高比值片段對 的英文怎麼說

中文拼音 [gāozhípiānduànduì]
高比值片段對 英文
hsp
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : Ⅰ動詞1 (比較; 較量高下、 長短、距離、好壞等) compare; compete; contrast; match; emulate 2 (比...
  • : 片構詞成分。
  • : Ⅰ量詞(部分) section; segment; part; paragraph; passage Ⅱ名詞(姓氏) a surname
  • : Ⅰ動詞1 (回答) answer; reply 2 (對待; 對付) treat; cope with; counter 3 (朝; 向; 面對) be tr...
  • 比值 : specific value; ratio比值法 ratio method; 比值計 ratio meter; 比值檢波器 ratio detector; 比值控制...
  • 片段 : part; passage; fragment; extract; segment; bit; episode; snatch; section
  1. The welding technology of francis turbine runners is optimized from the view of subsection welding and local heating by numerical simulation. the result shows that welding residual tensile stress appears in the weld and its area nearby, and peak stress appears in the dangerous area of blades after practising quondam welding technology ; welding residual tensile peak stress in the dangerous area of blades can be decreased by welding both ends earlier and then welding middle section later during subsection welding, and decreasing effect on welding residual stress of the subsection welding is related to the weld length of blade outlets and welding direction of each subsection ; decreasing effect on residual stress of the local heating is direct proportional to heating time, heating temperature, heating area, and inversely proportional to cooling area, and welding residual tensile peak stress in the dangerous area is decreasing trend earlier, and then increasing trend later with heated location increased

    本文利用數模擬手轉輪的焊接工藝從分焊和局部加熱兩個方面進行了優化,結果表明:採用普通工藝焊接時,葉焊后殘余拉應力出現在焊縫及其附近區域,並且在葉出水邊的熔合線附近(危險區域)出現了峰;在採用優化的分焊時,先焊兩端后焊中間的方法可以降低葉危險區域的焊接殘余拉應力峰,降低效果與葉出水邊焊長度、焊縫各的焊接方向有關;局部加熱法降低轉輪危險區域殘余應力的效果主要與加熱時間、加熱溫度以及加熱面積成正,與冷卻面積成反,並且危險區域的殘余應力隨加熱區域的增大呈先降低后升的趨勢。
  2. At the surface of the pollen grains there are three types of aperturates, including three porates type, three colpates type and three porate - colpates type ; and four types of sculpture, namely, reticulate, striate, striate - reticulate and verrucate. the upper epidermal cells of the leaves of 12 species plants are detected with hpias - 1000 image analytic system through the treatment of binarization, and the experimental methods are proved stable. the results indicated that the waviness of the anticlinal walls ( sfc ) and the ratio of the feret ' s diameter ( slf ) of the epidermal cells of the middle lamina in the third node of leaves starting from the lowerest part of the stem have a relative constant range and could distinguish from each other. oieanolic acid, l, 5, 8 - trihydroxy - 3 - methoxyxanthone and swertiamarin are separately detected on the tlc, and the different chromatogram of various plants can be considered as characters of identification. the contents of oleanolic acid in 12 species of plants are determinated by hplc, but among the different plants and botanical organs their contents are different, and the highest content in flowers

    本文川鄂產獐牙菜屬藥用植物資源進行了野外調查、標本採集和鑒定,12種乾燥藥材的性狀進行了描述,提供了可以鑒別的特徵。通過掃描電子顯微鏡觀察的12種本屬藥用植物的花粉粒均為單粒花粉,萌發孔有3孔型, 3溝型和3孔溝型三種類型;表面紋飾包括網狀紋,條狀?網狀紋,條狀紋和瘤狀紋四種類型。用hpias ? 1000清晰度彩色病理圖文分析系統上表皮細胞作圖像分析,並進行方法學研究,結果表明,同種植物莖上第3節葉主脈和第1側脈之間葉上表皮細胞垂周壁彎曲程度sfc和細胞縱、橫向直徑的slf,種間有顯著差異,每種都有相恆定范圍
  3. By means of the afm made in shanghai aijian co., ltd. and digital instruments co., ltd ( u. s. ), the dna strand and their fragments were observed successfully. 2. by comparison with afm experiments of three categories of ion beams, the result has been observed in qualitatively : in the uniform dose, the higher let heavy ions have caused more double strand breaks than the lower let radiation

    通過afm實驗結果的觀測,可以定性地得知:在同等劑量條件下,let的重粒子與低let的射線相, dna雙鏈斷裂的數目要多一些;在相同let條件下,隨劑量增加dsb的變短、數量增加。
  4. After the rationality of theoretical model has been testified, going along a series of numerical simulation and find the best ratio of evaporation segment and condensation segment by means of analyse the temperature variety of the electronic element surface on the effect of the radiator structure change. a series of strenthen step about heat transfer put forward theoretically by means of numerical analysis focuse on the thermal resistant of each tache of the heat transfer

    在證實了本理論模型是合理的基礎上,本文根據所建立的模型進行了一系列的數模擬計算,分析了熱管型電子器件散熱器的結構尺寸(蒸發和冷凝的長度、肋度等)變化發熱器件表面溫度的影響,得到了蒸發和冷凝的最佳長度
分享友人