高頻補償電路 的英文怎麼說

中文拼音 [gāobīnbǔchángdiànlù]
高頻補償電路 英文
high peaker
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 高頻 : high frequency
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. This paper introduces a power controlling system for electrosurgical generator based on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    介紹了基於可控硅整流電路的高頻電刀控制系統，並針對該類型電刀的輸出功率隨電網電壓波動而發生漂移的問題，採用了一種功率補償的方法，實現輸出功率在不同的電網電壓的波動下保持恆定。
  2. This paper introduces a power controlling system for electrosurgical generator baaed on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    摘要介紹了基於可控硅整流電路的高頻電刀控制系統，並針對該類型電刀的輸出功率隨電網電壓波動而發生漂移的問題，採用了一種功率補償的方法，實現輸出功率在不同的電網電壓的波動下保持恆定。
  3. The electric power harmonic comprehensive control system with low cast and high security is applied in this article. it adopts that sourced compensation links with non - sourced compensation herewhich the former is realized by high frequency pwm control technology and the latter is carried out by crystal switch formed by non - flow and over - voltage. it can realize stepless modulation with imaginary power, mightiness compensation of harmonic and negative electricity, and circuitry consumption debasing are achieved

    提出採用有源補償與無源補償相結合的電力諧波綜合治理技術及裝置，無源部分採用無涌流和過電壓的晶閘管控制電容器技術實現，有源部分採用高頻pwm控制技術實現，成本低、可靠性高、可實現無功功率的無級調節、強力補償諧波電流和負序電流，降低線路損耗。
  4. At the same time, the method of disposal phase shift of ct by compensation is introduced. then the analysis and statistic of electrical power quality, the control scheme and compensating amount of capacitor for reactive power compensation are analyzed respectively. and in the paper, the control with a / y and the switch with ac contactor and solid state switch is valid measure not only for improving operate level economically and amending electrical power quality but also for avoiding of replacing switch frequently and decrease economic loss

    然後對現有的演算法進行了詳細的分析、比較，篩選出既能滿足硬體要求又可降低投資、保證精度、簡化軟體的方案，確定了準同步采樣的方案，並通過對準同步采樣誤差的分析，提出了一種從45開始采樣，從而提高精度的采樣數據處理辦法，同時，對于電流互感器相位漂移提出了一種補償辦法，接著對裝置中電能質量分析與統計以及無功補償中電容器的補償量、投切原則也作了相應分析，其中對于無功補償採用y混合接線，並利用交流接觸器和固態開關共同投切電容，不但提高了經濟運行水平、改善了電能質量，而且有效的避免了頻繁更換開關，減少了經濟損失；最後，設計了裝置的硬體電路並繪制了相應的軟體流程圖。
  5. High frequency compensation in bypass circuit, parallel in power filtering

    高頻補償旁路，電源濾波並聯，改良音樂高音
  6. The circui t construct ion and the relevan t schemes of the realization of the circuit are also provided, simultaneously, the source of errors and the compensation methods are discussed. all of analysises, calculation results and simulations demonstrate that the methods presented in the paper are feasible, the algorithm is effective, the realization of circuit is simple, the procedures of the design are standard, the circuit is easy to be fabricated on a monolithic, and the system can be used for processing middle - high frequence signal and be applied in low - voltage, low - power and at high speed

    在此基礎上，本文首次提出了一種基於狀態空間對數域濾波器的一維連續小波變換實現方法、結構以及相關模塊電路實現的策略，並對該方法的誤差來源與補償措施進行了討論。論文中的理論分析與計算以及模擬結果表明，用對數域狀態空間濾波器實現一維連續小波變換的方法可行，演算法簡單、有效，電路實現簡單，設汁過程規整，易於單片集成，適合處理中、高頻信號並運用於低電壓、低功耗、高速的場合。
  7. In its digital processing circuit, clock chip with high precision and temperature compensation is uesd as reference clock. high frequency reversible counter is used to count trimmed impulse signal forward or backward and two pathes saw signals are selected timely by multichannel selector

    數字信號處理電路採用高精度、具有溫度補償的時鐘晶元作為基準時鐘，採用高頻可逆計數器對整形后的脈沖信號進行正向或逆向計數，採用高性能的多路選擇器控制兩路saw信號的定時選擇。
  8. The experiment result shows that conversion efficiency in ccm is improved by 2 percent compared with that in dcm, although the on - resistance of winding in ccm is more than that in dcm. the analysis of open - loop transfer function in both dcm and ccm shows that pull - push hfl inverter at ccm

    微分補償網路的推挽高頻鏈逆變電路在輸出從空載變化到額定阻性負載變化的過程中，逆變電路工作模式從dcm變化到ccm模式，實驗結果表明電路在這兩種模式下都能輸出穩定的正弦電壓，且具有較高的穩態精度。
  9. In order to solve this problem, this research adopts the electrical self - regulation circuit in series, on the basis of the unchanged of transfer function of electromagnetism rate transducer, extend frequency bandwidth of the transducer, improving its capability. after the self - regulation, the transducer has high passing feature and inferior lower lever cut - off frequency ( below 1 hz )

    為了解決普通電磁式速度傳感器不能檢測超低頻振動信號的問題，本研究採用了一種串聯式電子補償電路，在保持電磁式速度傳感器的傳遞函數性質（高通）不變的前提下，拓展了傳感器的頻寬，改善了傳感器的性能。
分享友人
分享到 Line

分享到臉書