高電阻繞組 的英文怎麼說

中文拼音 [gāodiànzǔràozǔ]
高電阻繞組 英文
high-resistance wind
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 繞 : 繞名詞1. [書面語] （彎曲） bend2. （姓氏） a surname
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. In this thesis, the author analyses the deficiency in detecting and controlling function of the computer detecting and controlling system utilized in present transforming station. the strategy of design of software on operation and direction of 5 00kv transformer station is presented. it points out that we can deduce the mathematic analytical formula using the current, voltage and power of two terminals of transmission line as input. on this basis, we do realtime calculation of 500kv transmission line ' s parameter. we can also deduce the linear analytical formula of three - winding autotransformer ' s resistence using its current, voltage and power as input. the corresponding software is programmed on this basis

    論文提出以輸電線路本端和對端電流、電壓、功率作為輸入量，導出了超高壓長線的波阻抗和傳播常數的數學解析式，在此基礎上進行了500kv輸電線路實時參數計算；提出以三繞組自耦變壓器的電流、電壓、功率為輸入量，導出了自耦變壓器繞組的電阻、電抗的線性解析式並進而對變壓器的實時參數進行計算；在此基礎上編制了相應的軟體。
  2. Since the secondary winding is normally operated into a high-impedance circuit, the secondary current is quite small.

    因為次級繞組通常輸入高阻抗的電路，因此次級電流很小。
  3. However, the result of the simulation, in which all the parameters are kept constant except the primary and secondary inductance, is that 3 % higher conversion efficiency can be achieved in ccm than in dcm

    但對輸出功率和繞組電阻相同時逆變電路模擬結果表明， ccm的效率比dcm提高了三個百分點；試驗結果說明盡管ccm的繞組電阻比dcm的大，變換器效率仍提高了1 . 5 。
  4. In accordance with the driving characteristics of ac driving locomotive, the working status of its traction transformer is analysed. the questions that should be considered in the traction transformer design of ac driving locomotive are mentioned. these questions are the large short - circuit impedance of traction winding, higher harmonic current, over - excitation and dc magnetization caused by large variation of the network voltage, etc. some disposal methods are given

    針對交流傳動電力機車的傳動特點，對其中的牽引變壓器的工作狀態進行了分析，指出交流傳動電力機車用牽引變壓器設計時需考慮的牽引繞組的短路阻抗大、電流的高次諧波、網壓波動大可能引起的過勵磁以及直流磁化等問題，同時給出了相應的一些解決方法。
  5. Antiflaming and antistatic high pressure wire spiral rubber hose is consist of an inner, a protectionlayer, middle layer, wire reinforcement layer, and a rubber cover

    阻燃抗靜電高壓鋼絲纏繞膠管結構是由內膠層、內膠保護層、中膠層、鋼絲纏繞層和外膠層組成。
  6. Soken electric co., ltd. was established in 1974 by several technical staff of japanese governmental institute etl electrotechnical laboratory and jemic japan electric meters inspection corp.

    同時顯示電阻和溫度，提供高效率和高精確度測量激磁線圈的電阻值及繞組溫升。
  7. According to the no - loading waveform deviation factor, the prototype conforms to the national design standard and practical needs in the engineering. more important, the high voltage is achieved. in the condition of considering core saturation and damping winding influence, the influence to powerformer of the no - loading tooth harmonic emf is smaller than conventional generator, and the waveform deviation factor of the former is smaller, too

    由求得的樣機空載電勢波形畸變率可知，該樣機滿足國家設計標準和工程實用要求，更重要的是，實現了產生高壓的目的；考慮鐵心飽和、考慮阻尼繞組影響情況時，電力發生器與具有相同尺寸（除定子槽形）的傳統發電機相比，空載齒諧波電勢對電力發生器的影響較小，前者的空載波形畸變率較小。
  8. As a new kind of motor, switched reluctance motor ( srm ) has a doubly salient structure, and its windings are only mounted on the stators. these characteristics bring srm lots of virtues : solid structure, high reliability and efficiency, good fault - tolerance, low cost etc. switched reluctance driver ( srd ) combined srm with modern power electronic technology and control technology

    開關磁阻電機（ srm ）作為調速電動機的新品種，採用定、轉子雙凸極鐵心結構，並且只在定子上裝有集中繞組，轉子上無繞組或永磁體，具有結構簡單堅固、運行可靠、效率高、功率變換簡單、容錯性好和成本低等優點。
  9. Under the conditions of high safe coefficient of insulated electrical strength of the stator winding of the generator, the selection of earthing resistance value should meet the needs of matching one - point earthing protection of the stator and limiting the fault current

    在發電機定子繞組絕緣電氣強度有較高的安全系數的情況下，接地電阻值的選取應主要服從與定子一點接地保護的配合及限制接地故障電流的需要。
  10. The set of these eigenvalues can be regarded as the eigenvalues of primary system approximately. this method not only can control the scale of the block - decoupling subsystems, but also achieves the reduced - order eigenvalue calculation for multi - machine power system. so this method can avoid the dimension disaster in the qr and calculate all the eigenvalues of large power system with the effect of damping windings considered

    這一方法可以控制分塊解耦子系統的規模，實現多機系統特徵值的降階計算，避免特徵值qr演算法的「維數災難」 ，同時為採用計及發電機阻尼繞組作用的詳細模型計算大型電力系統的全部特徵值、提高電力系統小擾動穩定分析的準確性提供了一種方法。
  11. The high voltage windings is made by sectional aluminium foil with glass fiber and resin casting, the voltage between turns is very low, the partial discharge is very low, there is no cracking, since the expansion factor of conductor and insulation material is similar, it also has the advantages of no corrosion, no pollution, low losses, low noise level, anti - vibration, fire protection, maintenance free, long operating life and high reliability

    低壓繞組為銅箔繞制，半干nomex紙做層間和外層絕緣，經乾燥與銅箔固化為一體，散熱好強度高。高壓繞組為分段鋁箔繞制，玻璃絲網架環氧樹脂澆注，層間電壓低，局部放電小，導體和絕緣體膨脹系數相似，不裂壽命長無腐蝕無污染損耗小噪音低抗震阻燃免維護運行安全可靠。
  12. Different distribution of power loss can be worked out by mathcad software based on the formula reasoning. the result of calculation is consistent with that of the experiment, which proves that this method is right. it is pointed out through the analysis of calculating data that the key to improve efficiency at the same output power is to decrease the peak current and rms current of power switches or the on - resistance of mosfet and windings

    由推導可得損耗計算公式，利用數學計算軟體計算出電路輸出從空載到410w阻性負載時損耗分佈變化，該結果與實驗數據基本相吻合，證實了這種方法的正確性；通過對計算數據的分析，指出了進一步提高效率的關鍵在於輸出相同功率時降低功率管的電流峰值和有效值，減小繞組和mosfet的導通電阻。
分享友人
分享到 Line

分享到臉書