飽和蒸汽 的英文怎麼說

中文拼音 [bǎohézhēngqì]
飽和蒸汽 英文
saturated steam; saturated vapour
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  1. A vapour at saturation is in equilibrium with the bulk phase.

    飽和蒸汽和凝結相處于平衡狀態。
  2. Data of 2120 class saturated steam locomotive

    2120型飽和蒸汽式水櫃蒸汽機車基本資料
  3. Specification for rubber hoses for high - pressure saturated steam

    高壓飽和蒸汽橡膠管規范
  4. Rubber hoses and hose assemblies for saturated steam - specification

    飽和蒸汽用橡膠軟管和軟管組件.規范
  5. Specification for rubber hoses for low - pressure and medium - pressure saturated steam

    低壓和中壓飽和蒸汽用橡膠軟管規范
  6. Biological indicators for saturated steam sterilization processes in health care facilities

    醫療保健設施的飽和蒸汽消毒處理用生物指示計
  7. The results show that in 185 saturated steam, pyrite tailing doesn ' t hydrate alone, but is converted into calcium silicate hydrate when mixed with lime

    結果表明： 185飽和蒸汽壓下，硫鐵尾礦不具有水熱水化的能力，硫鐵尾礦與石灰可以形成具有膠凝性能的水化產物。
  8. Abstract : based on the analysis of the mathematics models of saturation steam density and superheat steam density the paper states that the deviation of the detection on temperature highly affects the accuracy of intelligent flow totalizer. especially for saturation steam ， the accuracy of the temperature detection circuit shall be designed higher than the accuracy of the instrument. thus a temperature detection circuit based on ratio method with high accuracy is introduced

    文摘:在分析飽和蒸汽和過熱蒸汽密度的數學模型的基礎上指出，溫度檢測的偏差對智能流量積算儀的精度影響極大，尤其是飽和蒸汽，測溫電路的精度應設計為遠高於儀表的精度，同時引入一種基於比率法的高精度測溫電路。
  9. Segment timer may use to record pressent year, month, date, display pressent time, and with four - segment alarm function, alarm circlate in the sequence of time from first segment to forth segment alarm point it is display intuitional, clocking accuracy, alarm reliable, with clock keep function while key off function

    採用先進的微處理器進行智能控制，主要適用於供熱供暖製冷等熱能系統中，對熱水過熱蒸汽飽和蒸汽氯化鈣水或其它制熱製冷介質中的熱能進行高精度的積算與控制。
  10. High water saturated vapour pressure leads to the more possible occurrence of cavitation phenomena in water hydraulic pump, and so as in sliding shoes hydraulic supporting without exception

    水的高飽和蒸汽壓力使得水壓泵中極易發生氣蝕現象，滑靴靜壓支承也不例外。
  11. Metering and regulating of two - phase flow in heavy oil thermal recovery

    稠油熱采注入飽和蒸汽的計量和調節
  12. Saturated vapour pressure

    飽和蒸汽壓力
  13. Saturated vapor pressure

    飽和蒸汽壓
  14. The project studied the direct contact condensation behavior of saturated steam on the subcooled liquid in passive gravity injection system. the experiment parameters were as follows : the initial pressure of prz ranged from 0. 2 0. 6mpa and the initial fluid temperature of core makeup tank ranged from 10 80. condensation phenomenon in cmt was observed

    本課題進行了非能動重力補水系統中飽和蒸汽在過冷液面上直接接觸冷凝的實驗研究，研究了在加裝遮流板時，系統壓力0 . 2 0 . 6mpa ， cmt初始溫度為10 80條件下壓力容器cmt中飽和蒸汽在過冷液面上冷凝的瞬態特性。
  15. In order to size a stop - check the technical information needed is saturated steam gage pressure in pounds per square inch and actual required steam volume flow in pounds per hour

    為了確定正確的截止止回閥的通徑，需要下列有關的技術參數，飽和蒸汽表壓（磅/平方英寸） ，和實際所需的正氣流量（磅/小時） 。
  16. B20 10 nov. 2005 umekoji steam locomotives museum from 1944 to 1945, the manufacturing industies, tateyama, and jnr kouriyama works, had produced the 15 cars of this class

    B20型是國鐵型號中最小的蒸汽機車而且是唯一的飽和蒸汽機車，而但沒有空氣制動裝備蒸氣制動。
  17. A treatment method of super - saturation steam for deposited salt in steam turbine is introduced, output of the steam turbine is therefore improved through purge. purification process and attentions are introduced

    摘要介紹了背壓式汽輪機積鹽積垢的處理方法?過飽和蒸汽法，通過清洗使汽輪機的出力率得以提高。介紹了清洗的過程和注意事項。
  18. Saturation vapour pressure of internal combustion engine under actual operation conditions is expressed as the multinomial by using least square method, which facilitates the calculation of rectifying coefficient of engine output and fuel consumption as well as the fabrication of computer programme for such calculations

    摘要介紹了用最小二乘法擬合方法，將內燃機現場環境狀況下飽和蒸汽壓表示為多項式形式，為計算功率和燃油消耗率校正系數，並為此而編制計算機程序提供方便。
  19. The paper is on how to set up lab platform of vapour spewing to uppercooling water surface to coagulate directly and to observe and analyse which vapour coagulate on the water surface, the results enable people to know the security system of nuclear power. the range of the pressure parameters of prz is from 0. 2mpa to 0. 6mpa, and the range of the initial temperature parameters of cmt is from 23. 5 to 78. 5, all of the testing points are 30 and there are fifty thousand testing data. many results of vapour spewing to uppercooling water surface vertically to coagulate can get. for example : coagulating can make the water of cmt surge forcefully when vapour spews to uppercooling water surface, too many vapour - bubbles come into being and strike the water of cmt owing to rupture continually, all these will strengthen the surge because of the vapour pressure of cmt

    實驗中prz飽和蒸汽壓力變化范圍為: 0 . 2mpa - 0 . 6mpa ， cmt中水初始溫度變化范圍: 23 . 5 - 78 . 5 ，實驗中測試工況30個左右，實驗測試數據50萬余個，得出了很多與非能動安全系統相關的蒸汽垂直噴向過冷水表面凝結時的結論：蒸汽垂直噴入過冷水表面凝結時會造成cmt中液面的強烈波動和振蕩，產生大量蒸汽汽泡，汽泡不斷破裂對cmt中液體帶來很大沖擊，勢必引起cmt中液體的振蕩，造成cmt汽空間汽壓不均勻，加強cmt液體的振蕩和波動。
  20. There will be a hot water layer in the water of cmt when vapour spews to uppercooling water surface vertically and coagulates directly. the higher of the vapour pressure of prz and the initial water temperature of cmt are, the deeper the hot water layer is. and obtaining the experience formula of the hot water layer is as follows : the condensation coefficient is high when vapour coagulate at first, then it will lessen with the process of coagulation, the higher of the vapour pressure of prz and the initial water temperature of cmt are, the higher of condensation coefficient is

    蒸汽垂直噴入過冷水表面凝結時， cmt中水有明顯熱分層現象， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，熱分層厚度越大，熱分層厚度的經驗關聯式為：凝結剛開始時，凝結換熱系數非常大， ，隨著凝結的進行，凝結換熱系數越來越小， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，凝結換熱系數越大。
分享友人
分享到 Line

分享到臉書