ambient test 中文意思是什麼

ambient test 解釋
周圍環境下試驗
  • ambient : adj. 包圍著的，周圍的。 ambient temperature 室溫。
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. Standard test method for monotonic compressive strength of advanced ceramics at ambient temperature

    室溫下高級陶瓷持久抗壓強度的標準試驗方法
  2. Spherulites dimension also decreases due to the chemical changes occurred during pan - milling. viscosity test shows that chain scission occurred during pan - milling, which caused slight reduction of mechanical properties. polypropylene / polyamide 6 ( pp / pa6 ) ultra - fine powder was prepared through pan - milling at ambient temperature

    通過磨盤碾磨在常溫下制備了聚丙烯/尼龍6 （ pp / pa6 ）超細復合粉體，其粒徑可通過碾磨時間、磨盤轉速、磨面靜壓力、碾磨溫度等工藝參數控s摘要一制。
  3. Standard test method for monotonic compressive strength testing of continuous fiber - reinforced advanced ceramics with solid rectangular cross - section test specimens at ambient temperatures

    室溫下帶實心矩形截面試樣的連續纖維增強高級陶瓷的單值抗壓強度試驗的標準試驗方法
  4. Advanced technical ceramics. ceramic composites. methods of test for reinforcements. determination of distribution of tensile strength and tensile strain to failure of filaments within a multifilament tow at ambient temperature

    高技術陶瓷.陶瓷成分.增強的試驗方法.環境溫度下多纖維牽引內纖維斷裂拉伸強度和拉伸應變分配的測定
  5. Advanced technical ceramics - ceramic composites - methods of test for reinforcements - determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature

    高級工業陶瓷.陶瓷復合材料.增強纖維的試驗方法.室溫下復絲束中長絲斷開時的拉伸強度和拉伸應變分佈的測定
  6. Advanced technical ceramics - ceramic composites - methods of test for reinforcements - part 5 : determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature

    先進工藝陶瓷.陶瓷復合材料.增強纖維的試驗方法.第5部分:周圍溫度下復絲束中長絲拉伸強度的分佈和斷裂拉伸應變的測定
  7. Ambient air quality - diffusive samplers for the determination of concentrations of gases and vapours - requirements and test methods - general requirements

    環境空氣質量.測定氣體和蒸汽濃縮度的擴散樣品.要求和試驗方法.一般要求
  8. Ambient air quality - diffusive samplers for the determination of concentrations of gases and vapours - requirements and test methods - specific requirements and test methods

    環境空氣質量.測定氣體和蒸汽濃縮度的擴散樣品.要求和試驗方法.特殊要求和試驗方法
  9. Textile floor coverings - burning behavior - tablet test at ambient temperature

    鋪地紡織品燃燒性能在室溫下片劑試驗
  10. Test method for evaluating resistance to tracking and erosion of electrical insulating materials used under severe ambient conditions

    在嚴酷的大氣環境下使用的電絕緣材料耐漏電起痕蝕損的評價的試驗方法
  11. Maximum permissible ambient noise levels for audiometric test rooms

    試聽室最大可允許的環境噪聲等級
  12. Mechanical test at ambient temperature for high - voltage switchgear

    高壓開關設備常溫下的機械試驗
  13. The test research continuous two years, carry out land membrane cover, the ambient conditions that can improve garlic growth growth, raises winter spring soil temperature, maintenance has moist soil, loose, reduce moisture to evaporate run off, it is good to promote garlic to make sprout early, growth better, and take out moss early, raise output and quality, promote garlic to increase production and receipt

    摘要經過連續兩年的試驗研究，實行地膜覆蓋，可以改善大蒜生長發育的環境條件，提高冬春季土壤溫度，保持土壤濕潤、疏鬆，減少水分蒸發流失，可以促進大蒜早出苗、齊苗、長勢好、早抽苔，提高產量和質量，促進大蒜增產增收。
  14. Standard test method for determining ignition sensitivity of materials to mechanical impact in ambient liquid oxygen and pressurized liquid and gaseous oxygen environments

    在環境液態氧和加壓液態或氣態氧環境中測定材料對機械沖擊著火敏感性的試驗方法
  15. Standard test method for stability of water - in - oil emulsions under low to ambient temperature cycling conditions

    在低溫至室溫循環條件下油包水乳劑穩定性的標準試驗方法
  16. 05. 02 stability of water - in - oil emulsions under low to ambient temperature cycling conditions, test method for

    低於室溫循環條件下的油中含水乳液的穩定性的試驗方法
  17. Surface active agents - test method for stability of water - in - oil emulsion - part 2 : determination of storage stability of water - in - oil emulsion - low to ambient temperature cycling method

    表面活性劑油包水乳液穩定性試驗方法第2部分:油包水乳液貯藏穩定性的測定低溫至室溫循環法
  18. Test a : porcelain crucible ? a porcelain crucible was heated to a dull red color, placed on the test material, and allowed to cool to ambient temperature

    測試a ：陶瓷坩堝。將置於所測試材料表面的陶瓷坩堝，加熱至暗紅色然後讓其冷卻，溫度降至室溫。
  19. Plastics - determination of burning behaviour by oxygen index - ambient - temperature test

    塑料.通過氧指數測定其燃燒性.室溫試驗
  20. Plastics - determination of burning behaviour by oxygen index - part 2 : ambient - temperature test

    塑料.用氧指數測定其燃燒性.第2部分:室溫試驗
分享友人
分享到 Line

分享到臉書