高溫覆層 的英文怎麼說

中文拼音 [gāowēnfùcéng]
高溫覆層 英文
high temperature coating
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 覆 : 動詞1. [書面語] （蓋住） cover 2. [書面語] （底朝上翻過來; 歪倒） overturn; upset 3. 同 「復」 （Ⅱ1. 2. ）
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  1. Our company adopts the metal honeycomb or the metal network board carrier, with special coating coating technology and processing technology, prepare different forms, the all kinds of catalysiseses of specification, used in petrol exhaust. with the characteristic of light in low temp, purification efficiency high and long life etc. main technological schemes as below

    通用汽油機凈化器我公司採用金屬蜂窩或金屬網板載體，通過特殊的塗層塗覆技術及加工工藝，可制備不同形狀規格的各類催化凈化器，用於汽油機的排氣凈化，具有起燃溫度低凈化效率高使用壽命長等特點。
  2. The results are as follows : ( 1 ) based on soil temperature data measured at different time in the field, soil temperature characteristics under plastic mulch were analyzed at four locations : the middle, the edge, in - between the plastic film and uncovered spot ; the characteristics of soil temperature profile from 0 to 25cm depth and the correlation of soil temperatures in different soil layers were studied at different time with and without plastic mulch ; on the basis of analyzing temporal and spatial variations of soil temperature in a corn field, the relations between soil temperature and air temperature were established, and a new method that only uses air temperature to predict soil temperature profile at different time is proposed. the predicted results showed good accuracy

    成果如下： （ 1 ）根據大田實測地溫資料，分析了覆膜條件下膜中、膜邊、膜間和揭膜四種處理在早、中、晚三個不同時刻的地溫特徵；分析研究了各觀測時刻覆膜與不覆膜條件下0 25cm剖面地溫的特點及各層地溫間的相關關系；在重點對玉米田地溫時空變化特徵分析的基礎上，首次將覆膜與不覆膜不同時刻觀測的剖面地溫與氣溫建立了聯系，提出了僅根據氣溫資料來預測一日內不同時刻剖面地溫的新方法，預測結果表明其精度較高。
  3. ( y, gd ) bo3 : eu3 + was the red phosphors for pdp, which had poor color purity. in this dissertation, solid state reaction method at room temperature was firstly used for coating the ( y, gd ) bo3 : eu3 + particles with hematite. the thickness of uniform hematite coating is about 10nm

    （ y ， gd ） bo3 : eu3 +作為pdp用熒光粉的紅粉材料存在色純度差的弱點，為了提高其色純度，本文首次採用室溫固相法在微米級（ y ， gd ） bo3 : eu3 +顆粒表面包覆一層10nm左右的均勻的氧化鐵的包覆層。
  4. To make cds / k4nb6o17 powder on the base of the k4nb6o17 powder which by the courses of ion exchanging, amine intercalation, sulfuration etc. to obtain cds / k4nb6o17 thin film through the same course of making cds / k4nb6o17 powder on the base of k4nb3o17 thin film on the quartz which made by the spin coating and after heat treatment. to make experiments with additives ( na2so3, 0. 1mol / l ) of photocatalytically decomposing water into h2 and o2 to evaluate the photocatalytic activities of the catalyst knb6o17 powder, cds / k4nb6o17 powder, k4nb6o17 film, cds / k4nb6o17 film. the crystalline structures of the midst powder and film productions were investigated by using the x - ray diffraction ( xrd )

    本課題的主要內容是：高溫固相反應合成具有層狀結構的k _ 4nb _ 6o _ （ 17 ）晶體材料，然後以此為母體材料，通過離子交換、層間胺插入、硫化處理等過程制備出cds / h _ 4nb _ 6o _ （ 17 ）粉末形式的光催化材料；通過旋轉塗覆法在石英玻璃基片上制備了k _ 4nb _ 6o _ （ 17 ）薄膜，採用一定的熱處理制度后對薄膜分別進行離子交換、層間胺插入、硫化處理等處理過程制備了cds / h _ 4nb _ 6o _ （ 17 ）薄膜形式的光催化材料。
  5. Method for high - temperature corrosion test of metallic materials by salt coating

    金屬材料鹽覆層的高溫腐蝕試驗方法
  6. The results denote that the sand layer can greatly enhance heat transfer in high temperature region because it changes film boiling to liquid film evaporation in the sand layer

    在高溫金屬面上覆蓋砂層后，可將高溫面上的膜沸騰轉化為砂粒表面的液膜蒸發，從而大幅度提高表面換熱系數，強化冷卻能力。
  7. Experimental study is performed on the mist cooling of heated high temperature surface covered by a sand layer to investigate the effects of both sand size and thickness of sand layer on heat transfer charateristics in order to enhance heat transfer of film boiling region

    摘要研究了高溫金屬面上覆蓋砂層后的噴霧冷卻換熱特性，測試了砂粒顆粒大小和砂層厚度對換熱特性的影響。
  8. Study on the multi - layer covering and high efficiency cultivation model of vegetables in greenhouse

    日光溫室蔬菜多層覆蓋與高效模式栽培技術研究
  9. To make the thermal efficiency best, y, a, av / as should be : r : [ 60 - 75 ] a : [ 1 - 1. 5 ] av / as : [ 0. 8 - 1 ] in this paper, numerical model of solar radiant floor heating system is also built. the model of numerical model is solved by finite differance method. the smaller the distance to the tube is, the higher the temperature on the surface of the floor is

    地板表面相鄰兩管間水平方向的溫度分佈：距離加熱管越近，溫度越高；兩管中間處溫度最低；供回水溫差越小，地板表面溫度分佈越平緩；在供回水溫度和排管間距均一定的情況下，地板覆蓋層厚度越大，其溫度分佈越為平緩，對應的地板表面溫度分佈越均勻。
  10. Regard the ni - based high - temperature alloy as substrate and the mixed powder by oneself as layer cladding, the microstructure of laser cladding layers under different craft parameters was studied by cw co2 laser

    摘要為了研究工藝參數時激光熔覆層微觀形貌的影響，以co2連續激光器為熱源，在鎳基高溫合金基體表面熔覆自配粉末，對不同工藝參數下熔覆層的微觀形貌進行了分析。
  11. Specification for sprayed metal coatings - protection of iron and steel against corrosion and oxidation at elevated temperatures

    金屬噴覆層的規范.高溫下鋼和鐵的抗腐蝕和氧化保護
  12. Such measures as raising baking temperature of ladle, quickening thermal circulation of ladle, adding insulating lay in ladle lining, adding cover in molten steel surface, adding ladle cover in casting are introduced to reduce molten steel temperature drop in this paper

    闡明了通過提高鋼包烘烤溫度、加快鋼包熱周轉、包襯加隔熱層、鋼水表面加覆蓋劑、澆注鋼包加蓋等減少鋼水溫降的措施。
  13. Test methods for evaluating coatings for high temperature service

    評定高溫設備用覆層的試驗方法
  14. The orthogonal experiment has been used to optimize the electrolyte composition and the craft parameters, with the increasing of the main salt and reducing agent concentration in the electrolyte, the electroless plating coating ’ s adhesive strength and the coverage ratio also increase ; increasing the complex agent content, the electroless plating coating ’ s adhesive strength and the coverage ratio exist the maximum value ; the electroless plating deposition rate distinctly increases when the electrolyte temperature and the ph value were increased, but the increasing of temperature and ph value affects the electrolyte ’ s stability

    採用正交實驗對鍍液成分、工藝參數進行了優化，隨著鍍液主鹽、還原劑添加量的增加，鍍層結合強度及其覆蓋面依次增強，隨著絡合劑添加量的增加，鍍層結合強度及其覆蓋面先增加然後減少，隨著鍍液溫度及其ph值的升高，化學鍍沉積速度明顯提高，但影響鍍液的穩定性。
  15. Microstructure and wear resistance of co - based alloy coating on high temperature alloy by laser surface cladding

    高溫合金激光表面熔覆鈷基合金塗層組織與耐磨性能
  16. The smaller the the difference of the temperature of feedwater and backwater is, the more evenly and slowly the temperature distribution is. the smaller the thickness of overburden layer and the distance of two tubes are, the more evenly and slowly the temperature distribution is

    在供回水溫度和覆蓋層厚度均不變的條件下，排管間距越小，其溫度分佈越為平緩，地板表面的溫度分佈也越為均勻，地板表面平均溫度也越高。
  17. In this dissertation, the application of low temperature sensitivity coefficient ( ltsc ) high - energy nitroamine propellant in a 105mm gun has been studied theoretically and experimentally. the ltsc coated propellant ingredient calculation program, the closed vessel and gun experiment data processing program and the ballistic simulation program, which can simulate gun interior ballistic performances based on closed vessel experiment data, have been programmed with visual program design method

    本文對低溫感高能硝胺發射藥在某105mm火炮上的應用進行了理論和實驗研究，編寫了低溫感包覆火藥包覆層組分計算、密閉爆發器和火炮實驗數據處理以及利用密閉爆發器實驗模擬火炮彈道性能等可視化應用程序。
  18. With both crt ' s and lcd ' s virtue, fed has a bright future in all kinds of pdf. in this thesis, a new type of field emission cathode was described, that is using simple technique to deposit commercial nano - diamond powder on ti substrates, bonding diamond and ti, and form ohmic - contact by proper high temperature to form cathodes

    本文介紹了一種器件結構和制備工藝簡單，易於實現大屏幕顯示，且適于批量生產的新型場發射陰極，即在金屬鈦襯底上均勻塗覆納米金剛石塗層，然後在高溫下退火處理實現兩者的牢固鍵合，並形成歐姆接觸。
  19. Results showed that the coated propellant made by this two technologies have the same low temperature coefficient, and the quality uniformity of products made b y new technology was raised because the thickness and others coating layer ' s pro perties was controlled accurately

    結果表明這兩種工藝製造的包覆火藥均具有明顯的低溫感效果，而且新工藝製造的產品質量均一性由於包覆層厚度及其它包覆層性能得到精確控制而有明顯提高。
分享友人
分享到 Line

分享到臉書