齒面寬 的英文怎麼說
中文拼音 [chǐmiànkuān]
齒面寬
英文
face width of tooth-
Flower - heads narrowly campanulate, 16 - 19 mm long, ca. 6 mm across, usually 2 - 4 in terminal clusters ; peduncle 2 - 8 mm ; involucral bracts ca. in 7 series, ribbed on abaxial surface, apex spiny
葉互生,卵形,長3 - 5 . 5厘米,寬2 - 4厘米,先端短尖,基部近截形,邊緣具疏齒,兩面被長柔毛,具基出脈3條;葉柄長3 - 5毫米。Leaves papery, oval in outline, 6 - 7cm long and 8 - 11 cm wide, base rounded or subtruncate, trilobed or sometimes 5 - lobed ; lobes triangular - ovate, rarely ovate - oblong, apex acute or acuminate, margin serrulate, with appressed acute teeth, sometimes entire near base, glabrous or with tufted hairs at vein axils abaxially ; petiole 2 - 3 cm long, glabrous
葉紙質,輪廓闊卵形,長6 - 7厘米,寬8 - 11厘米,基部圓或近截平, 3裂或有時5裂,裂片三角狀卵形,有時卵狀長圓形,頂端漸尖,邊緣有疏而銳利地鋸齒,有時近基部全緣,兩面無毛或下面脈腋有簇毛;葉柄長2 - 3厘米,無毛。Leaves opposite, papery, ovate, suborbicular or elliptic, 4 - 8 cm long, apex rounded, base rounded to broadly cuneate, margin with regular and slightly sinuate teeth except base, covered with yellowish brown tufted appressed hairs ; petioles 0. 6 - 1. 5 cm long
葉對生,紙質,圓卵形、近圓形或橢圓形,長4 - 8厘米,頂端圓形,基部圓形至寬楔形,邊緣除基部外具整齊而稍帶波狀的鋸齒,兩面被黃褐色簇狀短伏毛;葉柄長6 - 15毫米。Leaves leathery, ovate, obovate, elliptic or obovate - elliptic, 4 - 9 cm long and 1 - 4 cm wide, with 3 - 6 obtuse teeth on each side ; abaxially with tufts of hairs at axils of veins ; lateral nerves 7 - 10 pairs
葉革質,卵形、倒卵形至橢圓形或倒卵狀橢圓形,長4 - 9厘米,寬1 - 4厘米,每邊有3 - 6鈍齒,側脈7 - 10對,背面脈腋有小毛叢。Leaves leathery, oblong, 7 - 13 cm long, base cuneate, glossy above, glabrous on both surfaces, margin sparsely and obtusely dentate ; petiole 1 cm long
葉革質,長圓形,長7 - 13厘米,寬2 - 4厘米,先端銳尖,基部楔形,上面發亮,無毛,邊緣有疏鈍齒;葉柄長1厘米。Leaves basal ; petiole up to 3 cm ; leaf blade elliptic, 2 - 3 cm long and 1. 1 - 1. 9 cm wide, apex rounded, base cuneate, margin serrulate, white pilose on both surfaces
葉全部基生;葉片橢圓形,長2 - 3厘米,寬1 . 1 - 1 . 9厘米,先端圓形,基部楔形,邊緣具細齒,兩面被白色柔毛;葉柄長可達3厘米。Leaves tufted ; stipes stout, up to 1. 2 m long, densely covered with golden brown hairs at base ; lamina up to 2 m long and 1 m wide, tripinnatifid ; pinnae alternate, sparsely spaced ; pinnules linear - lanceolate, to 15 cm long and 1 - 2. 5 cm wide, short - stipitate ; ultimate lobes linear, more or less falcate, shallowly serrate, dark green and shining above, light green to glaucous below
葉簇生;葉柄粗壯,長可達1 . 2米,基部亦密被金黃褐色毛;葉片長可達2米,寬達1米,三回羽狀分裂;羽片互生,疏離;小羽片線狀披針形,長達15厘米,寬1 - 2 . 5厘米,具短柄;末回裂片線形,略呈鐮狀,邊緣有淺鋸齒,上面深綠色,有光澤,下麵灰白色。The beyond is the simple notation of serial number of pricker, totaled 7 digits of codes, in which the first digit represents the diameter of needle - bar of pricker, the second digit represents the siding of triangle side on functional section of pricker, the third digit represent the length of functional section of pricker, whereas in standard notation, it represents the distance from needlepoint to gradual deflating small port ( lower port ), the fourth digit represents the total length of pricker, which is the distance from the inside of bending helve to the needlepoint, the fifth digit represents the total quantity of dents on the cording of functional section, and the sixth digit represents the model of barb on functional section, while the seventh digit represents the distance between barbs on functional section
以上為刺針編號的簡單寫法,共7位代碼,第一位是刺針針桿的直徑;第二位是刺針工作段三角面的邊寬;第三位是刺針工作段的長度,同標準寫法所不一樣的是針尖到漸縮錐小口(下口)的距離;第四位是刺針的總長度,按彎柄內側至針尖的距離;第五位是工作段棱上的總齒數;第六位是工作段上鉤刺的型號;第七位是工作段上鉤刺與鉤刺之間的距離。Therefore, these canines must stand far apart and be of good length so that the front surface of the muzzle is broad and squarish and, when viewed from the side, shows moderate layback
所以下犬齒必須有足夠的長度,而且彼此間有足夠的距離,以形成口吻前部的曲面,從側面觀察顯得有點方、有點寬、還有點向後。Secondly, this article studies the static working state of the labyrinth seals in steady flow, including the cavity the relative thickness between gear the proportion of cavity depth to cavity width various gears the level angle of gear the influences of helical gear angle and it ' s flowing direction
2 、研究迷宮密封在定常流動下的靜態工作特性,其中主要包括空腔數、齒間相對厚度、間隙與空腔寬度之比、空腔深寬之比、不同齒形、齒面傾斜角、斜齒傾角和流向等的影響。It was shown that when the soil pressure on the stepped rsrw was relatively small, its distribution form was zigzag, and would be affected evidently by unloading function of the step ; the potential fracture surface of the stepped rsrw was obviously different from the 0. 3h fracture surface proposed by the usual hypothesis, and would change with height - width ratio of the wall ; finally, its deformation characteristics were different from the vertical rsrw with single step
測試表明:臺階式加筋土擋墻的墻後土壓力較小,呈鋸齒形分佈,明顯受臺階卸載的影響;潛在破裂面與0 . 3h破裂面假定有較大差異,並隨擋墻的高寬比變化而變化;變形特徵不同於單級直立式擋墻。分享友人