驗軸 的英文怎麼說

中文拼音 [yànzhóu]
驗軸 英文
axis oculi
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  1. Testbed of pressure distribution of aerostatic thrust bearing

    空氣靜壓推力承壓力分佈實臺研製
  2. Design and analysis on high speed static air bearing test - bed

    高速徑向氣體靜態承試臺的設計與分析
  3. The test must work in a specify rotation spectrum, temperature spectrum and load spectrum to analogize the reality condition

    器要在一定的載荷譜、溫度譜、轉速譜條件下工作,模擬承的實際工況。
  4. 2 transmission of longitudinal stress wave in non - defect pipeline excited by axial symmetry impact has been studied by the numbers

    2 、對無缺陷管道中受對稱沖擊載荷下激勵出的應力波進行了較為系統的實研究。
  5. The velocity field has been designed in this article on defect of rolling workpiece surface about cross wedge rolling technique in the process of forming axial symmetry spare parts by result of simulated experiment of consult document [ 4 ]

    摘要依據文獻[ 4 ]的模擬實結果,擬定了楔橫軋工藝成形階梯類件時軋件表面出現表面缺陷(蛇皮狀或魚鱗狀缺陷)時的金屬流動速度場。
  6. Testing and cortrolling methods of grinding badness layer of bearings working surface

    承工作表面的磨削變質層的檢及控制方法。
  7. In view of bearing capacity of the elastoplastic theory analysis, the author made a comparison between the achieved bearing capacity limit load pi / 4 of round base ( space problem ) and the limit load pi / 4 of bar groundwork foundation design ( plane problem ) from soil mechanics at home and abroad as well as foundation criterion, and explained why the value of formula in present design criterion from soil mechanics is inclined to be conservative. in the light of the author ' s many years experience of vibration test on the spot and the research work of relevant projects, the author worked over the dynamic pile testing of the bearing capacity of foundation and batholith, and gathered the parameter of dynamic analysis and testing. the author also talked over the difficult point of pile foundation design criteria in present batholith engineering world, i. e. the confirmation of batholith bearing capacity of pile end, from the following aspects : a ) confirmation of single axis counter - pressure strength of rock in house ; b ) f. e. m calculation of elastoplastic model ; c ) calculation of soil mechanics ; d ) deep well load test

    然後,對巖土工程領域至今尚未解決,甚至不為人注意的考慮地基變形的地基承載力問題進行了實用化的探討,提出了考慮地基變形的地基承載力上程計算方法;對基於彈塑性理論分析的地基承載力國內尚未見報道的空間問題得到了圓形基礎(空間問題)的承載力界限荷載p _ ( 1 / 4 ) ,並與國內外土力學專著及地基基礎設計規范中的條形基礎(平面問題)的界限荷載p _ ( 1 / 4 ) ,進行了對比,從而定量上解釋了目前設計規范引用土力學承載力公式值偏於保守的這一情況;根據本文作者多年從事現場地基工程振動試及相關課題的研究工作,本文以截頭錐模型模擬地基,對地基(巖基)承載力的動測法進行了研究,為各類地基(包括巖基) ,匯總了動力分析和檢測川的參數:針對日前巖土工程界應用樁基設計規范中的難點? ?樁端巖基承載力的確定問題,從巖石室內單抗壓強度確定、基於彈塑性模型的有限單元法計算、土力學計算及深斤載荷試四方面進行了深入討論;本文作者根據多年現場載荷試的工程實踐,對深井荷試裝置的核心部分? ?反力裝置,設計了側壁支撐反力加載系統,該加載系統具有實用、簡便、穩定及安個等優點。
  8. And rock triaxial serve testing system is used, through model test involving bedded planes and a set of joint normal to the bedded planes in rock mass, multiple sliding failure affected by properties of joints and confining pressure is analysed, the condition triggering multiple sliding failure and characteristics of failure plane are given, under the co - action of inclination of connective joints ( bedded planes ), interlocking conditions of critical joints and confining pressure

    並在室內利用巖石三剛性伺服機,通過模型試對巖體的層面和一組與層面正交的節理的情況進行模擬研究,分析了結構面性狀和圍壓對復合式滑移破壞的影響,給出了在貫通性結構面(層面)傾角、非貫通性結構面以及圍壓等因素共同作用下,節理化巖體發生復合式滑移破壞的條件以及破壞面特徵。
  9. Couplings. industrial cardan shaft. acceptance

    節.工業用萬向.
  10. Test method for coaxial cable structural return loss

    電纜結構回波損耗試方法
  11. Consolidated undrained triaxial compression test

    壓密不排水三壓縮試
  12. Test and analysis of cutting quality of cornstalk macerator of dual vertical - axle

    雙立式玉米秸稈還田裝置切碎效果的試分析
  13. The cyclo - hoop effect which steel tubular has exert to the concrete shows the character of heterogeneous in the arch rib section, the same to the axial direction. the paper verifies the change of the material poisson ration and the concrete grade will make the cyclo - hoop effect obvious alteration, the change of the cyclo - hoop effect and the stress redistribution of the section produced by the shrinking and creeping of the concrete and the expensive concrete on the section

    在鋼管混凝土拱肋斷面上,鋼管對內填混凝土的環箍效應具有非均勻性,在拱方向上環箍效應也呈現非均勻性。證了材料的橫向變形系數、混凝土標號等參數的變化將引起環箍效應的明顯改變;混凝土的收縮、徐變和膨脹混凝土的應用導致鋼管混凝土的環箍效應發生變化並使截面的應力發生重分佈;並總結了其變化的基本規律。
  14. This dissertation presents a hypoelastic constitutive model with four material constants in describing the mechanical behavior of granular materials under loading. analysis results of the model have good coincidence with those of triaxial experiment of the standard sand under different relative density. the model can describe the contractant and dilatant phenomena of granular materials

    提出了一種含4個材料常數的亞彈性本構模型,來描述散粒體在加載時的力學行為,本模型的分析結果與不同相對密度下標準砂的三可較好地吻合,能反映散粒體的剪縮、剪脹現象,還對如何用三數據來確定這4個材料常數,給出了適宜的計算方法。
  15. Meanwhile, mabs - 3000 not only is the combination of the three different systems : roller braking test, vehicle axle weight and speed meter test, but also has more functions, less pollution, lower cost and a more efficient composite system

    該多功能abs檢臺在檢測汽車防抱死制動系統( abs )性能的同時還把汽車的速度表校重檢測、制動性能檢測三個分離的試臺的功能合為一體,是一種集成度高、多功能的復合試臺。
  16. Plain bearings - testing of tribological behaviour of bearing materials - testing of bearing metals

    滑動承.承材料摩擦特性試.承金屬試
  17. Rotary shaft lip type seals for automobils ; test ; carrying out axle - sections

    汽車用唇型旋轉密封件.第8部分:試.截面設計
  18. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - axial compression

    光纖互聯裝置和無源部件.基本試和測量程序.試.向壓縮
  19. Fibre optic interconnecting devices and passive components. basic test and measurement procedures. part 2 - 11 : tests. axial compression

    光纖互連裝置和無源元件.基本試和測量程序.第2 - 11部分:試.向壓力
  20. Basic environmental testing procedures ; part 2 : tests ; test ee and guidance : bounce iec 68 - 2 - 55 : 1987

    纖維光學互連器件和無源器件基本試和測量程序第2 - 11部分:試驗軸向擠壓
分享友人