饋電調整器 的英文怎麼說

中文拼音 [kuìdiàndiàozhěngqì]
饋電調整器 英文
feed regulator
  • 饋 : 動詞（饋贈） make a present of
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 調整 : adjust; tune up; trim; trimming; variation; modulation; arrangement; debug; rectification; redres...
  1. At first, according to the concrete requirement of the servo control system, a collective scheme, which provide guarantee to meet the requirements of the global performance, is established. in this scheme, the structure of gimbal and the torque motor driven mode are adopted, and angle measurement is accomplished by inductosyn and velocity measurement is accomplished by dynamically tuned gyro respectively

    首先，根據目標真值測量設備伺服系統的具體要求，確定了地平式常平架結構，力矩電機驅動，分別採用動力調諧式速率陀螺儀及圓盤式感應同步器作為速率及位置反饋元件這一總體方案，為伺服系統滿足整體性能指標要求提供了保證。
  2. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整流側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發電機勵磁電壓作為控制變量，以直流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出，用直接反饋線性化方法設計了系統的非線性控制器。
  3. Voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  4. Abstract : voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    文摘:採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  5. The auxiliary modulating signals of the current controller at the rectifier and the extinction angle controller at the inverter, and the reference voltage of exciter are chosen to be control variables. then the all - state feedback linear optimal controller is designed

    以直流系統整流側電流控制器的輔助調節信號、逆變側關斷角控制器的輔助調節信號以及勵磁系統參考電壓作為控制變量，設計了系統的全狀態反饋線性最優控制器。
  6. The way that two kinds of different potentiometer feeding back the blade gap value in adjusting mechanism of cnc shear have been introduced

    摘要介紹了數控剪板機刀片間隙自動調整機構中兩種不同電位器反饋刀片間隙值的方式。
  7. Secondly, to achieve the independent regulation of active and reactive power output from the generator side which is designed for the purpose of tracing the maximum wind - energy capturing. the paper has analyzed the mathematic model of the ac excited doubly - fed machine and the stator field orientation control strategy of the motor as vscf wind power generator. thirdly, it has put forward and designed the dual pwm converter with the capacity of energy flowing bidirectional aimed at the demand of rotor energy bidirectional flow. the author constructed reliable and integrated experimental system and did a series of experimental study including no - load, cutting - in network and power generation at, below and above the synchronous speed

    論文首先分析了風機運行特性及其最佳風能利用原理，通過模擬及實驗驗證了採用直流電機的輸出特性模擬風力機的最大輸出功率曲線的可行性，並給出了模擬系統的硬體結構；然後為了實現交流勵磁發電機有功、無功功率獨立調節機理，分析了交流勵磁雙饋發電機的數學模型和在追蹤最大風能捕獲變速恆頻風力發電時必需的定子磁鏈定向矢量控制策略；針對雙饋發電機轉子能量雙向流動的要求，提出並設計了具有能量雙向流動能力的雙pwm交流勵磁用變頻器；最後為實現從理論到實踐的全面研究，研製出了一套小功率完整的雙pwm變頻器交流勵磁的雙饋風力發電機實驗系統，進行了空載、並網、同步速及上、下的發電運行等一系列的運行實驗；所完成的模擬和實驗研究均驗證了理論、模型和控制策略的正確性、可行性。
  8. Compared with traditional feedforward, this paper presents an adaptive control method based on power detection minimization. with strong and fast digital signal processing ability, the adaptive system can control feedforward amplifier parameters exactly and suppress non - linear products at last by detecting changes of signals and environments

    與傳統前饋法相比，本文加入了基於最小功率檢測演算法的自適應控制電路，對輸入功率變化、溫漂和器件老化等導致系統性能下降的擾動進行自適應調整，使功放的非線性失真在很大程度上得到改善。
  9. Then a dynamic compensating system is designed and added into the measuring system to accomplish the compensation. furthermore, a mcu system is designed to acquire, process and display the output of the transducer ' s serving circuit, and to feed back the workpiece ' s real time dimension to the nc grinding machine

    同時，設計了一個單片機系統來對氣隙式電感傳感器及其調理電路的輸出信號進行採集、處理、顯示，並反饋給磨床，實現對磨床磨削加工的閉環控制，並且使整個系統具有友好的人機交互界面。
  10. It can improve the utilize of power by fed back the power generated by motor machine to power - net, has the benefit of improving power factor, reducing the harmonious feeding back to the power - net and can enhance the performance of converters for the constant voltage of dc - link

    該裝置能夠提高電能的利用率，把由電動機產生的再生能源回饋到交流電網，並且能提高裝置的功率因數，減少對電網的諧波污染。由於pwm整流，變頻器中間直流環節的電壓能保持穩定，提高了逆變器的調速性能。
  11. For this reason, it ' s application will be restricted. this paper designs a circuit topology structure of multi - functional converter, which contains rectifier, chopper and inverter, it can function in soft - starting, chopping and doubly - fed adjusting speed for doubly - fed motor

    本文設計了一種適用於雙饋電機多種運行狀態的多功能變流器的拓撲結構，它將整流器、斬波器與逆變器結合在一起，能完成電機的軟啟動、斬波、雙饋調速。
分享友人
分享到 Line

分享到臉書