高功率激光器 的英文怎麼說

中文拼音 [gāogōngguāng]
高功率激光器 英文
high-poer laser
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 名詞1 (功勞) exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • : 率名詞(比值) rate; ratio; proportion
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 高功率 : high power高功率電子管 high-power tube; 高功率發射機 high-power transmitter; 高功率放大器 high-power amplifier
  • 激光器 : [光學] (光激射器) laser (縮自 light amplification by stimulated emission of radiation); optic...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. Under the incentive of the civil - market demanding such as laser material processing and the military - market demanding such as a new generation of laser weapon candidate and icf, diode - pumped solid laser ( dpsl ) develops rapidly worldwide. as an important application, diode - pumped intracavity - frequency - doubled laser is attached much importance in recent years, but there still remain many problems unresolved completely. in this paper, i have given some abecedarian study results on some of these problems theoretically and experimentally

    因工業材料加工等民用市場的需求以及慣性約束聚變和作為新一代候選件等軍方需求的推動,國際上二極體泵浦固體( dpsl )的研究進展迅速,作為dpsl的一個重要應用,內腔倍頻一直得到大家的重視,但仍有許多未徹底解決的問題和理論上的不完備之處,本論文擬對其中的一些問題作一初步的理論和實驗研究。
  2. Along with developing of the commercial availability of high - power ingaas laser diode in the 1990s, the advantage of yb : yag suitable for the ld pumped high power solid - state lasers was realized

    對ld泵浦的yb : yag固體的研究已成為當前熱點,並將其視為發展效、固體的一個主要方向。
  3. Therefore, it is of great significance to research the simulation technology of the high power crosscurrent co2 laser

    因此,橫流co _ 2模擬系統技術的研究具有重要的理論意義和實用價值。
  4. In recent years, the longitudinal pulsed - discharge gas lasers with diffusive cooling have received renewed interests. a compact low power pulsed laser with high repetition rate has potential importance in laser exploration, fine mechanical processing, photochemistry and so on

    近年來,縱向放電的脈沖氣體重新受到了人們的重視,一種小型的低重復頻脈沖探測、精細加工和化學等許多應用領域,有重要的應用前景。
  5. The high - power semiconductor quantum well ( qw ) laser is a kind of luminescence device with superior performance, it has longe - lived, low threshold current density, high efficiency, high luminosity and excellent monochromatic, coherence, directionality, etc. the high - power semiconductor laser is widely applied to the fields, such as military, industrial machining, communication, information processing, medical treatment, etc. the material ' s epitaxy is the foundation of the whole laser ' s fabricating, and it has important influence on the optics and electricity performance about the laser

    半導體量子阱是一種性能優越的發件,具有壽命長、閾值電流密度低、效、亮度以及良好的單色性、相干性、方向性等特點,廣泛應用於軍事、工業加工、通信及信息處理、醫療保健等領域。材料的外延生長是整個件製作的基礎,對件的學和電學性能有著重要的影響,生長不出優質的材料體系,獲得性能的件就無從談起,因此,材料的外延生長便成為了整個半導體製作過程之中的重中之重。
  6. On the radiation range of l - 4gw / cm2, the effects of the modulation in intensity, beam aperture, pulse width and intensity of 3 w on tsrs in frequency convector crystals have been analyzed in detail. the interrelated thresholds have been gained by calculating and theoretical evidences have been offered to prevent tsrs from damaging frequency conversion crystals, which will be applied to the engineering design of the laser drivers on high - fluence

    的強度調制、束口徑、脈寬和強度等因素對諧波轉換晶體中tsrs的影響,並計算得出了一些相關闡值,得到了驅動工作的臨界狀態,為防止出現tsrs的損傷提供了理論依據,對驅動的工程設計具有實用價值。
  7. Moreover, we give a further discussion on the numerical value calculation of temperature distribution. the main problem when we design the high duty - cycle high power laser diode array we face is the large amount of heat during its operation. so we change the proportion of some ingredients and the concentration of the dopage to gain high quality iii - v material

    陣列的設計過程中,針對大嚴重的產熱問題,尤其是占空比工作時,會有更多的轉化為熱的現象,我們改進晶元材料的配比、摻雜,提出適應占空比工作的件版圖結構。
  8. Laser diode modules fod 3201, 3202, 3206

    Boston纖故障查找
  9. Polarization characteristics of laser beam, which is one of the important characteristics of high power laser, have a direct effect on output power, damage threshold of optical elements and beam quality etc. the polarization characteristics in the high power coil resonator is analyzed by jones calculus, and draw a conclusion that, in general the eigen - polarization state is elliptical polarization

    束的偏振特性是高功率激光器的一個重要特性之一,直接影響著高功率激光器的輸出、腔內學元件的損傷以及束質量等。本文首先利用瓊斯矩陣演算法對氧碘腔內的偏振特性進行了分析,並得出結論,諧振腔內的本徵振蕩一般為橢圓偏振。
  10. Based on a 3 - d transient thermal model with inhomogeneous heat generation, the temperature and thermal stress distribution in the disk of heat capacity laser pumped by high power laser diode array ( lda ) are simulated and analyzed by means of finite element methods

    摘要為了研究介質熱畸變對固體熱容的影響,數值計算了二極體陣列抽運片狀介質的瞬態溫度場和熱應力分佈。
  11. High power laser diode module means that output power is more than 40mw

    亮度是指出口大於40mw的紅
  12. Laser - induced deformations of unstable resonator mirrors of high power laser result in some aberrations of resonator parameter, which distort laser modes and degrade beam quality

    高功率激光器中,非穩腔鏡受直接輻照,鏡面發生變形,使諧振腔參數偏離設計值,模式發生畸變,束質量變壞。
  13. And the length of the laser is well shortened with the fold structure

    U型腔較之直線型長度尺寸比得到提,取得縮小體積的預期效果。
  14. Methods of edge figuring in digital controlled fabrication of optical surface

    高功率激光器學元件冷卻技術的研究
  15. With the development of infrared tunable opo, its application is more and more wide. lt is possible for us to estimate the quality of resonant mirrors in laser with high energy and to improve the output energy of laser, by measuring the reflectivity of resonant mirrors of coil and df laser by cavity - ring - down which use output wave of opo as the laser source, instead of coil and df laser with high price and huge space

    用opo紅外輸出作為腔衰蕩的源代替價格昂貴、體積龐大的氧碘和氟化氖,對其諧振腔鏡的反射進行測量,以達到對高功率激光器腔鏡反膜質量的評價,為改進膜系設計、鍍膜工藝優化和提的輸出能量提供理論依據。
  16. In former stl instruments, a laser beam with a gaussian distributed intensity was commonly used as the excitation source. nevertheless, the output of a high power laser is usually a superposition of multi - modes rather than a gaussian distribution ( tem00 ). therefore, it is very convenient to add an aperture to get a top - hat beam

    以前的表面熱透鏡裝置中,多使用束作為,但由於高功率激光器一般為多模輸出,要獲得嚴格的基模束比較困難,而平頂束可以通過在前加一定大小的闌實現,降低了對束質量的要求,更有利於實際的測量。
  17. Abstract : group technology is introduced in the developing proc ess of high - power laser system for the first time. as an example, on the basis of the spatial filter, it is demonstrated the needs and feasibility of group design in the developing process of high - power laser system, and the composing of comp uter aided group design ( gt - cad ) system is discussed and how to put it into pra ctice in the high - power laser system

    文摘:在裝置研製中首次引入成組技術概念,並以空間濾波為例論證了在裝置的件研製過程中實施成組設計的必要性和可行性.最後討論了計算機輔助成組設計系統( gt - cad )的組成和在裝置中具體實施過程
  18. There is the need for high duty - cycle laser diode array to satisfy the demand the dpssl ( diode pumping solid state laser ) technology

    要滿足當前的泵浦要求,占空比大陣列是必需的泵浦源。
  19. Model of small - scale self - focusing and noise in high power laser driver

    驅動中小尺度自聚焦和噪聲模型
  20. This has important significance on further developing compact, high power, high repetition rate pulsed co2 laser

    這對進一步發展緊湊的重復頻有重要意義。
分享友人