點燃溫度 的英文怎麼說

中文拼音 [diǎnránwēndù]
點燃溫度 英文
ignition temperature
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 點燃 : 1 （使燃燒） light; ignite; enkindle; kindle; put [place; set] a match to 2 [機械工程] （發火; 點...
  • 溫度 : [物理學] temperature
  1. Heat convected, a mode of motion developed by such combustion, was constantly and increasingly conveyed from the source of calorification to the liquid contained in the vessel, being radiated through the uneven unpolished dark surface of the metal iron, in part reflected, in part absorbed, in part transmitted, gradually raising the temperature of the water from normal to boiling point, a rise in temperature expressible as the result of an expenditure of 72 thermal units needed to raise i pound of water from 50 to 212 fahrenheit

    燃燒所引起的運動形式之一-熱對流傳熱，不斷地加速度地從熱源體傳導給容器中的液體，由那凹凸不平未經打磨的黑色鑄鐵面把熱向周圍發散出去一部分反射回來，一部分被吸收，另一部分被傳導，使水的溫度從常溫逐漸升到沸點。這種溫度的上升可作為消費結果標志如下：將一磅水從華氏五十度加熱到二百十二度，需耗七十二熱量單位。
  2. Metals are characterized by relatively high ignition temperatures.

    金屬的特點是較高的點燃溫度。
  3. Abstract : in the research of internal combustion engine, recordingin - cylinder pressure and temperature is an essential technique to study the thermal cycle of internal combustion engine. the combustion analyzer developed in this study will give both the measurements at sampling points per crank angle or sampling cycle, calculate and show the real time parameters which decide the working process of internal combustion engine, such as pressure accelerating rate, indicateed mean effective pressure, cycle - to - cycle variation, heat release rate, etc. compared with the imported congeneric products, the analyzer has many advantages such as chinese interface, low price, easy operateing, convenience in maintainance and easy upgrading

    文摘:為了測錄內燃機缸內的壓力及溫度，開發了一種內燃機燃燒分析儀.該分析儀由國產高速數據採集卡及自行開發的控制軟體組成.它不僅能精確設置每度曲軸轉角內采樣點的個數和採集循環數，而且在採集過程中能實時計算和表徵內燃機工作過程的壓力升高率、平均指示壓力、循環變動率、放熱率等參數.經實際使用以及與國外產品相比表明，此分析儀具有全中文界面、價格低、操作簡單、使用維護方便、功能便於擴充等優點
  4. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般壓力表氣壓表抗震壓力表充油壓力表全不銹鋼壓力表膜盒微壓表電接點壓力表冷媒壓力表真空壓力表壓力真空表隔膜壓力表微型壓力表差壓表微差壓表絕壓表精密壓力表耐高溫壓力表蒸氣壓力表汽車燃氣壓力表醫用壓力表遠傳壓力表衛生型壓力表壓力表緩沖管壓力表冷凝散熱器壓力表翅片散熱器壓力表開關不銹鋼連接彎管不銹鋼連接軟管轉換接頭油壓連接頭壓力表針閥節流閥及過壓保護附件濾油網加油口油溫油麵計雙金屬溫度計等。
  5. This temperature is called a material " s flash point

    這個溫度就被叫做物質的燃點。
  6. Testing of combustible materials ; determination of ignition temperature

    可燃材料試驗.點燃溫度測定
  7. Plastics - determination of ignition temperature using a hot - air furnace

    塑料.用熱風爐測定點燃溫度
  8. From simulations and data of fire site, most air preheater fire often appear when boiler is started in cool state and standby which fuels of insufficient combustion coagulate and congregate on the parts of air preheater. when the temperature of smoke inpouring air preheater increases, aggregate fuels and sediments will combust in stated temperature conditions. it is called the second combustion of air preheater

    這些起火起因於燃料油的不充分燃燒，其結果是未充分燃燒的燃料油凝結和聚集在空氣預熱器的部件上，當進入空氣預器的煙氣溫度增高時，沉積的燃料油被烘烤，當達到一定溫度條件時，則可點燃這些燃料油污沉積物，造成火災發生，這通常被稱為空氣預熱器的二次燃燒。
  9. At last, the conclusions of the whole thesis are drawn, and it is put forward that the future research emphases on the infrared radiation absorption ct technology should focus on : instantly get the absorption projections are the crucial factor to utilize the technology industrially ; on the basis of the hypothesis that the gas is ideal gas, species concentration of particular gas medium can be measured at the same time, which must be helpful to comprehend combustion essence ; if laser source to replaces blackbody stove, for irradiant flame, interferometric projection can be attained, and its temperature distribution will known

    最後，對全文進行了總結，並指出今後研究工作重點。指出：瞬時得到各方向的投影是此技術實用化關鍵；在獲得溫度分佈信息基礎上，進行必要的假設和推導，能同時得到火焰中某特定組分濃度的分佈，這必將進一步我們對燃燒本質的理解；利用方向性好，輻射強度高的激光源代替常規的黑體爐，能得到輻射干涉投影圖像，這樣就能測量所介紹系統不能測量的發光火焰溫度分佈。
  10. In the article, the originator worked out the mechanism of magnesium - base alloys catching fire ; analyzed briefly the influence of the temperature, the heating velocity and the pressure of oxygen in the atmosphere on the lumps and scraps of pure magnesium ’ s catching fire, and designed a practical method to measure the kindling temperature of the lumps and scraps of pure magnesium precisely, with which the initial quantization of kindling temperature can be realized

    本文圍繞鎂合金阻燃技術的開發作了許多基礎性的研究工作，通過分析大量的相關文獻和試驗結果，初步得出了塊狀鎂和鎂屑的燃燒機理，簡要分析了溫度、升溫速度、環境中氧的分壓對塊狀鎂和鎂屑的起火燃燒所產生的影響。設計出了精確度高、實用性強的塊狀鎂和鎂屑的燃點測試方法，使塊狀鎂和鎂屑的燃點得到初步的量化。
  11. Because of its great latent heat, water can absorb heat and boil away, so as to lower combustion temperature

    水可以利用自身潛熱大的特點吸收熱量而汽化成為過熱蒸汽，從而降低缸內燃燒溫度。
  12. Our company adopts the metal honeycomb or the metal network board carrier, with special coating coating technology and processing technology, prepare different forms, the all kinds of catalysiseses of specification, used in petrol exhaust. with the characteristic of light in low temp, purification efficiency high and long life etc. main technological schemes as below

    通用汽油機凈化器我公司採用金屬蜂窩或金屬網板載體，通過特殊的塗層塗覆技術及加工工藝，可制備不同形狀規格的各類催化凈化器，用於汽油機的排氣凈化，具有起燃溫度低凈化效率高使用壽命長等特點。
  13. Then, analytical work was carried out as follows : the ultimate analysis and physi - chemical analysis of the pyrolytic oil comprised a sketch of the fuel properties of the oil ; then, through the distillation analysis of the oil, the fraction composition of the " unrefined " oil was known. after that, a general knowledge of the aromaticity and saturation of the hydrocarbons in the oil was provided by the outcome of the ft - ir functional group analysis. also, from the analysis, the form of the polar functional groups and their distribution in different fractions of the oil were learned

    文中首先對不同熱解溫度下熱解油產率進行分析討論，然後，針對熱解油品質進行了一系列分析：通過元素組成和理化特性的分析，對熱解油作為燃料特性有了一個大致了解；通過實沸點蒸餾分析，得到熱解油作為一種未提煉油的餾分分佈，並為后續熱解油餾分的細入分析提供了前提；通過對熱解全油和各窄餾分的ft - ir官能團分析，對熱解油的芳香性、不飽和性有了整體的了解，並且清楚了熱解油中的極性官能團存在型式及其在熱解油不同餾分中的分佈。
  14. The firing time is about 24 hours and the firing temperature is at about 1300c. lighting fireis after finishing the laying bricks for building the kiln entrance. the fuel is pine firewood. the kiln keeper, as a technical director is watching the degree of firing and controlling the change of thekiln temperature and determining the time of stopping fire

    燒窯時間過程約一晝夜，溫度在1300度左右。先砌窯門，點火燒窯，燃料是松柴，把椿工技術指導，測看火候，掌握窯溫變化，決定停火時間。
  15. For the sake of realizing compressive ignition of single fueled natural gas and aiming at the characteristics of high spontaneous combustion temperature of natural gas, the separated combustion chamber provided with low heat radiation structure was designed, meanwhile the heating device for the intake pipe air and the ceramic electro - thermal plug heating device inside the separation chamber were set up

    摘要為實現單一燃料天然氣的壓燃著火，針對天然氣自燃溫度高的特點，設計了具有低散熱結構的分隔式燃燒室，同時設置了進氣管空氣加熱裝置和分隔室內陶瓷電熱塞加熱裝置。
  16. Electrical apparatus for explosive gas atmospheres. part 4 : method of test for ignition temperature

    防爆電氣設備.第4部分:點燃溫度試驗方法
  17. Testing method of ultrafine metal particles for ignition temperature by differential thermal analysis

    用差熱分析法測定超細金屬顆粒的點燃溫度的試驗方法
  18. Electrical apparatus for use in the presence of combustible dust - part 2 : test methods ; section 1 : methods for determining the minimum ignition temperatures of dust

    用於易燃粉塵的電氣設備.第2部分:試驗方法.第1節:測定塵埃最小點燃溫度的方法
  19. This paper analyzes the occurring of land conversion with burning theory, and points out that land conversion is results from population increase, resource endowment, economic development, farmland ' s low comparative economic benefit, unreasonable distribution of framland ' s income, vague land property right, shortsighted activities of local government, the first revolution of urban land use system and rapid urbanization

    論文運用社會燃燒理論分析了農地非農化過程的發生，認為農地非農化是在「燃燒物質」人口增長、資源稟賦、經濟發展， 「助燃劑」農地比較經濟效益低、農地非農化收益分配不合理、土地產權、權能模糊和地方政府的短期行為， 「點火溫度」城市土地使用制度的第一次革命和快速城市化下共同作用的結果。
  20. Heating temperature plays a key role of ignition, otherwise the raw materials cannot be ignited when heating temperature is lower than 400c. there are phenomena that gestation time was shortened, combustion time was lasted, and combustion was accelerated as heating temperature increased

    點火溫度對反應原料是否能夠點燃起決定性的作用，在400以下不能點燃，且隨著點火溫度的升高孕育期縮短，燃燒時間增長，燃燒越劇烈。
分享友人
分享到 Line

分享到臉書