高溫煙囪 的英文怎麼說

中文拼音 [gāowēnyāncōng]
高溫煙囪 英文
high-temperature chimney
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 煙 : Ⅰ名詞1 （物質燃燒時產生的氣體） smoke 2 （像煙的東西） mist; vapour 3 （煙草） tobacco 4 （紙煙、...
  • 囪 : Ⅰ名詞（煙囪; 爐灶出煙的通道） chimney; funnel; stovepipeⅡ構詞成分。
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  • 煙囪 : chimney; funnel; tun; stovepipe; tewel; smoke stack [funnel]
  1. Air temperature inside solar chimney increases with the increase of solar radiation and solar chimney height

    氣流的溫度隨著太陽能煙囪高度的增加和太陽能輻射強度的增大而升高。
  2. For long - term protection of heated pipelines, exhaust pipes, smoke stacks and other heated surfaces up to 550 - 600

    長期保護加熱管道、排氣管道、煙囪及其它溫度可高達550 - 600的受熱面。
  3. Moreover, the theoretical formula were applied in combination of practical example, with the temperature distribution along the radial direction in a transient state proposed

    並結合算例給出了在短時超高溫條件下煙囪筒身沿徑向的瞬態溫度分佈。
  4. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  5. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  6. Fire ) for reinforcing building, moreover, what will happen about the bond behavior of the cohering face for the building under high temperature frequently such as metallurgy and chemical shop which are radiated under high temperature ( 200 - 300 ), chimney wall ( 100 - 150 ) ? these are not clear and definite. so it is necessary to study this question through experiments

    另外，對于經常處于高溫狀態下的建築，如冶金和化工車間受高溫輻射的結構（溫度在200 300 ） ，煙囪筒壁（溫度在100 150 ）等結構，經過高溫作用后，其粘結面的粘結性能會發生什麼變化，這些目前都不明確，因此很有必要對這一基本問題進行試驗研究。
分享友人
分享到 Line

分享到臉書