饋電條 的英文怎麼說
中文拼音 [kuìdiàntiáo]
饋電條
英文
power strip-
It is necessary to control the mechanical stimuli precisely in the studies of cardiac mechano - electrical feedback ( mef ). in the present study a ventricular pressure - clamping system has been developed, which can be applied to isolated - perfused rabbit hearts. controlled by a computer, this system not only can make the left ventricle follow a command defining the same pressure wave as that during a beating cycle under physiological condition, but also deliver mechanical stimuli with a proper waveform to the ventricle at a particular time phase. this system integrates multiple functions, including perfusing, pacing, recording of electrocardiogram and monophasic action potentials, and clamping and measuring of ventricular pressures in isolated - perfused hearts. thus, it is a distinct system for investigating the phenomena and mechanisms of cardiac mef at organ level
在心臟機械電反饋的研究中準確控制機械刺激是非常重要的.本研究室構建了一套適用於離體家兔心臟的心室壓力鉗系統.該系統通過計算機控制壓力鉗，不僅能模擬正常生理條件下左心室的壓力波形，還能在心室活動周期的特定時相、以適當波形對心室施加機械刺激.該系統集心臟灌流與起搏、表面心電圖記錄、單相動作電位記錄、心室壓力鉗制與測定等多種功能於一體，特別適用於器官水平上觀察機械電反饋現象並探討其機制Abstract : it is necessary to control the mechanical stimuli precisely in the studies of cardiac mechano - electrical feedback ( mef ). in the present study a ventricular pressure - clamping system has been developed, which can be applied to isolated - perfused rabbit hearts. controlled by a computer, this system not only can make the left ventricle follow a command defining the same pressure wave as that during a beating cycle under physiological condition, but also deliver mechanical stimuli with a proper waveform to the ventricle at a particular time phase. this system integrates multiple functions, including perfusing, pacing, recording of electrocardiogram and monophasic action potentials, and clamping and measuring of ventricular pressures in isolated - perfused hearts. thus, it is a distinct system for investigating the phenomena and mechanisms of cardiac mef at organ level
文摘:在心臟機械電反饋的研究中準確控制機械刺激是非常重要的.本研究室構建了一套適用於離體家兔心臟的心室壓力鉗系統.該系統通過計算機控制壓力鉗，不僅能模擬正常生理條件下左心室的壓力波形，還能在心室活動周期的特定時相、以適當波形對心室施加機械刺激.該系統集心臟灌流與起搏、表面心電圖記錄、單相動作電位記錄、心室壓力鉗制與測定等多種功能於一體，特別適用於器官水平上觀察機械電反饋現象並探討其機制A novel distribution network optimal control approach for load balancing is presented based on the simplified model of distribution system, in which tie switches are regarded as critical elements. the two feeder lines connected with a tie switch are regarded as a feeder couple. load balancing ratios of feeder couples and total distribution network are defined and be used as indice of network reconfiguration, respectively
提出一種以聯絡開關為核心的用於負荷均衡化的配電網路優化控制方法，將每個聯絡開關對應的兩條饋線看作饋線偶，定義了饋線偶和配電網的負荷均衡率，並以此作為網路優化的評價函數，這樣配電網路重構過程就由若干饋線偶內負荷均衡化過程組成，在此基礎上發展了以負荷均衡化和降低線損為目標的配電網優化方法。A niched - penalty approach is used to transform this optimal kinematical design problem to an unconstrained one. a kinematic accuracy comparison of the genetic designed fine - tuning stewart platform with the quasi - newtonian designed one is made. the comparison results have shown that the kinematic accuracy of the genetic designed fine - tuning stewart platform has a much higher accuracy and a compact structure than that of the quasi - newtonian designed one, which guarantees the accomplishment of high precision trajectory tracking and reduces the disturbance of wind to the feed - supporting system
以並聯機器人jacobian矩陣的條件數為優化設計的目標函數，提出了基於遺傳演算法的並聯機器人最優運動學性能結構參數優化設計方法，採用實值遺傳演算法，對精調stewart平臺進行了優化設計，得到了最優運動學的精調stewart平臺結構參數，為實現新一代大射電望遠鏡饋源指向跟蹤系統高精度軌跡跟蹤控制奠定了堅實的基礎。Type in a few instructions on the teletype machine and a few seconds later the dp would type back its response
在電傳打字機上鍵入幾條指令，幾秒鐘后程序數據處理機即會反饋回信息。Type in a few instructions on the teletype machine and a few seconds later the pdp would type back its response
在電傳打字機上鍵入幾條指令，幾秒鐘后程序數據處理機即會反饋回信息。Different power circuits and control strategy of the single phase inverter in parallel condition are first analyzed, and half - bridge inverter is selected as the power circuit and current hysteresis control is selected as the control strategy
本文首先對單相逆變器的主電路結構和控制電路的結構在並聯條件下進行了比較分析，最後選用了半橋結構的主電路和內環為滯環控制的瞬時電壓電流雙閉環反饋控制方式。The impedance matching criterion that the sum of all the radiating slot normalized conductances is equal to 2 for the inner feed, and also the sum of all the coupling slot normalized impedances for the series - shunt inner feeder is equal to 2 are verified by using microwave network theory
採用微波網路理論，在內部饋電情況下，分別對一條輻射波導上輻射裂縫的歸一化導納和為2的匹配設計準則，以及對串並形式饋電裝置，對耦合裂縫的歸一化阻抗和為2的匹配設計準則進行了證明。By constructing the necessary condition and sufficient condition for feedback to exist in a circuit, can derive the methods of short circuit or open circuit for the load or the signal source resistance respectively of the feedback network, to analyze the configurations of the negative feedback circuits
通過構建電路存在反饋的必要條件和充要條件，可引出令反饋電路的負載和信號源內阻分別短路或開路的方法，用於分析負反饋電路的組態。The innovative ideas in this paper are that robust h control theory based on conventional ip controller is applied to the high - precision feed of a single axis, and the controlled plant is composed of ip velocity loop and two - order model of linear motor. a constraint condition on y in the problem of h2 / h is deduced from the frequency criterion of riccati equation, which makes the repeated computation on r simple. considering the two - loops control problem, the h state feedback controller based on ip controller as the inner controller is applied to satisfy the velocity performance of the system, and a pi controller, the external controller, is used to satisfy the position performance
本文的創新之處在於將傳統的ip速度控制器和直線電動機的二階模型作為一個廣義的被控對象，利用魯棒h _控制理論設計了一個h _狀態反饋控制器，以此解決高精度進給的控制問題，並在此基礎上研究了h _ 2 h _混合控制問題，結合h _代數riccati方程正定鎮定解存在的頻率判據，推出了一個控制器存在的約束條件，使以往須反復試探的，有了更進一步的約束范圍，簡化了計算。After the whole army is equipped with the generator set cabin, the feedback information of user indicates that the generator set ca n ' t work in gear because of excessive high temperature in some bad conditions
在通信車載電源機組艙裝備全軍以後，使用人員的反饋信息表明，在某些惡劣條件下，發電機組會因為溫度過高而不能正常工作。因此，解決機組艙的通風散熱是當前急需解決的一個主要問題。After analyzing compensation conditions for 3 - axis stabilization to overcome disturbance from ship surge, sway and yaw, two control strategies - feed - forward compensation and closed - loop feedback compensation - are given. these two strategies are applied to antenna stabilized tracking system with good performance. intelligent pid is used in closed - loop feedback compensation to get high tracking precision and rapid response
重點分析了天線穩定控制系統的三軸補償條件，提出了穩定系統抑止載體擾動的控制策略：對于橫滾和俯仰系統採用前饋補償的控制策略；對于方位系統，在以步進電機為驅動元件的特定條件下，研究了變控制周期的閉環反饋策略，同時成功將智能pid演算法應用於實際系統，提高了系統的跟蹤精度和響應快速性。A novel resonant pole zvt three - phase pwm inverter circuit for three - phase ac motor driving is presented. the proposed circuit has the feature of being more flexible with three inverter arms in zvt process. using only one resonant inductance, the inverter can not only reduce the power loss of inductance but also avoid possibility of unbalance in motor ' s three stator windings
提出了一種針對三相交流電機驅動的新型諧振極零電壓過渡三相pwm逆變器電路，該電路中三個逆變橋臂的零電壓過渡更具有靈活性，僅使用一個諧振電感，既減少了電感損耗又防止了電機三相定子繞組可能存在的不平衡問題，並且諧振電感中殘余能量能夠回饋給電源；新型逆變器的輔助開關均工作在零電流開關條件下，並且控制邏輯簡單。The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load
本文在場效應管fet柵極上加上諧振網路（諧振網路是通過cst模擬得到的，它是串聯反饋迴路，介質工作在te01模，對于其後的fet ，它又相當於一個帶阻濾波器） ，然後設計輸入輸出匹配電路，使電路結構滿足起振條件，之後繼續用諧波平衡法模擬和優化，使振蕩器輸出功率合適，相位噪聲很低。Considering practical application, some control methods brought forward by predecessors have been improved in order to realize them more easily. because it is difficult to control chaos and hyperchaos to high - period by simple linear feedback in experiments, the ordinary linear feedback method is modified to local control, further more, we prove its feasibility and find out the controllable parameter range theoretically. the improved linear feedback method is applied to circuit experiments, and the results of numerical simulation and circuit experiment are all in accordance with theory, which validate this method effective
概括起來有兩個層面的內容：針對前人已經提出的一些控制方法，結合實際應用的需要提出改進的方案，使之更易於實際應用中的實現，這部分包括：基於簡單的線性反饋控制低維混沌和超混沌系統的高周期態難以在實驗中實現而提出的局部控制的改進方案；結合具體實例，從理論上分析了改進控制方案的有效性及系統可控制的參數條件；並且用電路實驗實現了改進的控制方案，實驗結果也驗證了理論的正確性和可行性；在應用非線性反饋方法控制混沌系統的研究中，我們也得到了前人沒有討論過的高周期結果。In this paper, the development of vibration - resistant interferometry and several adaptive vibration - resistant methods be introduced. by considering the practical condition and the influence of vibration in interferometer, the mechanical & electric feedback vibration - resistant method be designed. the paper ' s content including two parts
本文介紹了抗振干涉技術的發展情況，比較了幾種自適應抗振方法，結合實驗室條件及振動對干涉條紋的影響，確定了機電反饋式自適應抗振方案。Compared with mechanics - electricity feedback control method, laser diode feedback control method and optical bistable equipment control method, the circuit is relatively simple, furthermore, simply adjust the optical system to increase the number of pixel corresponding to the interference pattern width, which will promote the control precision of the system
和已有的機電反饋控制方法、半導體激光器反饋控制方法、光學雙穩裝置控制方法相比，電路較為簡單，而且，簡單地調節光學系統使干涉條紋寬度對應的象素數增大，即可提高系統的控制精度。The sequence to solve a overcurrent line of a feeder is : load transference to another feeder, reduction the reactive power and finally increase the section of the cable
規劃一個饋線線路（設備）的一條過流主幹路的順序是：了解負荷轉移至另一個饋線線路（設備）過程中，將無功功率降低最終就要增加電纜。分享友人