angle displacement 中文意思是什麼

angle displacement 解釋
角位移
  • angle : n 【英史】盎格魯人〈cf Angles〉。n 1 角，隅，角落；棱，嬗角。2 【數學】角，角位，角的度數。3 【機...
  • displacement : n 1 轉位，移動；取代，置換；（人的）流離失所。2 撤換，免職。3 【機械工程】（活塞）排氣量；【航海...
  1. The brightness temperature is highly related to the density of ice hydrometeor. since the convective cloud system is tilted, and the viewing angle is oblique, the area displacement between ice hydrometeor and the surface rainfall rate makes the relation between tb and surface rainfall rate is relatively small

    但亮溫和地面降水強度之間的相關性較弱，這是由於該對流系統為傾斜的，冰相粒子和地面降水強度之間存在著位置上的不一致，並且觀測角為傾斜的。
  2. Owing to its excellent adaptability to large angle - displacement between two transmission shafts and other characteristics such as large transmission ratio, terse mechanism, high transmission efficiency, cardan cross - pin spindles has been widely used as an important mechanical part in transport machines, metallurgy machines, petrolic machines, heavy machines, etc. as an effective and promising approach to resolve complicated development of modern software, component - based development ( cbd ) is put forward to change the present way of software development by producing software through assembling ready software components and its final target is to realize the industrialization of software development totally

    十字軸式萬向聯軸器能夠很好地適應傳動軸間的較大角位移，而且具有傳遞扭矩范圍大、結構緊湊、傳動效率高、維修保養方便等特點，是一種重要的傳動部件，因此在交通運輸、冶金、重型機械等領域中得到廣泛應用。基於組件的開發是近幾年發展並日益成熟起來的一種軟體開發新方法，其核心思想是以流水線方式、通過組裝組件生產軟體，從而容易實現軟體開發的工業化。
  3. The results show that the internal friction angle of rock has importance affect on the displacement of surrounding rock for deep roadway when in - situ stress and support resistance all are certain

    分析結果表明，在地應力和支護阻力一定時，巖石的內摩擦角對深埋巷道圍巖位移的影響最為明顯。
  4. The measurement of small angle of biprism by displacement method

    離散偶極子近似方法
  5. Rebounding displacement of slope and axial force of anchor bars increases as the increment of the included angle of the rebounding displacement vector and x positive axis will reduce as the increment of horizontal tectonic stresses. the reduction of lithologic characters and weak interplayer have unfavorable influence on stability

    支護錨稈軸力也增大；隨著水平構造應力的增加，回彈位移矢量與水平x軸正方向所形成的角度將減小；邊坡巖體巖性參數的弱化和軟弱央層的存在都對邊坡的穩定造成不利的鍘惻。
  6. Several models of bonded dissimilar materials with interface edges are calculated. displacement, electrical potential, singular stress fields and singular electrical displacement fields near a singular point are deduced by the eigenfuntion expansion method based on the general solution of the spatial axisymmetric problem of the transversely isotropic piezoelectric media. a generally axisymmetric interface edge of bimaterials with arbitrary interface angle and joining angle is analyzed theoretically by using this method

    在此基礎上，對具有任意界面角和結合角的橫觀各向同性雙壓電材料空間軸對稱界面端一般模型的軸對稱變形問題進行了理論分析，給出了該模型界面端的奇異性特徵方程以及界面端附近的位移場、電勢、奇異應力場和奇異電位移場。
  7. Angle displacement measurement

    角位移測量
  8. The main controller is in charge of managing, communicating and the measuring of grating - displacement and angle - displacement. the subcontrollcr is in charge of the measuring of inner diameter of psd, the analog - to - digital converting of the serial a / d and the data processing of dsp

    主控制器完成管理、通信及光柵位移、角位移測量控制功能；子控制器完成psd內徑尺寸檢測、串列a / d模數轉換及數字信號處理器（ dsp ）數據處理功能。
  9. In the case of the unsaturated alcohols, such as hydroxyethyl acrylate ( hea ), the paes showed the photo - alignment property to the nematic liquid crystals with the pretilt angle of 0. 60 ? secondly, three kinds of fluoro - containing diamine monomers were prepared via the reduction reactions of the corresponding dinitro compounds, which were synthesized via the nitro nucleophilic displacement reactions of 3, 5 - dinitro - 5 - trifluoromethyl benzene with diphenol compounds

    此外，本論文還設計並通過3 ， 5 -二硝基三氟甲苯與二酚化合物的硝基親核取代反應制備了二硝基化合物，將其還原最終合成了三種間位取代的含氟二胺單體tfpda 、 tfbpda與tfmda ，並對其聚合行為進行了研究。
  10. The preferences are analyzed, pipe ’ s parameters such as depth, thickness, pipe diameter, and mechanical property of material ; soil parameters such as soil types, internal friction angle, pipe - soil interaction ; fault ’ s parameters such as fault types, fault throw, fault drop, fault - pipe angle, mechanical property of material ; load types such as gravity force, linear displacement load, seismic load and seismic wave. some conclusions are drawn from the calculating results : when buried pipes cross fault, pipe ’ s embedded depth should be shallow, and big pipe diameter and thick wall should be selected. avoid the site where fault moves severe, and select suitable pipe - fault angle

    在有限元三維模型建立中考慮的因素有:管道自身參數如管道埋置深度、管壁厚度、管徑、管道材料等;巖土材料參數如土體類型、巖土的內摩擦角、管土相互作用等;斷層考慮有斷層類型，斷層斷距，斷層錯動距離，斷層與管道的交角，斷層材料的考慮等;荷載分別考慮靜荷載，動荷載，其中動荷載包括線性位移加載、地震力加載和地震波加載等。
  11. During the process of measuring valve phase, the grating displacement sensor and photoelectric axis - angle encoder are applied to measure the displacement of valve and the angle of curving shaft respectively. their signals are sampled and imported into computer. then the three signals are compared to find the relationship of valve phases in order to offer the reliable measuring parameters for the researchers and quality controllers

    在氣門相位測量中，採用光柵位移傳感器和光電軸角編碼器，分別將發動機進、排氣門位移量和曲軸旋轉位移量的變化信號通過采樣，輸入計算機，對三路信號加以比較找出氣門的相位關系，從而為設計開發人員、品質控制人員提供可靠的測量參數。
  12. In the simulation it was found that there was interference when the manipulator moved. it is because the manipulator is controlled by minimum time method. the method has no constraints about angle displacement

    經分析后發現主要是由於採用的控制方法是最小時間控制，造成了機械手各關節的角位移太大，從而產生了干涉。
  13. Based on the experiment of full - sized cshb walls under lateral and vertical loads, initial crack - resisting stiffen formula was deduced by considering the influence of concrete beams, concrete core columns, structural columns, vertical pressure and window ( or door ). the results calculated from the formula were fit well with the experimental results. by the analysis of displacement at initial crazing, probability statistical mode and its parameters of relative displacement angle were presented

    在介紹和總結本課題的室內足尺寸單片墻抗側力性能試驗的基礎上，考慮了圈樑、芯柱、構造柱和墻體正壓力、開門窗洞等因素對抗側剛度的影響，提出了綜合各種因素的初裂抗側剛度公式，與試驗結果具有很好的一致性；結合試驗的初裂位移分析，給出了層間相對位移角的概率統計模式及相應的統計參數，提出了小砌塊建築層間位移角的控制標準。
  14. Four groups ’ measurement data are given based on built system, and the results and the error analysis of measurement range of 1. 5, angle step of 0. 06 is discussed in detail. a list table of fitting curve and angular displacement is given as well

    利用建立的測量系統給出了四組測量數據，詳細討論了測角范圍為1 . 5 、角度遞增0 . 06的測量結果與誤差，並給出標定擬合直線與角位移的查找表。
  15. At the end, the vibration responses are displayed in polar diagram synthetically, in which the displacement, the static offset and the deflection angle of rotor could be shown altogether

    提出用極坐標表徵轉子振動特性的方法，可以更直觀、全面地反映轉子的振動幅度、機動飛行時的靜態偏移以及偏擺角。
  16. This platform can detect geometry ( length, angle ), electricity ( current, voltage ) and mechanism ( shake, speed, acceleration, displacement, pressure ), it can analyze signal and process data too

    即具有對幾何量（長度、角度） 、電量（電流、電壓） 、機械量（振動、速度、加速度、位移、壓力等）的檢測功能，同時具備信號分析與數據處理能力。
  17. Influences of axis inclination, length, clamping angle of anchorage, roughness and bonding degree of interface on the displacement of anchorage and repose stability of rock mass were explored

    就錨碇體軸線傾角、長度、夾持角、接觸界面粗糙度及結合程度對錨碇位移和巖體安息穩定性的影響作了深入探討。
  18. Considering joint clearances at both ends of the coupler, a continuous contact model is developed by modeling clearance as a massless rigid link. a set of strongly nonlinear equations is obtained by using angle displacement of clearances in kinematic pairs as generalized coordinates. four order rong - kutta method is adopted to solve the dynamical equations of continuous contact model

    考慮曲柄與連桿、連桿與滑塊之間運動副間隙，將運動副間隙看成是一無質量的理想桿，利用連續接觸模型進行建模，採用運動副間隙角作為廣義坐標，得出一組強非線性方程組。
  19. Abstract : this paper deals with the simulation result analysis of three phase synchronous generator with rectified output with stator y connected, as well as with stator connected. the curves of overlap angle, displacement angle and power factor with load are presented, and the tendency of these curves are also described

    文摘:對整流負載時凸極同步發電機定子繞組及y聯結模擬結果進行分析，繪出反映整流特性的換流重疊角、位移角以及功率因數隨負載變化曲線，並對變化趨勢進行分析。
  20. As an electromechanical element, which can transform digital electrical pulse signal into mechanical angle displacement, the stepper motor takes the advantage that it can work well in the open loop system, and is widely used in different kinds of control system

    作為一種將數字式脈沖信號轉換成機械角位移的機電執行元件，步進電機的主要優點是能在開環系統中較好地工作，因此，它作為驅動元件廣泛地應用於各種控制系統中。
分享友人
分享到 Line

分享到臉書