饋線 的英文怎麼說

中文拼音 [kuìxiàn]
饋線 英文
[電工] feeder line; feeder; supply line; feed line; transmission line饋線電纜 [訊] feeder cable; 饋線夾 feeder clip; 饋線天線 feeder antenna; 饋線網路 feeder network; 饋線系統 feeder system; feed line system; 饋線柱 feeder pillar
  • 饋 : 動詞（饋贈） make a present of
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  1. The distribution of electric energy is accomplished by dividing and subdividing large-capacity feeders into feeders of smaller and smaller capacity.

    電能的分配是通過把大容量饋線分支和再分支成容量越來越小的饋線的辦法來實現的。
  2. Integrated with scada, da, fa, sa

    配電scada饋線自動化配電工作管理一體化集成
  3. In addition the duplex system, antenna and feeder line are discussed

    另外對系統的雙工體制及天饋線也進行了分析和討論。
  4. Feeder feeder line

    饋管饋線
  5. After analyzing several kinds of protection for feeder line in subway dc traction power supply system, it is pointed out in the paper that the phenomena of refusing action and error action can not be avoided with existing protection which can not protect the whole feeder line

    摘要分析了地鐵直流牽引供電系統中幾種常用的饋線保護類型，發現現有的保護方法很難避免跳閘保護拒動或誤動現象的發生，並且不能保護饋線的全長。
  6. A new model of distribution system is presented, whereby, the feeder switches are regarded as the vertcxes of a graph and the feeder lines are regarded as the arcs. the method to model distribution networks by adjacent table is put forward. therefore, storage size is reduced and calculation is speeded up

    建立了配電網的簡化模型，即將饋線開關當作圖的頂點、將饋線當作弧，採用等長鄰接表的數據結構來描述配電網，大大減少了佔用空間和提高了查詢速度，並建立了基於等長鄰接表的配電網路拓撲演算法。
  7. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整流側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發電機勵磁電壓作為控制變量，以直流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出，用直接反饋線性化方法設計了系統的非線性控制器。
  8. On the basis of methods of feedback linearization and compound lyapunov, the author puts forward a sort of robust output track control rule with a regulable parameter. this rule not only guarantees the system exponent output track but also makes the closed loop system have limited states

    基於反饋線性化方法和復合lyapunov方法，作者提出了一種具有可調參數的魯棒輸出跟蹤控制律，不僅可以保證系統指數輸出跟蹤，而且閉環系統狀態有界。
  9. Cable connections are made to the side of the battery by means of threaded bolts into "cast-in-lead" stainless steel nuts.

    在蓄電池一側，利用螺栓擰到「鑲鑄鋁」的不銹鋼螺帽上進行饋線連接。
  10. Radio - frequency connectors. part 3 : two - pin connector for twin balanced aerial feeders

    射頻連接器.第3部分:雙股平衡天線饋線用雙插針連接器
  11. Electrical equipment for aircraft. feeder protection housing for direct current generator

    飛機電氣設備.直流發電機饋線保護箱
  12. The auxiliary modulating signals of the current controller at the rectifier and the extinction angle controller at the inverter, and the reference voltage of exciter are chosen to be control variables. then the all - state feedback linear optimal controller is designed

    以直流系統整流側電流控制器的輔助調節信號、逆變側關斷角控制器的輔助調節信號以及勵磁系統參考電壓作為控制變量，設計了系統的全狀態反饋線性最優控制器。
  13. A method of calculating millimeter wave microstrip antenna array feed line loss

    一種計算毫米波微帶天線陣饋線損耗的方法
  14. Basic principle of the simplification is detailed. feed lines with branches is also discussed. the proposed approch is verified by branch current based power flow calculation

    論述了簡化分析的基本原理，並採用支路電流法驗證了該方法的可行性，還討淪了帶有支線的饋線的處理問題。
  15. A novel distribution network optimal control approach for load balancing is presented based on the simplified model of distribution system, in which tie switches are regarded as critical elements. the two feeder lines connected with a tie switch are regarded as a feeder couple. load balancing ratios of feeder couples and total distribution network are defined and be used as indice of network reconfiguration, respectively

    提出一種以聯絡開關為核心的用於負荷均衡化的配電網路優化控制方法，將每個聯絡開關對應的兩條饋線看作饋線偶，定義了饋線偶和配電網的負荷均衡率，並以此作為網路優化的評價函數，這樣配電網路重構過程就由若干饋線偶內負荷均衡化過程組成，在此基礎上發展了以負荷均衡化和降低線損為目標的配電網優化方法。
  16. An automatic fault location method is proposed based on ftu after the circuit analysis of single line - to - ground fault in distribution networks

    通過對配電網發生單相接地故障后饋線的電壓、電流變化規律的分析，論文提出了基於饋線現場監控終端ftu的故障點智能定位方法。
  17. Two feedback linearization methods are presented

    分析基於反饋線性化的mpc穩定性。
  18. In applications of feed - forward linearization technique, the overall amplifier efficiency is significant concerned. giving mathematical analysis and simulation results, the paper present two practical methods to optimize the efficiency of a feed - forward amplifier system

    針對前饋線性化技術應用中倍受關注的系統效率問題進行了數學推導和模擬，提出實踐中提高效率的兩種方法及其適用條件。
  19. According as the analysis of third - order inter - modulation of high - power amplifiers, an innovative practical method to adjust the feed - forward amplifier system to optimize the performance of feed - forward amplifier system is described. the application of feed - forward linearisation to a 890 - 915mhz amplifier is described

    詳細分析了高功率放大器的三階互調產物的特點，並據此創新的提出了調整前饋線性化系統狀態，優化前饋放大器性能的正確方法。
  20. Directed against the distributing fault disposing mode and centralizing fault disposing mode of distribution distribution feeder automation, we use two different research methods respectively. under the distributing fault disposing mode ， combined with the technological ameliorate of the applying plc in the switch control department of the urban distribution ring feeder, we design a new voltage - current feeder automation flow executing by recloses and sectionnalizers controlled by plc to locate the distribution feeder fault section

    針對配電網饋線自動化的故障分佈處理模式和故障集中控制模式，分別採用了不同的研究方法：在配電網採用故障分佈處理的模式下，結合應用於城市手拉手配電環網的環網開關櫃的技術改造，設計了一種新的電壓-電流型饋線自動化模式，利用可編程序控制器（ plc ）來控制饋線上的重合器和分段開關來實現配電網饋線的故障區域定位。
分享友人
分享到 Line

分享到臉書