高碳鉻鐵 的英文怎麼說

中文拼音 [gāotàngètiě]
高碳鉻鐵 英文
high carbon ferro-chrome
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 碳 : 名詞[化學] （非金屬元素） carbon （c）
  • 鉻 : 名詞[化學] chromium （24號元素, 符號 cr）
  • 鐵 : Ⅰ名詞1 （金屬元素） iron （fe） 2 （指刀槍等） arms; weapon 3 （姓氏） a surname Ⅱ形容詞1 （形容...
  • 高碳 : high carbon高碳鋼 [冶金學] high carbon steel; 高碳鉻 high carbon chromium; 高碳合金鋼 high carbon...
  • 鉻鐵 : chromium iron; ferrochrome; ferrochromium
  1. The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength

    對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明：碳化鎢體積分數為52時，復合層內基體為灰口鑄鐵組織，顆粒直接分佈在灰鐵基體上，部分碳化鎢顆粒有相互接觸的現象，基材與復合層之間沒有明顯的過渡；碳化鎢體積分數為36 、 27時，復合層內基體為高鉻鑄鐵，由面塊狀的奧氏體和白條狀碳化物組成，碳化鎢顆粒表面固溶於基體組織中，粒形基本保持完整，分佈均勻，與基體構成冶金結合，基材與復合層之間存在一個明顯的平緩過渡區。
  2. Manufacturing : industrial silicon, metal magnesium, calcium carbide, high - carbon ferrochrome, silicon chromium alloys, low carbon ferrochrome china

    製造：工業硅、金屬鎂、電石、高碳鉻鐵、硅鉻合金、中低微碳鉻鐵。
  3. The results show that the composites were more wear resistant than the matrix, contributing to the " volume effect " and " size effect ", the wear resistance increases with the particle content and size. the composite shows better wear resistance than high chromium cast iron material especially in low load and fine abrasive test condition. the results also indicate that the composite strengthened by ageing treatment was more wear resistant than as - cast composite

    磨損試驗結果表明，鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料具有比較高的抗磨料磨損能力，而且其耐磨性隨著鑄造碳化鎢顆粒體積分數及尺寸的增大而提高，表現出了強烈的「體積效應」及「尺寸效應」 ，尤其是在低載荷、細磨料磨損條件下，復合材料表現出更好的而寸磨性，即使與高鉻鑄鐵（ cr28 ）相比也有很大程度的提高。
  4. The effect of compound casting technology and compound modification on the properties of high speed steel roll collar was studied. the results showed that compound high speed steel roll collar with high and even hardness and good bond between outer and inner layers could be gained when the modified colbalt free high speed steel in outer layer and nodular iron inner layer in connection with appropriate rotational speed of centrifugal machine, pertinent pouring interval between two kinds of the melt and moderate pouring temperature as well as surface induction heat treatment were chosen. it is indicated in industrial use that the service life of compound roll collar is higher by 5 times than that of high chromium cast iron collar

    研究了離心復合鑄造工藝和復合變質處理對高速鋼輥環性能的影響，結果表明，選用變質高碳無鈷高速鋼作外層，用球鐵作內層，選擇合適的離心機轉速、兩種金屬熔液澆注間隔時間和澆注溫度，結合採用表面感應熱處理工藝，可獲得硬度高、均勻性好、內外層結合良好的高速鋼復合輥環，用於工業生產其使用壽命比高鉻鑄鐵輥環提高5倍以上。
  5. X - ray diffraction spectrum, empa methods and several tests including mechanical properties, electrochemistry, corrosion wear, on - site plate hanging, the microstructure of steel has been observed and analyzed, performance has been studied, and corrosion - abrasion, fragility mechanism, and microalloy application in ferritic stainless steel have been explored comprehensively. the test results of electrochemistry, corrosion wear and on - site plate hanging have been analyzed. the analytical result shows that crsomo has enough corrosion resistance in phosphoric acid slurry because it has high chromium and low carbon

    通過實驗室的電化學試驗、腐蝕磨損試驗和磷肥廠的現場掛片試驗結果分析，表明： cr30mo鐵素體不銹鋼高鉻低碳的配合，保證其在磷酸料漿中具有足夠的耐蝕性： cr30mo中（ fe ， cr ） _ 23c _ 6 、 （ fe ， cr ） _ 7c _ 3 、 mo _ 2c 、等碳化物硬質點從基體的彌散沉澱析出可提高鋼的硬度和耐磨性，使得鋼在磷酸料漿中具有良好的耐磨蝕效果。
  6. The boundary of ferrite has been clarified and fined by adding re into crsomo. the intergranular corrosion induced by solution chromium decreasing can be restrained for nb, v, ti combing carbon in the steel. the wear resistance of stainless steel can be increased for the precipitation of microalloyed carbides

    其中，稀土能夠凈化鐵索體晶界，並起到變質劑的作用，細化鐵素體晶粒，改善不銹鋼的韌性；鈮、釩、鈦能夠與鋼中的碳結合，減少固溶鉻的損失，從而避免晶間腐蝕，同時細小微合金碳化物的沉澱析出可提高不銹鋼的耐磨性。
  7. The products such as ferro - silicon, high - carbon ferro - chrome, medium and low carbon ferro - chrome, micro - carbon ferro - chrome, medium and low carbon ferro manganese and chrome metal have won the high quality title in china. the new developed products have broad prospects such as low carbon silicon manganese, low - titanium ferro - chrome and micro - low carbon ferro - manganese

    公司產品：硅鐵高碳鉻鐵中低碳鉻鐵微碳鉻鐵中低碳錳鐵金屬鉻低碳硅錳低鈦鉻鐵低微碳錳鐵等產品市場前景廣闊。
  8. Under the conditions of low stress abrasion, eutectic composition is the optimal composition of high - cr white cast iron. the narrow intercarbide spacing is quite benefical to protect the austenitic matrix

    摘要低應力磨料磨損條件下，高鉻白口鑄鐵以共晶成分為宜，在細小的共晶組織中，碳化物間的短小空間對共晶奧氏體起到良好的保護作用。
  9. The result showed that, by adopting appropriate casting method, a good metallurgical combination between tungsten particles and hi - cr alloyed cast iron could be obtained

    結果表明，在適宜的鑄造工藝條件下，碳化鎢顆粒和高鉻鑄鐵基體之間可以形成良好的冶金結合，鑄滲效果較好。
  10. Abstract : the microstructure of as - cast high cr injection micro - alloying martensitic cast iron and the substructure of martensite in it have been observed under sem and tem. the alloying element distribution related to phase formation, as well as the various types of branch and distortion of carbide in the martensitic cast iron have been explored by using x - ray diffraction and electron probe analysis

    文摘:應用掃描電鏡和透射電鏡研究了噴射微合金化的鑄態馬氏體高鉻鑄鐵顯微組織及馬氏體的亞結構，並藉助x射線衍射與電子探針分析探討了合金元素的分佈與相形成的關系，以及碳化物的不同形式分枝與畸變。
分享友人
分享到 Line

分享到臉書