高速乳劑 的英文怎麼說

中文拼音 [gāosùrǔjì]
高速乳劑 英文
high speed emulsion
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 乳 : Ⅰ動詞（生殖） give birth to Ⅱ名詞1 （乳房） breast2 （奶汁） milk 3 （像奶汁的東西） any milk lik...
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 高速 : （高速度） high speed; high velocity （hv）; high rate; swift; fast; express; high-speed
  1. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採用有機硅單體延遲滴加及添加水解抑制劑等技術，有效防止了-甲基丙烯酰氧基丙基三甲氧基硅烷在乳液聚合過程中的過渡水解及縮合反應，提高了聚合物大分子鏈中有機硅鏈節的含量；利用紅外光譜與差示掃描量熱儀對產物分子結構進行了表徵，並通過對共聚產物力學和吸水率的測試，證實了本研究所制備的有機硅改性丙烯酸酯共聚物具有比純丙烯酸酯聚合物更優良的力學及耐水性能；從分子設計角度出發，利用醇解反應合成出水解、縮合反應速率較慢的兩種新型不飽和有機硅單體： ?甲基丙烯酰氧基丙基三乙氧基硅烷和?甲基丙烯酰氧基丙基三異丙氧基硅烷；利用核磁共振對新型硅烷單體結構進行了證實；研究表明利用新型硅烷單體可以制備出高硅烷含量的有機硅改性丙烯酸酯乳液，且其聚合產物具有較高的力學及耐水性能。
  2. Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling

    首先，系統研究了乳化機轉速和乳化劑濃度對膠囊性能的影響，並通過提高轉速或乳化劑濃度獲得相變材料納膠囊；其次，系統研究了不同成核劑對微膠囊性能的影響，找到合適的成核劑抑制了相變材料微膠囊的過冷現象；再次，詳細研究了環己烷對膠囊性能的影響，並通過添加適量環己烷提高了相變材料微膠囊及納膠囊的耐熱溫度。
  3. Its main natural enemies were chilocorus kuwanae silvestri, chrysopa spp., spiders, predatory mites, amitus kerperidum silvestri and prospaltella sp. the single use of omethoate, optunal or methidathion, etc. was not satisfactory to keep this insect pest under control, the control effect of combined use of omethoate and optunal was somewhat better than their single use, and was much better ( 90. 93 % ) as putting a few emulsified machine oil into this combination, while the use of mixture b, 32 % of 40 % omethoate + 48 % of 40 % optunal + 15 % of 4. 5 % - cypermethrin + 5 % of synergist, got most desirable effect ( 97. 71 % )

    藥劑試驗表明，氧化樂果、水胺硫磷、速撲殺等藥劑單用時效果不理想，但氧化樂果和水胺硫磷混配後效果有所提高，如果與機油乳劑配合使用，則效果更好，可達到90 . 93 % ，復配劑b 40 %氧化樂果（ 0 . 32 ） + 40 %水胺硫磷（ 0 . 48 ） + 4 . 5 %高效氯氰菊酯（ 0 . 15 ） +增效劑（ 0 . 05 ）的防效最好，達97 . 71 % ，是目前防治柑桔黑刺粉虱最好的藥劑之一。
  4. It was found that polymerization rate was increased with the increased dosage of initiator or surfactant ; particle size of miniemulsion was kept relatively stable during polymerization when an initiator of lower solubility was used ; an increase in dosage of dpr reduced polymerization rate, but showed no significant impact on the final monomer conversion

    實驗結果表明：引發劑或乳化劑的用量增加可以提高單體的轉化速率；引發劑水溶性的降低可以更好地控制聚合過程中的粒徑變化；歧化松香含量的增加降低了聚合速率，但對單體的最終轉化率影響不大。
  5. Graft copolymerization of methyl methacrylate onto carboxymethyl chitin was carried out by stirring quickly and no emulsifier, without emulsifier made the products more pure

    摘要通過高速攪拌，未使用乳化劑，制備了羧甲基甲殼素和甲基丙烯酸甲酯的接枝共聚物，避免了產物中引入乳化劑雜質。
分享友人
分享到 Line

分享到臉書