air flow-back 中文意思是什麼

air flow-back 解釋
反風
  • air : n 1 空氣，大氣。2 天空，空中。3 微風，和風。4 態度，樣子，風度，氣派；〈pl 〉高傲的架子。5 傳播，...
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • back : n 1 背，背部；背脊；背面，反面；背後，後部，後面，裏面。2 （指）甲；（刀）背；（手）背；（書）背...
  1. A slot was cut in the back plate of the double - foil shield to improve the flow field with air diversion method. the flow field and droplets trajectory near the shield are simulated in wind tunnel by fluent software to analyze the wake flow affecting the spray drift. from simulation, the improved shield spray in reducing drift is better than double - foil shield spray and conventional spray in six types of wind velocity

    本文採用導流法在雙圓弧罩蓋上開口，利用fluent模擬分析和比較罩蓋噴霧流場，並模擬該流場下的霧滴運動軌跡來分析霧滴的飄失性，模擬結果表明：結構改進后的罩蓋噴霧流場得到改善，其減少霧滴飄失的效果好於原罩蓋，更優于常規無罩蓋噴霧。
  2. The paper analyzes the non - lineal relations of the quantity of heat exchange and water flux of coil exchanger in part - load operating condition, the shortage of deciding the water flux in bypass pipe, the disadvantage that the operating condition of pumps and chiller ca n ' t be met with the load change of the air conditioning system in different operating condition of using pressure - difference bypassing control in primary water pump system. using load control method in the change of the operating condition of primary water pump system can realize that the load change is small and reasonable in the on / off condition of pumps and m m chiller by comparing load control method in primary variable - flow water pump system with pressure - difference bypassing control method, back water temperature control method

    本論文從目前空調工程中使用的變流量水系統入手，研究了盤管換熱器在部分負荷下水流量與換熱量的非線性關系，分析了文獻中介紹的旁通管通流能力選擇的不足之處和一次泵水系統採用壓差旁通控制時，工況轉換不能滿足系統控制要求的缺陷；比較了一次泵變流量水系統中壓差旁通控製法、回水溫度控製法、負荷控製法的精確性，並得出了在一次泵水系統的工況轉換時，採用負荷控製法能使冷水機組及其相應水泵在啟停時的負荷變化范圍較小，更符合建築物的冷量需求，節能效果較好的結論。
  3. Variations in pressure with and without aeration in cavitation region are measured and the compressible characteristics of pressure waveforms and relation between mach number and compression ratio are analyzed ; the time - averaged pressure profiles of different air concentration in cavitation erosion region are measured, the variations of the pressure with air concentration and effects of back pressure on cavitation erosion are analyzed ; the relations between least air concentration to prevent cavitation erosion and flow velocity are proposed ; the cavitation numbers with and without aeration in cavitation region are compared

    實測了空化區摻氣前後壓力的變化，分析了壓力波形的可壓縮流特徵以及馬赫數與壓縮比的關系；實測了空蝕區不同摻氣濃度的時均壓力分佈，分析了壓力隨摻氣濃度的變化及背壓對空蝕的影響；提出減免空蝕的最低摻氣濃度與流速的關系，比較了摻氣前後水流的空化數。
  4. There will appear a very uneven flow field, and appear a very big velocity magnitude distribution and ash concentration distribution near back wall. thus, the velocity magnitude is far bigger than that of optimal design velocity magnitude, which will lead to serious wear and tear in metal face of heater. especially, because of curve structure in front of heat pipe air preheater, there is more serious wear and tear

    由於靠近豎井后墻面的煙氣流速很大，飛灰濃度也較大，斷面速度分佈的最大速度大於最佳設計速度的2 - 3倍，這樣將造成受熱面的嚴重磨損，特別是熱管空氣預熱器前端煙道的幾何結構有一定的轉角，更增加了磨損的程度。
分享友人
分享到 Line

分享到臉書