amorphous phase 中文意思是什麼
amorphous phase
解釋
非晶相，無定形相-
Formation of amorphous phase in binary immiscible cu - ta system
體系非晶相的形成 -
The iron doped tio2 thin films showed almost no photocatalytic activity for the photodegradation of no in the gaseous phase when the calcination temperature was lower than 400 c. this was due to the fact that the phase structure of the film was amorphous. at 400 c, the film appeared obviously photoactive du
對于用液相沉積法所制備的tio :薄膜，薄膜中的si （或fe ）含量和薄膜的厚度可通過調節前驅體濃度、溶液的ph值、基片的沉積溫度和沉積時間，薄膜的熱處理溫度和時間進行有效地控制。 -
The unstable solid solution would disintegrate and transform into carbide phases in these systems of sisocso, tisocso and zrsocso, based on the increase of free energy introduced by the effect mechanical alloying. for the system of wsocso, the solid solution had not transformed into tungsten carbides but an amorphous phase, which was different from those systems. the exist of fe in these experiments, which came from the abrasion of ball - milling tool because of the higher hardness of w and w - c solid solution, would induce the crystalline - to - amorphous phase transformation during milling
C50球磨體系中，繼續球磨時，不穩定的固溶體在機械合金化作用下，由於體系能量提高，會發生分解相變，從而可以形成碳化物；對于w扣c50球磨體系， w ? c固溶體具有較高的硬度，磨削不銹鋼質的球磨介質和球磨容器，而引入雜質，其中fe會促使固溶體向非晶相轉變。 -
The inperfect crystal structure and its analysis for materials, is an elective course for the master graduate student, which include the crystallology principle, development of crystal diffraction, crystal determination and computer simulation of new phase, analysis of solid solution and superstructure, correction of crystal structure and bondvalent theory, analysis of inperfect crystal structure, analysis of amorphous structure and so on
材料不完整晶體結構及其分析方法，為材料科學及工程等專業碩士研究生的選修課，內容包括晶體學基礎、晶體衍射技術最新進展、新相晶體結構測定與數值模擬、固溶體與超結構分析、晶體結構修正與價鍵理論、不完整晶體結構分析、非晶結構分析等。 -
Wang yongqian, liao xianbo, ma zhixun, et al. solid - phase crystallization and dopant activation of amorphous silicon films by pulsed rapid thermal annealing [ j ]. applied surface science, 1998 135 : 205
薛清，郁偉中，黃遠明.利用快速退火法從非晶硅薄膜中生長納米硅晶粒[ j ] .物理實驗， 200222 （ 8 ） : 17 -
Aluminum coagulation pretreatment enhances the uf removal of ha and greatly ameliorates the effect of ha on the membrane flux decline. at ph = 7. 0 the mechanism is adsorption of ha on the amorphous solid - phase al ( oh ) _ 3 ( s ), while at ph = 5. 0 the mechanism is charge - neutralization. in terms of the removal of ha ( toc, uv _ ( 254 ) ) and the membrane flux decline, the effect of coagulation under ph = 7. 0 condition turns out to be much better than that under the condition of ph = 5. 0
Ph = 7 . 0條件下的混凝預處理機理主要是鋁鹽高分子水解產物對腐植酸的吸附網捕作用， ph = 5 . 0時的機理主要是帶正電荷低分子鋁鹽水解產物吸附電中和作用，從toc和uv254的去除率以及膜滲透通量的變化情況來看， ph = 7 . 0條件下的混凝預處理優于ph = 5 . 0 。 -
It was revealed that the hexagonal order was destroyed and the phase transition from hexagonal to amorphous structure with the increment of manganese ion, and with the appropriate neutral hexadecylamine ( hda ) with cetyltrimethylammonium bromide ( ctab ) as mixed template, mn - mcm - 41 was synthesized with well uniformly pore size and hexagonal mesostructure for the additional function of n - metal covalent bond, and the ordered structure was mediated by the influence on the packing parameter
表明隨著mn ~ （ 2 + ）引入量的增加，導致介孔長程有序結構的破壞，最終引起由六方相向無定型相的轉變。適量中性表面活性劑十六胺的引入以形成混合模板劑，通過在原有靜電作用基礎上增加n -金屬鍵作用，合成結構較為完整的錳摻雜mcm - 41材料。 -
By increasing the h2 dilution ratio, it is found that atomic hydrogen can selectively etch amorphous phase and stabilize crystalline phase. from the study on the distance from substrate to catalyzer, choosing a proper distance can ensure the gas fully decomposed, while a relatively low substrate temperature can cause the nanocrystalline particles to lose mobility and keep their sizes. the pre - carbonization process can enhance the nucleation density and make the growth of high quality nanocrystalline p - sic films much easier
實驗結果表明：隨著工作氣壓的減小，薄膜的晶粒尺寸有所減小；通過提高氫氣稀釋度，利用原子氫在成膜過程中起的刻蝕作用，可以穩定結晶相併去除雜相；選擇適當的熱絲距離能保證反應氣體充分分解，又使襯底具有較高的過冷度，是形成納米薄膜的重要條件；採用分步碳化法可以提高形核密度，有利於獲得高質量的納米- sic薄膜；襯底施加負偏壓可以明顯提高襯底表面的基團的活性，因負偏壓產生的離子轟擊還能造成高的表面缺陷密度，形成更多的形核位置。 -
And pbo single crystal nanowire was successfully prepared with new method. the results show that the amorphous matrix of the powders almost completely transforms into crystalline perovskite phase after 600 calcinations. the mean grain size in pt / tb powder is about 23nm that is smaller than that of pt powders
鈣鈦礦相的晶軸比c / a比未摻tb的pt粉末低，具有贗立方結構的特性，降低了從立方相向這種四方相轉化的勢壘，從而有效地抑制了較高溫下焦綠石相的產生。 -
The grain size of - fe decreased with increasing milling time, the nd - fe - b alloy powders was composed of amorphous phase nd2fe14b and - fe with average grain size of about 10nm after milling 5 hours
隨球磨時間的延長， nd2fe14b和- fe的晶粒尺寸逐漸變小， nd2fe14b相迅速分解直至消失，基本上轉化為非晶相。 -
The amorphous surface layer of tantalum was obtained by anodic oxidation in melting nitrate after plasma - nitriding at relative low temperature, and the composition, phase structure and property of coating were tested
摘要採用低溫離子滲氮后再熔鹽陽極化的方法，在鉭表面形成厚度達微米數量級的非晶態層，測試了非晶層的成分、相結構和性能。 -
Magnetic properties of nanocrystalline two - phase permanent magnetic alloys by crystallizing from amorphous state
非晶晶化法制備納米晶雙相永磁合金的磁性 -
In this pcm, polyethylene glycol ( peg ) has been taken as functional branches, with which the energy storage and energy release can be proceeded by phase transition between its crystal state and amorphous state
利用聚乙二醇從結晶態到無定形態之間的轉變，實現該材料的儲能和釋能，整個過程中材料始終保持為固體。 -
The results show that titanium oxide films prepared at room temperature consist of amorphous phase of titanium oxides, which can transform to crystal phase mainly consisting of anatase and rutile when they are subjected to appropriate heat treatment
實驗結果表明，本文採用電化學方法制備的氧化鈦膜是一種非晶態膜，對其進行適當的熱處理后，膜的結構主要由銳鈦礦和金紅石組成。 -
The sample is amorphous phase at the thickness 1000 nm, however, its soft magnetic properties gradually become worse. the phenomenon originates mostly from the thermal stress
膜的軟磁性能隨厚度的增加迅速變差，認為是熱應力太大造成的。 -
The amorphous phase is formed from the transformation of super - saturate solid solution, and there is no nuclear formation and grow process
非晶相的形成是通過超過飽和固溶體的失穩轉變而成，不存在形核與核長大過程。 -
Na2o - 8teo2 crystal is stable at temperatures below 330 and will decomposed into two crystalline phase including na2o4teo2 and teo2 at 340 or a higher temperature. the phase diagram of sodium tellurite is modified according to the results obtained. the transformation of na2o - 8teo2 into na2o4teo2 and teo2 includes two steps : na2o - 8teo2 is first transformed into an intermediate amorphous phase and then the intermediate amorphous phase crystallizes to form na2o - 4teo2 and teo2 - the intermediate amorphous phase formed during the transformation is amorphous powder
通過對nt _ 8晶相向nt _ 4和teo _ 2晶相的轉變過程的研究發現，由nt _ 8晶相向nt _ 4和teo _ 2晶相的轉變包括兩個轉變過程，即由nt _ 8晶相向非晶中間相轉變的過程和由非晶中間相向nt _ 4和teo _ 2晶相轉變的過程，在轉變過程中出現的非晶中間相是一種非晶固態粉末。 -
Consisted mainly of amorphous phase. hrem images showed that the ti - dlc film had a lamellar structure. the tic phase with a size of 5 nm was located at the titanium - rich regions surrounded by amorphous carbon structures in the ti - dlc film
Ti - dlc膜的結構主要為非晶相，高分辨電子顯微鏡分析（ hrem ）表明ti - dlc膜成層狀分佈，膜內存在著富ti區和貧ti區， tic顆粒尺寸大約為5nm 。 -
( 5 ) the structures of samples obtained by ball milling were also related with the milling intensity ( power ), which indicated that the lower milling power was in favor of the formation of amorphous phase
（ 5 ）球磨強度的大小對產物的組成也有影響，相對較低的能量有利於非晶相的形成。本實驗中，機械合金化作用下，球磨體系（ sts 。 cs 。 -
With the increase of its thickness, the single film transforms crystal phase into amorphous phase
單層膜隨著厚度的增加呈現非晶態， 1000nm以上為完全非晶態。
分享友人