickness of the airproof loop and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the burning rate of the powder and the relation between the length of the bullet and the maximum pressure of the emission hole and the relation between the length of the bullet and the emitting time of the bullet, and the reasonable str ucture of the head of the carrier and bullet were designed, then the intensity of the head of the carrier was checked out using of the software of ansys

    本文首先對子母式穿甲彈總體參量作了全面的計算分析，其中主要分析了子彈射出的彈道位置和必要的子彈著靶速度，論證了子母式穿甲彈對付爆炸式反應裝甲的可行性，然後對子母式穿甲彈彈頭部進行了總體設計，其中主要對子彈的發射過程進行了詳細的分析，得出了母彈彈頭部發射孔內閉鎖環厚度與子彈飛離母彈速度的關系、子彈長度與子彈飛離母彈速度的關系、子彈長度與火藥燃燒率的關系、子彈長度與母彈彈頭部發射孔內最大壓力的關系以及子彈的長度與子彈發射所需時間的關系，設計出了合理的母彈彈頭部結構和子彈的結構，並利用ansys有限元分析軟體對母彈彈頭部的強度進行了校核。
  2. The armor plate is a product of no cutting bits, holding the advantages that being high usingrate, firmintensity, slippery proof, easy to fix, durability and breezy, ectc. it can be used as motoway partition, air field runway and used for mine, dock, working platformand so on

    篩網作為一種無切屑產品，其鋼板利用率高，強度牢固，具有防滑、通風性能好、施工方便、經久耐用等優點；用於高速公路建築、大型飛機楊跑道、礦井、碼頭、工作平臺、隔離等。
  3. Second, by computing the trajectory of the missile and the method of analyzing cep, influences that the fighter ' s height, speed, pitch angle, the deflection angle between fighter and target, and the target moving characters make on the times of fighter attack and missile launch are deeply developed. third, by relating the motion of the missile and the fighter, the influences that fighter ' s dive angle and the deflection angle between fighter and target make on the attack field of the fighter are discussed in this paper when the fighter perform vertical and horizontal attack. criterion of attack effect is proposed focusing on attack time of the fighter, trajectory of the missile and destruction probability to the target

    本文主要完成了以下幾個方面的工作：對導彈可發射區和飛機可攻擊區進行建模，通過對導彈彈道的模擬計算，並運用典型的圓概率偏差精度分析方法，詳細討論了飛機實施攻擊時，飛機的飛行高度h 、速度v 、俯仰角、與目標的偏離角_ x及目標運動特性等對飛機攻擊時機和導彈發射時機的影響；因此，將飛機和導彈結合起來，詳細研究了飛機在垂直平面和水平平面內實施攻擊時，飛機俯沖角和與目標的偏離角_ x對飛機的攻擊范圍的影響；以飛機實施攻擊的時間t 、彈道特性和對目標的殺傷概率p來評判對地攻擊的效果；最後給出典型算例，通過對空地攻擊過程的模擬實現，對飛機飛行過載提出要求。
  4. Improvements in performance include reductions in specific fuel consumption ( 4 % ), take - off distance ( 10 - 20 % ), minimum speed ( 100 kias ), time to climb and increase in specific excess power, sustained load factor and sustained turn rate ( 15 % )

    性能改進方面包括減少4 %的耗油率，縮短10到20 %的起飛距離，減少最低速度大約一百指示空速節，縮短爬升時間和增加單位剩餘功率，提升15 %的持續回轉率與持續負載系數。
  5. At fast speeds, centrifugal force causes the plane ' s turn radius to increase and its turn rate to decrease

    在高速下，離心力將導致飛機的轉彎半徑增加和回轉率降低。
分享友人
分享到 Line

分享到臉書