饋線調整器 的英文怎麼說

中文拼音 [kuìxiàndiàozhěngqì]
饋線調整器 英文
feeder regulator
  • 饋 : 動詞（饋贈） make a present of
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 饋線 : [電工] feeder line; feeder; supply line; feed line; transmission line饋線電纜 [訊] feeder cable; ...
  • 調整 : adjust; tune up; trim; trimming; variation; modulation; arrangement; debug; rectification; redres...
  1. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整流側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發電機勵磁電壓作為控制變量，以直流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出，用直接反饋線性化方法設計了系統的非線性控制器。
  2. The auxiliary modulating signals of the current controller at the rectifier and the extinction angle controller at the inverter, and the reference voltage of exciter are chosen to be control variables. then the all - state feedback linear optimal controller is designed

    以直流系統整流側電流控制器的輔助調節信號、逆變側關斷角控制器的輔助調節信號以及勵磁系統參考電壓作為控制變量，設計了系統的全狀態反饋線性最優控制器。
  3. According as the analysis of third - order inter - modulation of high - power amplifiers, an innovative practical method to adjust the feed - forward amplifier system to optimize the performance of feed - forward amplifier system is described. the application of feed - forward linearisation to a 890 - 915mhz amplifier is described

    詳細分析了高功率放大器的三階互調產物的特點，並據此創新的提出了調整前饋線性化系統狀態，優化前饋放大器性能的正確方法。
  4. Secondly, to achieve the independent regulation of active and reactive power output from the generator side which is designed for the purpose of tracing the maximum wind - energy capturing. the paper has analyzed the mathematic model of the ac excited doubly - fed machine and the stator field orientation control strategy of the motor as vscf wind power generator. thirdly, it has put forward and designed the dual pwm converter with the capacity of energy flowing bidirectional aimed at the demand of rotor energy bidirectional flow. the author constructed reliable and integrated experimental system and did a series of experimental study including no - load, cutting - in network and power generation at, below and above the synchronous speed

    論文首先分析了風機運行特性及其最佳風能利用原理，通過模擬及實驗驗證了採用直流電機的輸出特性模擬風力機的最大輸出功率曲線的可行性，並給出了模擬系統的硬體結構；然後為了實現交流勵磁發電機有功、無功功率獨立調節機理，分析了交流勵磁雙饋發電機的數學模型和在追蹤最大風能捕獲變速恆頻風力發電時必需的定子磁鏈定向矢量控制策略；針對雙饋發電機轉子能量雙向流動的要求，提出並設計了具有能量雙向流動能力的雙pwm交流勵磁用變頻器；最後為實現從理論到實踐的全面研究，研製出了一套小功率完整的雙pwm變頻器交流勵磁的雙饋風力發電機實驗系統，進行了空載、並網、同步速及上、下的發電運行等一系列的運行實驗；所完成的模擬和實驗研究均驗證了理論、模型和控制策略的正確性、可行性。
  5. Compared with traditional feedforward, this paper presents an adaptive control method based on power detection minimization. with strong and fast digital signal processing ability, the adaptive system can control feedforward amplifier parameters exactly and suppress non - linear products at last by detecting changes of signals and environments

    與傳統前饋法相比，本文加入了基於最小功率檢測演算法的自適應控制電路，對輸入功率變化、溫漂和器件老化等導致系統性能下降的擾動進行自適應調整，使功放的非線性失真在很大程度上得到改善。
  6. So most software can be test on the pc and can be transplanted to gateway after all is ok. the platform is designed from top to bottom, at first, the functionalities and interface of the three module should be specified clearly, and then go into the details of it, came back to modify the interface made before. the tree modules are connected through pci bus. adsl module implements the adsl modern as the atu - r ; the network interface consists of two part, wileless lan ( it is optional ) and lan, can connect with two different lan. the main control module controls the action of the others which is made of sdram, microcontroller, flashrom and serial port

    為了設計方便，整個硬體平臺按照自頂向下的設計方式，首先按照功能分為三部分： adsl模塊，網路介面模塊，主控模塊，這些模塊之間採用流行的pci總線相連接，規定模塊之間的介面關系，然後進行細化，反饋回來完善原先定義的介面關系。其中， adsl模塊可作為單獨的adsl數據機使用，起到atu - r的功能：網路模塊由兩部分組成，無線lan和lan介面（其中前者為可選項） ，可以連接wirelesslan和lan 。主控模塊起到協調的作用，包括sdram 、微控制器、 flashrom 、串口等。
分享友人
分享到 Line

分享到臉書