air radiator 中文意思是什麼

air radiator 解釋
空氣散熱器
  • air : n 1 空氣，大氣。2 天空，空中。3 微風，和風。4 態度，樣子，風度，氣派；〈pl 〉高傲的架子。5 傳播，...
  • radiator : n. 1. 輻射體，輻射器，放熱物。2. 散熱器，暖氣管；（汽車引擎的）水箱，冷卻器；【電學】輻射暖房裝置；【無線電】發射天線。
  1. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  2. The condensed water separated from the air - conditioning system of an airplane is sprayed in the cold side of the radiator, and the heat transfer and the state change of water in the process of its spraying to the ram air are analyzed

    摘要將飛機空調系統中水分離器分離出的游離水噴到散熱器的冷邊，並對水噴到沖壓空氣中的狀態變化過程和傳熱過程進行分析和計算。
  3. Pmv and the indoor temperature field can be used to evaluate the effect of heating in a large amount air current condition. the result of analysis indicate that the radiation heating and radiator heating have some advantages in such rooms, and hot - air heating is an unsuitable way for room heating

    分析結果后認為， pmv和室內溫度分佈是評價大換氣量房間不同供暖方式室內熱環境的重要參數，在這類房間中，輻射供暖和散熱器供暖將各有優點，而熱風供暖則是一種不宜採用的供暖方式。
  4. Analysis of fracture of air radiator clip steel tape

    飛機空氣散熱器卡箍鋼帶斷裂分析
  5. Our main products are plate heat exchanger, unit heat exchanger, spiral heat exchanger, displacement heat exchanger, air radiator, welded plate heat exchanger, shell and tube heat exchanger, heat exchange boiler, etc

    公司主要產品有板式換熱器、換熱機組、螺旋板式換熱器、容積式換熱器、空氣散熱器、釬焊板式換熱器、全焊板式換熱器、列管式換熱器、全自動換熱開水器等設備。
  6. Air pressure drop and heat transfer performance for the automotive radiator

    管帶式汽車散熱器流動阻力與傳熱性能分析
  7. Thirdly, radiator performance test - bed thermal system control modeling and rule self - organizing fuzzy control simulation were studied. the water supply temperature, radiator inlet temperature, test room temperature based on water temperature regulation, air supply average temperature and test room temperature based on air temperature regulation total five controlled processes transfer function were set. finally, rule self - organizing fuzzy control simulation for two

    通過試驗，辨識了散熱器實驗臺熱工系統中供水溫度、散熱器進水溫度、基於熱水系統調節的測試室溫度、送風平均溫度及基於送風系統調節的測試室溫度共5個被控過程的傳遞函數，並對基於熱水系統調節和基於送風系統調節的測試室溫度響應過程進行了規則自組織模糊控制模擬。
  8. Silvery white, powder spraying aluminum alloy, doors and windows aluminum shaped materials, four rush pith stick shaped materials, cold storage reveal cupboard shaped materials, radiator shaped materials air conditioner, solar energy, furniture, carpentry machinery and so on, various kinds of aluminum shaped materials

    各種系列銀白色、靜電噴塗鋁合金、鋁合金門窗型材，裝飾材料、酒類包裝型材、純鋁型材、電信四芯棒型材、冷藏展示櫃傢具、木工機械等各種工業型材。
  9. 9 when there is some air in water heater, it will affect the water temperature, please release gas from decontamination devices and radiator

    9當過水熱內有空氣時，將影響出水溫度，請通過除污器放氣或散熱器放氣口放氣
  10. For example, heating of the air could be a duct mounted hot water coil, duct mounted electric elements, duct mounted gas fired burner, reverse cycle air conditioning unit, room mounted panel radiator etc

    例如，空氣加熱的方式有：通過熱水盤管風管送風，電加熱風管送風，燃油鍋爐取暖風管送風，製冷逆循環機組制熱，地板輻射採暖，等等。
  11. Main products c. v. joint, radiator, air hanging and processing center etc

    主要生產：汽車組合開關暖風機散熱器等速萬向節空氣懸掛摩托車套鎖
  12. Compared the heating load ( and energy consumption ) of a same room with floor heating or radiator heating under same operative temperature. revealed the energy consumption of floor heating room could reduce 5 % ~ 10 % to radiator heating, and the heating load could reduce 10 % ~ 15 %. the main season of energy efficiency is due to no apparent high temperature zone in floor heating room, which avoid additional heat loss in outside envelopes, rather than the lower of indoor air temperature

    利用對連續供暖房間溫度場的研究結果，對分別採用上述兩種供暖方式的典型房間的熱負荷和能耗進行了全面分析后發現：低溫地板輻射供暖房間熱負荷比散熱器供暖房間可降低10 15 ，能耗可降低5 10 ；低溫地板輻射供暖房間節能的主要原因並不是由於房間空氣溫度可以降低，而是消除了室內空氣局部高溫區，避免了由此產生的在外圍護上的附加傳熱量。
  13. Set up a mathematical model for indoor thermal environment on the base of analyzing enclosure heat gain and heat loss of each envelope. programs were developed for floor heating and radiator heating respectively. due on higher surface temperature ( or mrt ) in the same room, the calculation results shown the indoor mean air temperature of heating radiator room was 1 ~ 1. 3 c higher than floor heating room under operative temperature same

    對連續供暖房間的熱過程進行了分析，根據房間熱過程數學模型編程計算結果顯示：由於散熱器供暖房間各圍護結構內表面對人體的平均輻射溫度低於低溫地板輻射供暖房間，要達到相同的作用溫度，散熱器供暖室內空氣溫度應比低溫地板輻射供暖房間高1 . 0 1 . 3 。
  14. Rapid warm - up is one of the characteristics of air - cooled engine, since they do not have heat water in cylinder jackets and radiator

    快熱是風冷發動機的特性，因為它們沒有熱水在水套和散熱器里。
  15. The process of indoor air turbulent flow and heating transfer were analyzed in the typical closed room with floor heating room and radiator heating room respectively

    利用phoenics3 . 3商品軟體中的低雷諾數k -模型對封閉房間室內空氣溫度場進行了模擬。
  16. On the vehicles concerned, there may be some contact between the air filter assembly and the engine cooling radiator outlet pipe

    對于在涉及的車輛，發動機水箱出水管與空氣濾清器總成之間會接觸。
  17. The low re k - model in software phoenics3. 3 were applied to simulating indoor air temperature field in this two kinds of heating room contrastively. it shown that temperature gradient at human altitude in floor heating room is lower 3 ~ 4 c than radiator heating room, temperature adjacent out wall and out window near by radiator is higher 6 ~ 7 c than mean indoor temperature, temperature different of room top with mean indoor temperature in top floor radiator heating room is higher 1 ~ 2 c and thickness is 0. 3 ~ 0. 5m thicker than floor heating room

    結果顯示：在人員活動高度區域內，低溫地板輻射供暖房間的室內空氣豎向溫度梯度比散熱器供暖房間小3 4 ；在散熱器供暖房間內，靠近散熱器的外墻附近和散熱器上部的外窗附近空氣溫度高於室內平均空氣溫度6 7 ；在頂層房間，散熱器供暖房間頂部溫度與房間平均溫度之差比低溫地板輻射供暖房間高1 2 ，高溫區厚度比低溫地板輻射供暖大0 . 3 0 . 5m 。
分享友人
分享到 Line

分享到臉書