高低偏置檢測 的英文怎麼說

中文拼音 [gāodīpiānzhìjiǎncè]
高低偏置檢測 英文
high-low-bias test
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 高低 : 1 （高低的程度） height 2 （高下） relative superiority or inferiority; difference in degree 3 （...
  • 檢測 : check; detection; test; gauging; detecting; sensing; [工業] checkout; measuring
  1. In addition to the conventional techniques such as low sidelobe antennas and displaced phased center antenna ( dpca ), there has been great interest in space - time adaptive processing ( stap ) because it can suppress clutter effectively and improve the detection performance of airborne phased array radar evidently

    除了採用低副瓣天線、偏置天線相位中心（ dpca ）等傳統雜波抑制技術，能夠有效提高機載相控陣雷達地雜波抑制能力和動目標檢測性能的空時二維自適應處理（ stap ）受到了廣泛關注。
  2. In this dissertation, we studied the tcra1101plus total station position system, which introduced the principle and characters of the instrument ' s closed loop tracking system. also we explained the cause of prism ' s position error and brought forward mathematic model to correct, moreover, the good results has been drawn form the expenriments. the kinetic survey system have been realized, which the sampling rate attain more than 5hz and the position precision can be less than 2mm on condition that targeted - point moving slowly at the velocity below 2cm / s. having finished the survey system to examine whether the fine - tuning stewart platform in good status, we have finished mensurating the position reference of the fine - tuning stewart platform and the offset of the prism

    在此基礎上研製了多臺儀器在線控制高頻采樣動態跟蹤測量系統，采樣率大於5hz ，在跟蹤小於2cm / s低速運動目標時，測量精度好於2mm ；完成對饋源二次精調系統的檢測，包括對二次精調平臺位置基準的標定和觀測棱鏡偏心差的測定；設計不同動態測量實驗，對全站儀動態跟蹤的誤差來源和特點進行了分析；從實驗角度，對全站儀的測量時滯及其穩定性進行了測試分析，給出了定量的結果；比較了全站儀和計算機的內部時間系統，發現兩者存在較大差異。
分享友人
分享到 Line

分享到臉書