高阻電橋 的英文怎麼說

中文拼音 [gāodiànqiáo]
高阻電橋 英文
megohm bridge
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 名詞1. (橋梁) bridge 2. (姓氏) a surname
  1. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發,提出了一種lcc諧振型恆頻移相單相頻鏈逆變路拓撲,在調制系數0 . 1 m 0 . 5情況下,控制移相角按正弦規律變化,使諧振壓脈沖列的幅值追蹤參考正弦壓信號,經過整流、濾波、低頻逆變,從而獲得正弦度較好的輸出壓。理論分析和實驗結果證明對于性負載或感性負載,移相全具有超前臂零壓開通,滯后臂或者零壓開通( _ 0 )或者零流關斷( _ 0 )的軟開關特性,而低頻逆變器的各個開關均實現零壓條件下的開通與關斷。
  2. The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material

    本文的主要工作和結論如下:在人工氣候室內,根據不同覆冰絕緣子正、負極性下的閃絡試驗結果,得出負極性弧金屬陰極的強子發射能力造成了單片瓷、玻璃絕緣子及被冰凌接的合成絕緣子有較低負極性冰閃壓;正極性弧金屬陽極側產生區所處位置的差異使得瓷和玻璃絕緣子串具有明顯的極性效應;覆冰較少時,合成絕緣子表面出現數量較多的非極性弧使合成絕緣子無極性效應。利用覆冰期內平均閃絡壓的試驗方法,對不同材質和結構的絕緣子在覆冰、低氣壓和污穢共存環境中的直流閃絡特性進行了研究。試驗結果表明,直流平均閃絡壓隨著海拔的升、覆冰量的增加以及污穢度的增加而降低,且其特徵指數與絕緣子結構、覆冰量、覆冰狀態、污穢度等有關。
  3. D. c. bridge for measuring high resistance

    直流高阻電橋
  4. Dc high resistance bridge

    直流高阻電橋
  5. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用路和單運放差動放大路對溫度傳感器信號檢測放大,軟體校正溫度傳感器和測量路的非線性,軟體校準測量路的零點和滿度,消除測量路的系統誤差,提補償溫度的測量精度;採用、低漂移運放tlc2254組成差動放大路用於酸度極信號測量。
  6. A new bridge type high temperature superconducting fault current limiter ( sfcl ) with a limiting impedance of superconductor serried in the limiting circuit is proposed, which could limit the peak value and the stable value of the fault current

    摘要提出一種改進的溫超導限流器拓撲結構,將不同溫超導體製成的限流與限流感同時申入式限流迴路。
  7. Usually the bridge circuit has a relatively high input impedance so that it has an insignificant effect on the signals in the transmission line

    通常路具有較的輸入抗,因此傳送線上的信號將不受影響。
  8. In this paper, a kind of improved practical active linear bridge circuit with platinum resistor is used to eliminate the error mentioned above, and the precise temperature measurement can be made

    本文採用鉑改進型實用有源線性化路克服了上述誤差,實現了精度的溫度測量。
  9. The 3 - db bridge of low loss, which is the vital part in improving power combining efficiency, is different from wilkinson bridge. it features usage in high performance power division and combining networks with the usual dielectric materials, as well as low loss, no need for resistant material, and simple fabrication technology

    本課題設計的低損耗3 - db不同於一般常用的wilkinson,其特點除了損耗低外,無需性材料,且製作工藝簡單,可以在常用的軟基片上做出性能的功率分配、合成網路。
分享友人