ambient temperature range 中文意思是什麼

ambient temperature range 解釋
環境溫度范圍
  • ambient : adj. 包圍著的,周圍的。 ambient temperature 室溫。
  • temperature : n. 1. 溫度,氣溫。2. 體溫。3. 〈口語〉發燒,高燒。
  • range : vt 1 排列;整理(頭發等)。2 使歸類[班、行、隊];把…分類。3 〈用被動形或反身形〉加入,站住…的一邊...
  1. The conclusions are reported as following : the structure change of triuranium octaoxide ( u3o8 ) was studied by xrd at ambient atmosphere at temperature form 25 to 850. there are two kind of phases of u3o8 in the temperature range studied, and the transformation temperature is about 300. the low temperature phase is orthorhombic with space group amm2, and it change to another phase with better symmetry around 300

    主要的研究結果如下:對u _ 3o _ 8的相變和結構隨溫度的變化進行的分析研究結果顯示:在300附近u _ 3o _ 8發生了相變,由底心正交結構(空間群為amm2 )的低溫相轉變為簡單六方結構(空間群為p - 62m )的高溫相。
  2. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程,從鋪裝層環境溫度變化范圍、交通量等使用條件出發,在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上,提出了(即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma )的高性能鋼橋面sma鋪裝體系,並對這種sma的組成材料,包括改性瀝青、集料、礦粉、纖維進行了比較研究,設計了這種sma的配合比,對sma混合料的性能進行了對比試驗,對這種sma方案進行了疲勞性能研究,驗證了所選擇sma方案的可行性。
  3. Range of ambient temperature in which the force transducer may be operated with the acceptance of greater error limits, without the error limits being exceeded on subsequent use of the transducer within the nominal temperature range

    在標準溫度范圍內,不超過最大誤差范圍,也不超過后續操作的誤差范圍的情況下,力轉換器工作的環境溫度的范圍。
  4. Based on the theories of gear engagement, contact analysis, friction and heat transfer, a three - dimensional finite element model of gear tooth was established to investigate temperature distributions and variations along the contact path over a range of applied loads and operating speeds with consideration of lubrication conditions. sensitivity analysis of surface temperature to gear configuration, frictional heat flux, heat transfer coefficients, and oil and ambient temperature was conducted and the major parameters influencing surface temperature were evaluated

    本文基於齒輪嚙合原理、輪齒接觸分析、摩擦學和傳熱學,以有限元分析方法和理論分析計算相結合為手段並以實驗測量結果作為參考,建立了適用於工業應用並具有較高計算精度的高速齒輪傳動輪齒溫度分析的模型和方法,系統地分析了輪齒本體溫度的大小和分佈以及齒輪幾何、載荷及轉速和潤滑冷卻條件等對輪齒本體溫度的影響。
  5. Ambient temperature range

    環境溫度范圍
  6. The recharging device if provided shall provide the rated charge performance specified by the battery manufacturer to charge the battery within 24 h over the rated ambient temperature range and when operating at voltages within the range of 0. 9times the rated operating voltage ( range ) and 1. 06times the rated operating voltage ( range )

    當工作在電壓為額定電源電壓的0 . 9倍到1 . 06倍范圍內,在超過額定環境溫度范圍時電池充電器應能達到由電池生產廠家規定的對電池24小時充電的規定的電性能。
  7. Ambient temperature range in which the force transducer may be stored free of mechanical or electrical loading, without the error limits being exceeded on subsequent use of the transducer within the nominal temperature range

    力傳感器不受機械或電荷載時,在標準溫度范圍內,傳感器在後續使用中不超出誤差標準的情況下的儲藏環境溫度。
  8. Change in force transducer s zero signal referred to the characteristic value, as a result of a change in ambient temperature by 10 k within a defined temperature range after adjustment of stationary states

    每10k零點信號的溫度影響穩態調節以後,規定溫度范圍內周圍溫度變化10k時力傳感器根據特徵值的零點信號產生的變化。
  9. 1. capacitor installation is sorted into indoor and outdoor type. the ambient temperature range for capacitor installation and operation : - 40 b. there should be no corrosive gas, steam, conductive explosive dust and strong vibration exist at installation site

    1 .裝置分為戶內櫃式和戶外框架式,環境空氣溫度類別- 40 b安裝使用場所應無導電性或爆炸性塵埃應不含對金屬有嚴重腐蝕的氣體及蒸汽應無劇烈機械震動。
  10. Charge batteries within an ambient temperature range of 0c to 40c. charging current : above 0. 1c, control conditions time, voltage, temperature, etc. shall be carefully selected

    超過0 . 1c的充電電流,要選擇合適的控制條件如時間- v溫度,否則嚴重的過充會對電池性能造成損害
  11. Ambient temperature range in which the force transducer adheres to the error limits of the temperature - dependent technical specifications

    力傳感器保持溫度技術規范的測量誤差時周圍溫度的范圍。
  12. Service condition : the product can be used in indoor, outdoor, plateau, humid and hot, dirty locations with ambient temperature range from - 40 to + 50

    正常使用條件:產品可在戶內、戶外、高原、濕熱及污穢等場所、 - 40到+ 50內不同溫度范圍的環境下使用。
  13. Relative change in the characteristic value of the force transducer as a result of a change in ambient temperature by 10 k within a defined temperature range after adjustment of stationary states

    穩態調節以後,當周圍溫度在規定溫度范圍內變化10k時,力轉換器的特徵值的相應變化。
分享友人