點蝕深度 的英文怎麼說

中文拼音 [diǎnshíshēndù]
點蝕深度 英文
pit depth
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 深 : Ⅰ形容詞1 （從上到下或從外到里的距離大） deep 2 （深奧） difficult; profound 3 （深刻; 深入） thor...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 深度 : 1. （深淺程度） degree of depth; depth 2. （觸及事物本質的程度） profundity; depth
  1. High performance and high precision copper and copper alloy strips, electrolytic copper foil, lead frame, copper clad and printed - circuit board, special enameled copper wire, fashioned copper bar, track contact wire, medium and high elastic copper strips for interconnecting devices, precision alloy copper pipes for ac and cooling appliance, over - long and corrosion - resistant copper alloy condenser pipe, seamless cooper water pipe in housing construction and other copper fine and deep processing products will be highly developed in jiangxi province

    江西將重點發展高性能高精度銅及銅合金板帶、電解銅箔、引線框架、覆銅板及印刷電路板、特種漆包線、異型銅排、軌道接觸線、接插元件用中高彈性銅帶材、空調與製冷精密合金銅管、超長耐腐蝕銅合金冷凝管、建築用無縫銅水管等10項銅精深加工產品。
  2. Aluminum alloy extrusion profiles are welcomed because of their advantages such as lightweight, cutless, rustproof and high strength

    鋁合金型材具有重量輕、無切削、耐腐蝕、強度高等各方面優點，深受歡迎。
  3. The result shows that under the effect of repeated impact load, the stress wave produces reflection in the metallurgical junction plane between coating and basal body, and forms stretch wave causing longitudinal split and angle split of coat ; the microcosmic spot pitting and deep layered peeling off occur in coating surface due to stress concentration ; the energy accumulation of impact loading causes rigidity variation and plastic deformation

    結果表明：在多沖載荷作用下，應力波在塗層和基體的冶金接合面發生反射，形成拉伸波造成塗層的縱裂和角裂；在塗層表面由於應力集中，塗層表面發生微觀點蝕和深層剝落；沖擊載荷能量的積累，造成塗層試樣硬度變化和塑性變形。
  4. The instrument can easily and correctly location, depth of the underground pipes and the exact position of leak points on the insulating anticorrosive coating without digging ground

    本儀器不挖開復土的情況下，方便而準確地查出地下管道的走向、深度和絕緣防腐層的漏蝕點的精確位置，使整個管道表面不再屢遭到處開搪破土之苦。
  5. Seen from the experiment result, it is clear that the deposited coating obtained with the trivalent chromium electrodepositing method we use is smooth, homogeneous, dense, and has good unti - erosive ability, high stiffness. the color ol ihe deposited coaling ol irivalent chromium is similar with that of hexavalent chromium. further more, this process has a good ability of homogeneous and deep depositing with simple facility, high current efficiency, and wide working current flow and even more it avoids environmental pollution

    實驗結果表明，本文採用的三價鉻鍍鉻方法能電鍍出鍍層光滑、均勻、緻密、抗蝕性好、硬度高的鍍層，而且解決了鍍層顏色的問題，使三價鉻鍍層不僅具有現行六價鉻鍍層的天藍色光澤，同時還具有電流效率高、均鍍能力與深鍍能力好、工作電流密度寬、設備簡單、無環境污染等特點。
  6. In this paper, by explored geo - physico - chemical prospecting method for looking for oil in prior prospect, the authors summarize a suit of prospective technique and program, which is valid to oil - geology trait of zhidan area and composed of ; oil gas geo - chemical prospect ( acid degradation of hydrocarbon, absorbed - fluorescent spectrum, ultraviolet radiation spectrum, methane carbon - isotope ) non seismic detection in favorable explorative area which confirmed by chemical prospect ( matural potential, gamma energy spectrum. accurately magnetic analysis ) resistively prospecting in anomalous area which confirmed by physicalprospect successful general evaluation of geo - physicochemical prospect

    通過勘探早期地質物化探綜合找油方法實驗，筆者總結了一套適合志丹探區石油地質特點的勘探方法組合和勘探程序：油氣地球化學勘探（酸解烴、吸附烴、熒光光譜、紫外光譜、甲烷碳同位素、蝕變碳酸巖）化探圈定的有利勘探區進行非地震物探（自然電位、伽瑪能譜、高精度磁測、土壤測氧）物探圈定的異常區進行電阻率測深勘探地質物化探成果綜合評價。
  7. This kind of instability bulk movement is induced by wave cyclic loading, as a result the slope of bottom bed decrease, water depth increase, and instability bulk movement has the character of subregion, regularity and head erosion, thus it will influence evolvement of region of interest landform, and change flow field and bottom stratum condition continually, so will lead to dynamic influence on structure foundation soil

    這種不穩定塊體運動由波浪循環荷載誘發，其結果使底床整體坡度減緩，水深加大，而且不穩定的塊體運動具有小區域、多發性和溯源侵蝕的特點，將繼續影響著海域以後的水深地形的發展演化，並不斷改變著該區的流場與底床地層條件，對構築物地基土的穩定性產生著動態的影響。
  8. ( 2 ) study on the mechanics mechanism of the calamity caused by the cave of the highway : based on the investigation in detail along the line of the highway in shan - gan loess plateau, the distribution law, the classification and characteristic of hazard of highway cave are presented ; the calamity mechanism of highway cave opposite side slope and road bed is discussed, especially the mechanism of collapsing of the hidden cave in road bed. propose " the effect of hidden corrosion ", etc. 10 kinds send to mechanism of collapsing. based on the principle of limit balance, the formula of the critical treating thickness of hidden cave is put forward as follows : according to different stratum, different size and depth, the calculation of the critical thickness of the hidden cave of roadbed has been carried on

    （ 2 ）公路洞穴的致災力學機理研究：在對陜甘黃土高原區公路沿線黃土洞穴詳細調查基礎上，研究了公路洞穴分佈規律、危害分類及致災特點；公路洞穴對邊坡及路基的致災機理，重點是路基暗穴致塌機理，並提出了「潛蝕效應」等十種致塌機制；利用極限平衡原理導出路基暗穴臨界處理厚度計算公式如下：針對不同地區不同地層，對不同尺寸和埋深的暗穴，進行了路基暗穴臨界處理厚度的計算。
  9. From the simulation of peb process, we prove that peb could reduce standing wave effects and improve resist development profile. after analyzing the effects of standing wave effects on resist profiles, we bring forward a certain thickness and these effects could be ignored when resist is beyond that value. finally, the characters of thick resist profile are analyzed, and experiment results are also given

    同時，在論文中還深入討論了抗蝕劑折射率變化對光場計算帶來的誤差；模擬了后烘過程對駐波效應的改善作用，論證了採用適當的后烘工藝改善抗蝕劑光刻質量的作用；分析了駐波效應對厚層抗蝕劑顯影輪廓的影響，提出了一個可以忽略駐波效應影響的抗蝕劑厚度條件值；最後還模擬和分析了厚層抗蝕劑顯影輪廓特點並給出了實驗結果。
  10. In this dissertation, rainfall infiltration, runoff, and soil water redistribution on a hillslope were studied by simulated rainfall experiments, and soil water cycling was investigated by site observation and soil sampling methods. moreover, the reasons for the desiccation of deep soil layer were analyzed, and its assessment indexes and standards were presented. the main results are as follows : ( 1 ) rainfall infiltration into a planar hillslope with a homogeneous isotropic soil could be simply regarded as one - dimensional infiltration process, if soil erosion was prevented

    針對當前該區植被恢復重建中存在的科學問題，以植被建設的關鍵性限制因素?土壤水分為出發點，通過室內外模擬降雨試驗，研究了坡地降雨入滲、產流及土壤水分再分佈規律，同時採用定位觀測和采樣分析相結合的方法，分析了坡地土壤水分的循環與轉化特徵，並初步建立了深層土壤乾燥化程度的評價標準，取得的主要結論如下： （ 1 ）在防止土壤侵蝕的條件下，均質坡地的降雨入滲過程可以簡化為一維。
  11. This paper discusses the statistical rule of maximum corrosive pit depth and determination method of extremum estimation for local corrosion depth, and presents a practical example of calculation

    文章討論了管道最深點蝕孔深度的統計規律以及局部腐蝕深度最大極值估計值的確定方法，並給出了實際算例。
  12. Firstly, the basic character of the remote filed eddy current is simulated and analyzed in case of two - dimension axial symmetry which approves the existence of remote filed eddy current phenomenon ; the full circumferential defect model is investigated to approve the feasibility of using the rfec techniques to detect the position and depth of defect ; the pit corrosion 、 circumferential and axial crack models are simulated, and the defect character based on voltage plane polar plot and the changes of phase and amplitude are analyzed to supply the standard for defect reconfiguration

    首先，在二維軸對稱情況下模擬與分析了遠場渦流的基本特性，證實了遠場渦流現象的存在;對全周向缺陷的遠場渦流檢測進行了詳細研究，證實了遠場渦流檢測缺陷位置和深度的可行性;對點狀腐蝕、軸向與周向裂紋三種非軸對稱缺陷進行三維有限元模擬，利用相位差和幅值變化曲線與電壓平面極坐標圖對缺陷特徵進行分析，為缺陷形狀重構提供了依據。
  13. Through the analysis, it is shown that : 1, while fabricating the grating, the principle of selecting the parameters is : the period should be as large as possible, the etching depth should be small and filling factor should approach to 0. 25. 2, if selecting the parameter combine the selecting principle and the requirement of concrete application, the space of selecting the parameter should be larger than before. 3, while the period to. 4a, the surface profile has no effect on the reflectivity

    通過分析發現： 1 、在製作有一定特性的光柵時，光柵參數的選擇原則為：周期的取值應盡量的大，刻蝕深度的取值應盡量的小，占空比的取值應盡量靠近f = 0 . 25 ； 2 、以參數的選擇原則結合製作的具體應用要求宋選擇光柵的參數，則各個參數的優化空間更大； 3 、當光柵的周期t 0 . 4時，表面面形對反射率沒有影響； 4 、運用臨界周期點隨折射率的變化規律，可以避免由於選擇光柵周期過大而出現一級衍射，從而導致製作失敗。
分享友人
分享到 Line

分享到臉書