adhesive interface 中文意思是什麼

adhesive interface 解釋
粘合界面
  • adhesive : adj. 黏附性的,膠黏的。n. 膠合劑,黏合劑。adv. -ly ,-ness n.
  • interface : n. 分界面,兩個獨立體系的相交處。vt. (-faced, -facing) 把界面縫合。vi. 交流,交談。
  1. The fem analysis for the three structures of sling screw - thread - based, namely the circle, rectangle and that with strengthen plate, and the tensile test for sling screw - thread - based in torpedo body show, that the bonding with strengthen frp plate between load - bearing metal parts and frp hull with hatch can reduce the stress concentration and significantly decline the local stress in frp hull with hatch. this structure can also be used in the similar produces. ( 3 ) the effects of parameters for bonding process on the adhesive strength and leakproof are discussed, such as the bonding interface reduce, bonding surface treatment, match of adhesive surface, protect for adhesive seam and so on

    本文通過某型號雷體吊耳螺紋座結構的三種方案,即圓形昂耳螺紋座、長方形吊耳螺紋座、具有增強板的吊耳螺紋座的有限元分析及雷體吊耳螺紋座拉力試驗結果證明:金屬承力件與開口玻璃鋼殼體粘接採用玻璃鋼增強板補強,緩和了應力集中,使開口殼體局部應力明顯降低,類似的水下兵器用金屬承力件與開口復合材料殼體膠接均可採用此種結構形式。
  2. If the surfaces of baso4 particles were not modified with couplant, the interface was clear with a very small adhesive force ; while the surfaces modified, the interface was fuzzy with a strong adhesive force. the glass transition temperature ( tg ) of baso4 / tpu blend was obtained by dma

    當baso _ 4表面未用偶聯劑處理時, baso _ 4 / tpu共混體系相界面清晰,界面粘合力較小;當baso _ 4表面用偶聯劑處理后, baso _ 4 / tpu共混體系相界面模糊,界面粘合力強。
  3. Used for the rendering on both internal and external walls ; decoration plate and brick adhesive ; leveling by cement or gypsum ; also can be used as the bonding agent or interface treatment agent. it can be made into fine stone concrete used for structure enforcement and repair engineering too

    用於內外墻抹灰、飾面磚板粘貼、水泥或石膏膩子批刮,並可作為粘接劑、界面劑使用,也可配製成細石混凝土用於結構加固和維修工程。
  4. Delamination occurred when the liquid and gas phases of water coexist in micro - holes at chip / underfill interface. the adhesive strength between underfill and chip would be reduced due to the absorbed water molecules, resulting in extension and linkage of these micro - holes to form the delamination

    認為在一定的水汽濃度下,器件內部塑封材中國科學院上海微系統與信啟、技術研究所博十學位論文料在界面處的微孔洞可能出現氣液兩相共存。
  5. ( 2 ) it is found that distilled water as lubricant can markedly reduce the accumulation of friction heat and temperature rise on the frictional surfaces of polymer. so the heat fatigue and adhesive wear decrease. moreover, a lubricating film forms on the interface between the counterpart and polymer when distilled water acts as polar lubricant

    ( 2 )潤滑劑水的存在,可大幅度降低聚合物磨損表面的摩擦熱積累及溫升,從而減少了基體的熱疲勞磨損和粘著磨損,同時,水作為一種極性潤滑劑,在摩擦界面上能形成一層潤滑膜,對摩擦表面起了一定的隔離作用。
  6. Study of the fracture process zone of adhesive interface of new and old concrete

    新老混凝土粘結面斷裂損傷過程區研究
  7. With a change of stencil and perhaps an adaptation to the enclosed print head, a stencil printer may be used as needed to deposit solder paste, adhesive, flux, encapsulants or thermal interface materials

    鋼網改變和調整至閉合印刷頭,鋼網印刷機用作錫膏印刷,紅膠水印刷,松香,密封劑或其他的熱表面材料。
  8. In the situation of same roughness interface, compared the shear strength of specimens with mechanical joint element and that of without ; compared the shear strength of specimens with adhesive agent and without adhesive agent when there were mechanical joint element in the specimens. compared the shear strength of specimens that was made of young and old concrete and which was monolithic

    對比相同界面粗糙程度下,機械連接件對抗剪強度的影響;對比在加機械連接件的試塊中,界面劑? ?水泥膨漿的影響;對比各新舊結合試塊抗剪強度與整體伴隨試塊抗剪強度的差別。
  9. This was due to three reasons : ( 1 ) baso4 particles were rigid inorganic particles, which could hinder the retraction of polymer molecules and decreased the elasticity. ( 2 ) a bad compatibility between baso4 and tpu, small interface adhesive force and the phase interface ready to separate. ( 3 ) during high content of baso4, the tenacity of filament mainly depended on tpu, so that the strength decreased with the content of tpu in filament down

    這是因為: baso _ 4屬于剛性粒子,阻礙tpu大分子鏈的回縮,降低了纖維的彈性; baso _ 4與tpu相容性極差,共混時容易形成相界面,界面結合力小,受外力作用時相與相間容易發生分離,使纖維的力學性能下降; baso _ 4在高含量下,纖維強度主要由聚合物的力學性能決定,隨著baso4含量的增加, tpu所佔比例下降,從而在宏觀上表現出纖維的力學性能下降。
  10. In this paper, the reflection method of ultrasonic longitudinal wave and that of ultrasonic shear wave to test the bonding quality of the adhesive interface between steel and concrete from single - surface is adopted respectively

    因此,找到一種合理的無損檢測方法來判斷鋼-混凝土粘結質量具有重要的工程意義和實用價值。本文分別採用超聲縱波和橫波反射的方法來單面檢測鋼-混凝土界面粘結質量。
分享友人