點匹配法 的英文怎麼說

中文拼音 [diǎnpīpèifǎ]
點匹配法 英文
point match method
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 匹 : Ⅰ動詞（比得上; 相當; 相配） be equal to; be a match for Ⅱ形容詞（單獨） lone Ⅲ量詞1. （用於馬、騾等） 2. （用於整卷的綢或布）
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 匹配 : 1. [書面語] （婚姻配合） mate; marry 2. [電學] matching
  1. In local vector match method, we add the line numbers and the dispersion of direction angle between the center point and near minutiae point. we also add the direction angle of the center point. these additions enhance veracity of the minutiae feature matching

    在局部向量特徵匹配法中加入了中心點與鄰近特徵點的紋線數，方向角差，中心點的方向角等特徵信息，提高了特徵匹配的準確性。
  2. The main work and achierement are as following : ( 1 ) by using shock impedance matching technique and electric probe method, 5 shots of impact experiments were conducted to measure the hugoniot equation of state for enstatite ( mg0. 92, fe0. 08 ) sio3 with the average initial density 3. 05g / m3 from shock pressure 50 gpa to 115gpa, using two stage light gas gun

    本文研究取得的認識主要有以下幾點： （ 1 ）用阻抗匹配法和電探針技術在80 115gpa壓力范圍內對平均初始密度為3 . 05g / cm ~ 3的頑火輝石樣品進行了5發hugoniot狀態實驗測量。
  3. ( 3 ) a minutiae matching method combining genetic algorithm and fuzzy logic is proposed

    （ 3 ）提出了綜合利用遺傳演算法和模糊邏輯的細節點匹配方法。
  4. Modeling : this thesis develops a method different from traditional techniques that begins with the cylindrical projection of a generic model and its seamless global texture map using multiresolution technique, and then automatically fit the unwrapped cylindrical projected mesh to the texture map with an improved algorithm that based on 2d morphing to specify corresponding feature points ( or lines ). finally, we propose a formula of inverse cylindrical projection to recompose the deformed mesh, and after the texture mapping a photo - realistic individual facial model is created

    採用多解析度技術構造紋理無縫拼接圖，然後把三維網格模型投影到圓柱面上並展開，根據二維圖象變形技術中特徵點匹配演算法的數學思想，將匹配公式進行改進后應用於模型網格點的適配，在作了一定假設后推導出逆向圓柱映射的計算公式，再將適配后的柱面網格映射回去，最後進行紋理映射生成真實感的特定人臉的三維模型。
  5. This paper proposes a practical method of automatic acquisition cognominal points in system of binocular stereo vision, which provides necessary parameter for camera relative calibration, moreover it presents farther study in acquiring and matching feature points

    提出了一種新的方法來進行雙目立體視覺系統同名點的自動提取，對現有的特徵點匹配方法進行了改進，通過對同名點的自動提取，獲取了攝像機相對校準所必需的參數
  6. A brand new method of grid nodes corresponding is proposed based on 2 - dimensional neighbor node table. 4. coordinate data visualization

    獨立的提出了基於網格點相鄰關系建立二維表格的網格點匹配演算法。
  7. As to the modelling of integrated flight / propulsion system, this paper mainly investigated and the modelling methods of flight kinetics and propulsion system thermodynamics, building up the real - time models of body kinetics. then we integrated the component - level thermodynamics model of engine, solved the problem of matching of initial points in the integrated simulation of flight / engine and the interactive parts of flight system and propulsion system

    對于綜合飛行/推進系統建模，本文主要研究的是飛行動力學和推進系統熱力學的建模方法，建立了飛機動力學實時模擬模型。並結合前人已建立的發動機部件級熱力學模型，本課題在解決了飛機/發動機綜合模擬中的起始點匹配問題的基礎上，完成飛行系統和推進系統的交互部分，最終建立飛行/發動機綜合實時模擬模型。
  8. In those processes, preprocessing is based on a serial of algorithms using gobar filtering techniques and mathing is based on a compound algorithm in two stages : the first is a structural maching using local features and the second is a point matching by rotation and displacement

    其中，指紋預處理採用了以gobar濾波為核心的一套演算法；指紋匹配採用了基於結構信息的指紋初篩和基於旋轉平移的點匹配指紋確認兩級構成的復合式演算法。
  9. 4 ) in unit 5, an alignment - based algorithms minutiae matching for fingerprint verification is studied

    4 ）對基於脊線校準的特徵點匹配演算法進行了研究和討論。
  10. In this thesis, some key issues of the vr technique are systematically investigated. firstly, for the image filters and image interpolation between slices, a integrated interpolation algorithm is presented based on the contour shape and correspondence matching, which keeps the shapes and grays information the objects of interest. secondly, the fidelity of effect of the vr for medical images is studied, and a continuous - gradient - based method for transparent volume rendering is proposed, which vivifies the results of volume rendering

    首先，研究了醫學斷層圖像數據的濾波及層間插值技術，提出了一種基於輪廓形變和對應點匹配相結合的混合插值演算法，在實現圖像層間插值的同時保持了目標的輪廓形狀與灰度信息；其次，對醫學影像容積重建效果的逼真度進行了研究，提出了一種基於連續梯度轉換函數的互動式透明體繪制方法，使重建效果更加生動、真實。
  11. Using the dsd models and forward scattering amplitude computed by the least squares fitting method, the specific attenuations at l - 400ghz have been computed and analyzed, the parameters of " power law " relation between specific attenuation and rainfall rate are obtained. the specific attenuations in qingdao, guangzhou and xinxiang are compared with itu - r specific rain attenuation models

    利用平均雨滴尺寸分佈和點匹配法計算的雨滴的前向散射數據計算和分析了青島、廣州和新鄉地區1 ? 400ghz特徵雨衰減特性，得到了特徵雨衰減與降雨率的指數關系參數，並與itu - r （ internationaltelecommunicationunion - radiocommunication ）特徵雨衰減模式進行了系統的比較研究。
  12. In chinese words take - out module we adopt an approach using the characters of chinese to pre - process the downloaded web pages, and an approach of max - matching and frequency statistics

    中文分詞部分採用了利用漢字的特點對文檔進行預處理的方法和基於詞庫的最大匹配法和無詞庫的頻度統計法相結合的方法。
  13. The high similarity in shapes and large overlapping areas of corresponded contours on adjacent cross - sectional are main conditions in reconstructing surface correctly. in accordance with the disadvantage of blurring caused by traditional gray - level interpolation methods, this dissertation introduces a method to interpolate 3d images based on point matching approach to get 3d isotropy volume data. with respect to non - similar shapes or no superposition of corresponded contours on adjacent slices and concave contours, this dissertation presents a method for shape - based interpolation based on nonuniform scale bounding box

    相鄰斷層上對應輪廓區域的形狀相似和重疊部分大是保證重建表面正確性的重要條件，針對傳統灰度插值容易引起模糊邊界的缺點，本文採用基於對應點匹配的方法進行灰度插值，以獲得各向同性的三維數據；針對相鄰斷層間對應輪廓的形狀不相似，位置不重合和有凹輪廓線的情況，提出一種基於包圍盒非均勻比例放縮的形狀插值方法。
  14. In this paper we present three new methods of image manipulation including linear parallel search method for region labeling, statistical peaking method for object - size ascertainment and characteristic - points matching method for object recognizing

    針對核孔膜顯微圖像自動識別的具體問題，本文創新地提出線性并行區域標記方法、對象尺寸統計峰值方法和特徵點匹配識別方法。
  15. Fifth, we select two methods of point pattern to match minutiae feature

    選取了基於圖像校準的點模式匹配法和局部向量特徵匹配法進行指紋的特徵匹配。
  16. In the match method based on picture emendation, we use the changeable sized boundary box which influences the disadvantage of the unchangeable sized boundary box

    在基於圖像校準的點模式匹配法中採用了可變大小的界限盒，改變了固定大小的界限盒的不足。
  17. 3 、 chinese words divided syncopation technology is the difficulty of the query technique based on phrase. some divided syncopation such as mechanical matching method, feature phrase library method, restriction matrix method, syntax analysis method and comprehended syncopation method are emphasized

    對其中的幾種方法，如機械匹配法（即mm法） 、特徵詞庫法、約束矩陣法、語法分析法和理解切分法等做了詳細的比較和分析，並歸納出各自特點。
  18. To the complete character use the image which representation by matrix, making the subtraction between the matrix of capture image and the matrix of template, the result matrix which absolute sum of its all elements is the smallest is the recognition result. to the incomplete character, using two lines of 0 ~ 9 as template, then carry on the recognition using the template matching. to the scale division recognition, using the central position of it, distinguishes the long scale division expression is merely 0 perhaps 5

    對完整字元，採用將圖像用矩陣表示，利用獲取圖像的矩陣與識別模板的矩陣做減法，結果矩陣的所有元素絕對值和最小的即為識別結果;對不完整字元，針對電度表讀數的具體特點，採用將兩行0 ~ 9的字元圖像排列起來作為模板，利用模板匹配法進行識別;對于刻度的識別，利用刻度的中心坐標位置，僅僅識別長刻度表示的是0或是5即可。
  19. The pairwise matching of feature points in each resolution is the emphasis of our discussion. an improved method based on mapping is adopted to find the best match of each feature point. experimental results show that it can effectively reduce the number of wrong matches, thus increase the precision of image stabilization

    重點研究了金字塔每層中特徵點匹配問題，提出了利用前後映射尋找一一對應特徵點的方法，實驗結果表明，該方法能有效排除錯誤的特徵點配對，從而減少運動參數估計的誤差。
  20. A matching method of homonymy points on grain - lacking object

    缺乏紋理目標同名點匹配方法
分享友人
分享到 Line

分享到臉書