高壓型儲層 的英文怎麼說

中文拼音 [gāoyāxíngchǔcéng]
高壓型儲層 英文
geopressured reservoir
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 壓 : 壓構詞成分。
  • 儲 : Ⅰ動詞（儲藏; 存放） store up; save; keep [have] in reserve Ⅱ名詞1. （繼承人） heir 2. （姓氏） a surname
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 高壓 : 1 （殘酷迫害; 極度壓制） high handed 2 [氣象學] （高氣壓） high pressure3 （高電壓） high tension...
  1. Through studying it is shown that in chagan sag, the geothermal gradients in the center are higher than those around the sag margin and major factors influencing the characteristics of temperature field distribution are the property of geotectogenesis and the differences in tectonic portion, lithology and underground water behaviour ; there are three types of mudstone compaction, i. e. normal compaction, undercompacition and overcomepaction ; there are two pressure systems in sandstone reservoirs, i. e. normal pressure and negative pressure systems and the strata ' s being uplifted and denuded is the key factor leading to the formation of the negative pressure system in reservoir ; and the distinctive temperature - pressure field characteristics in the sag are possessed of important petroleum geological significance in hydrocarbon source maturity, hydrocarbon generation, widening on oil and gas exploration domain and selecting exploration targets, etc

    研究表明，查干凹陷中心的地溫梯度高於凹陷邊緣，大地構造性質及所處構造部位、巖性與地下水活動的差異是影響凹陷地溫場分佈特徵的主要因素；泥巖壓實存在正常壓實、欠壓實和過壓實三種類型，砂巖儲層段壓力類型可分為正常和負壓兩個系統，地層抬升剝蝕是導致儲層負壓系統形成的主導因素；凹陷獨特的溫壓場特徵對烴源巖成熟、油氣生成、油氣勘探領域的擴大及勘探方向的選擇等具有重要的油氣地質意義。
  2. The variations in trace element contents and ratios may hold up a mirror to the lake - level fluctuations and climatic changes, which, in turn, have exerted a direct and important effect on the sequence stratigraphic development. collectively, the reservoir rocks from the yanchang formation consist dominantly of the delta front subfacies subaqueous distributary channel and channel - mouth bar microfacies and delta plain subfacies subaerial distributary channel microfacies fine - grained feldspar sandstones and siltstones. the reservoir rocks have been subjected to three stages of diagenetic and porosity evolution : ( 1 ) the porosity reduction by the mechanical compaction and chemical pressure solution during the early diagenetic stage ; ( 2 ) the porosity increase by the dissolution during the a substage of the late diagenetic stage, and ( 3 ) the porosity reduction by the cementation and filling during the b substage of the late diagenetic stage

    系統的儲層特徵研究表明，該區延長組儲層成因類型主要為三角洲前緣水下分流河道、河口砂壩及三角洲平原水上分流河道微相細粒長石砂巖、粉砂巖；儲層巖石經歷了壓實，膠結，溶蝕等成巖作用，歷經早成巖機械壓實和化學壓溶孔隙縮小期、晚成巖a亞期溶蝕作用孔隙擴大期及晚成巖a亞期（ b亞期）膠結充填孔隙縮小期三個成巖-孔隙演化階段；儲層物性總體上具有較低孔滲、低孔滲的特點，孔隙類型主要為粒間溶孔、殘余粒間孔隙、粒內溶孔、晶間孔及晶間溶孔，裂縫不發育，儲集巖排驅壓力和中值壓力較高，孔隙結構類型以細小孔-微孔隙，微細喉-微喉型為主。
  3. Finally, this paper analyzed reservoir characteristic of turbidite lithologic reservoir and the control iactors of oil and gas enrichment and high production and figure out that the major factors of influence and control reservoir are pressure, temperature, microfacies types, sand thickness, the action of fault, and the non - uniform feature of reserve by anatomizing typical reservoir

    最後，對濁積巖的儲層敏感性反應和濁積巖巖性油藏的成藏特點及其富集高產的控制因素進行了討論，認為砂體所處的壓力和溫度條件、沉積微相類型、砂層厚度、斷層的活動及儲層的非均質性等是其主要影響和控制因素。
  4. In this article, the following technology of the carbon fiber composite flywheel in the integrated energy - storage / attitude - control system are analyzed and the valuable achievements are achieved above the foundation of consulting a large quantity of literatures and investigation : 1. different technology method for carbon fiber composite flywheel are designed, aimed at the character of carbon fiber composite material and manufacture 2analyzes the stress of carbon fiber composite flywheels made by different technology method, hoop - winding method, symmetric ortho layers pressing method, multi - layer winding method and interference joining method, under high rotate speed, builds their static model ; and simulates their technology and shape parameter ' s affecting their stress level with i - deas f. e. m

    本文在查閱了大量國內外相關文獻及調研的基礎上，針對集成化儲能/姿態控制飛輪系統中的碳纖維復合飛輪的以下相關技術進行了研究，並取得了有價值的成果： 1針對碳纖維復合材料的特點及加工方式，設計了周向纏繞成型法、對稱正交鋪層層壓法、多層結構纏繞及過盈連接法等不同工藝方式的碳纖維復合飛輪轉子； 2針對不同工藝方式的碳纖維復合飛輪轉子，進行了高速旋轉狀態下的應力分析，建立了靜力學解析模型，並結合i - deas有限元分析軟體模擬模擬了不同工藝方式的碳纖維復合飛輪轉子的相關幾何參數及工藝參數對其應力水平的影響； 3
分享友人
分享到 Line

分享到臉書