axial line 中文意思是什麼
axial line
解釋
軸跡-
This paper simply introduces the device of on - line monitoring for the thrust of the rotating maching, then discu ed the finite dement analyses on the on - line monitoring elastic dement for measuring thrust in detail, in order to develop the performance of the se or and the device, we calculated the distribution of the stre 、 strain 、 axial di lacement in the elastic element using the finite element method when the axial forces f = 3 104n, the result is very satisfied
簡單介紹大型旋轉機組軸向力在線監控裝置，然後詳細介紹軸向力測力彈性元件的有限元分析，為了提高所研製的測力傳感器的性能，採用有限元方法計算了彈性元件在軸向力f = 3 104n時的應變、應力、靈敏度及軸位移等的分佈情況，分析結果表明：所設計的測力傳感器完全符合廠方的要求及儀表性能指標。 -
In the anistropic magnetic medium under the condition of magnetic permeability 11unequal to 33, the magnetic field on axis line of current - carrying coil and that inside current - carrying solenoid can be calculated by applying biot - savart law of that medium. as the condition of their service is restricted, it is necessary to derive the magnetic field on axial line of current - carrying coil and that inside current - carrying solenod under more general condition of 11unequal to 33. on the basis of the magnetic field on axial line of current - carrying coil in anisotropic magnetic medium under the derived condition of 11unequal to 33, the authors obtain the magnetic field on axial line of current - carrying solenoid in anisotropic magnetic medium under general condition of 11unequal to 33. the result shows a wider applicable coverage
利用畢奧-薩伐爾定律，並在磁導率11 = 33的條件下，可求出各向異性磁介質中載流圓線圈軸線上的磁場，以及載流直螺線管內部的磁場.顯然，其使用條件受到限制.為此，有必要導出在11 33的更一般情況下，各向異性磁介質中載流圓線圈軸線上磁場和載流直螺線管內部的磁場.在已導出11 33及各向異性磁介質中載流圓線圈軸線上磁場的基礎上，求出一般情況下各向異性磁介質中載流圓線圈軸線上的磁場，使其結果適用范圍更廣 -
Obtain these chief research achievements. ( 1 ) the method of hydraulic fracturing, kaiser effect experiment and the finite element numerical simulation computation results, the direction of maximum horizontal principal stress intersect the small - angle of tunnel axial line, it is favorable to the stability of tunnel peripheral rock ; according to the test rust of field stress - relief method, at the present time, zhe gu mount tunnel have n ' t access to high crustal stress site, maximum principal stress magnitude is 17mpa ~ 20mpa
主要獲得以下研究成果： （ 1 ）綜合水壓致裂法、室內巖石kaiser效應試驗和有限元數值模擬計算研究成果，最大水平主應力方向與隧道洞軸線小角度相交，對隧道圍巖穩定性有利；根據現場應力解除法測試結果，目前鷓鴣山隧道尚未進入高地應力段，最大主應力量級為17mpa 20mpa 。 -
Combined with the real example of monitoring pressure on the supporting system in the long span underground space of dk7 + 692 section at jiao - xin line of chongqing light railway, it is set forth the methods about choosing the support system and its parameter, digging methods of underground space, measuring and testing methods for the stress of the support system ; the testing results and variation pattern were analyzed for the stress of the initial supporting i - steel axial stress of bolt, stress of shot - concrete, supporting pressure of temporary i - steel and stress of steel of the second lining, then, the reason for deformation of the support system induced by sharp increase of i - steel was determined
摘要結合重慶市輕軌較新線大坪車站大跨度地下空間dk7 + 692斷面施工支護體應力監測的工程實例，闡述了該大跨度地下空間支護結構的參數選擇、地下空間的開挖方法、支護體結構的應力量測方法及測試手段；分析了支護體初期支護工字鋼拱應力、錨桿軸力、噴射混凝土內應力、臨時工字鋼支撐應力、二次襯砌鋼筋應力等測試結果和變化規律；確定了工字鋼拱應力急劇增大而可能引起支護體系失穩的原因。 -
Axial hinge line
軸向脊線 -
A discretization equation is derived by using a finite volume method in three - dimensional cylindrical polar coordinate system. algebraic equations are solved by iteration with a line - by - line method that is a combination of tdma in axial and radial directions, ctdma in tangential direction and adi method in three directions. the pressure and velocity coupling are solved with the simple algorithm
在三維圓柱坐標下，利用有限體積法推導離散方程；在軸向與徑向用三對角矩陣法（ tdma ） ，在周向採用循環三對角矩陣法（ ctdma ） ，採用交替方向亞鬆弛疊代法（ adi ）求解方程；推導同位網格下的壓力修正方程，用simple演算法處理速度與壓力的耦合；為加速收斂，採用適當的鬆弛因子。 -
An axial direction line multi - sensors placed method is presented. in the process of machine learning, use genetic algorithm to fit the curve of sensor ' s output. to improve the convergence speed of genetic algorithm, hill climbing method is joined with
對示教過程中進行曲線擬和所用的遺傳演算法進行了一定的研究，為了解決遺傳演算法在接近收斂點時收斂速度慢的缺點，使用爬山法對其進行改進。 -
Based on the resolving algorithm of continuous - layer method, the time order analyzing curves, acceleration curves and the response spectra of transfer function at the different points of the ground and at the same point on the different ground conditions are gained. it demonstrates that the responses of ground in x, y and z axial directions all change by time, and the obvious wave propagation appears in ground. for different observing points on the same ground condition, at more distant points from the load line, the less swings are found, that is to say, vibration possesses the obvious characteristic of attenuation
基於分層法的解析演算法，得到了在不同點以及在同一點但不同地質條件下的時程分析曲線、加速度變化曲線和傳遞函數反應譜，結果表明，地基土在x 、 y 、 z三個方向的響應都是隨時間變化的，並且伴隨有明顯的波動現象產生；對于相同地質條件的不同觀察點，距離荷載作用線越遠的地方振幅越小，即振動具有明顯的衰減性。 -
The temperature and stress field of wagon wheel under the condition of long ramp way cycle braking in daqin line have been simulated by using fem and axial symmetry model results indicate that high stress area appears on the wheel web, and the strength of wheel meets the requirement of routine operation under current braking condition
摘要採用軸對稱模型和有限元方法，模擬了大秦線長大坡道循環制動條件下貨車車輪溫度和應力場，結果表明車輪高應力區出現在輻板上，現行制動條件下車輪強度滿足使用要求。 -
These springs are now eliminated and replaced by an axial non - me - tallic thrust located in the center - line of the gearing to avoid any friction that would generate wear, vibration and noise
在本系列產品中，這些彈簧已經取消，並由位於齒輪中心上的非金屬材質的軸向止推裝置所取代，避免了會導致磨損、振動和噪聲的任何磨擦現象。 -
On the basis of experiments the axial vortex in pump system is analyzed and calculated, the vortex line formulas of planar, cylindrical and axial vortexes are given, and their vortex lines aregraphed
在試驗研究的基礎上，對泵系統軸向渦流進行了分析計算，給出了平面渦流、柱面渦流和軸向渦流的渦線計算公式，並繪出了它們的渦線。 -
On the basis of the experiment, this thesis furthered the research on vortex in the inlet side of the pump system with the method of numerical calculation, and offered its axial vortex line, and contrasted this line with the diagrammatized vortex line
本文在實驗基礎上，通過數值計算方法對泵入口側渦量場作了進一步研究，繪出了泵入口側渦量場地軸向渦線，並與圖解法繪制地渦線進行了對比。 -
The pore air pressure gradually goes up with the developing of axial strain in the process of the dynamic torsional shear test of loess, but the pore water pressure hold the line or goes up a little in the last. the stress - strain dynamic constitutive relationship of intact loess and man - made loess show the hyperbolic model. there are some remarkable differences of strength and strain between unsaturated loess and saturated loess
研究結果表明：非飽和黃土在動力扭剪試驗過程中，隨著軸向變形的發展，孔隙氣壓力逐漸上升，而孔隙水壓力則基本保持不變或後期略有升高；原狀黃土和重塑黃土的應力應變本構關系呈雙曲線型；非飽和黃土和飽和黃土的強度及變形特性存在明顯差異；進而分析了含水量、固結應力和固結應力比對黃土動力特性的影響本文最後對非飽和土的有效應力計算公式進行了討論。 -
As pointed out earlier, those sources eliminate the need for a heavy external magnet. two hpm sources magnetically insulates line oscillator ( milo ) and the reltron have been researched and improved. finally, a new high power microwave source, the axial acceletron is presented in this paper
首先對幾種高功率窄帶微波源進行了評估，然後著重研究無引導磁場最具備代表性的兩種器件，磁絕緣線振蕩器（ milo ）和super - reltron ，並提出了改進的措施。 -
A method presented for designing diagonal impeller blading from blade elements defined on cones which pass through the blade - edge streamline locations. the staking line for the blade elements can be leaned in both the axial and tangential directions
葉片造型分為基元葉片確定及沿葉高的積疊方式，在葉片積疊過程中，考慮了氣動力以及離心力力距對葉片積疊點的影響。 -
Axial limitation of the slevve movement by means of a patented thrust system located in the center line of each gearing
採用位於每套齒輪中心線的專利推力系統對軸套的位移進行軸向限制。 -
By the support of national nature science foundation, some key problems of cvt were investigated, and some useful results were obtained as follows : ( 1 ) the relations between metal - belt misalignment in axial direction and transmission parameters were studied. by designing curved generating line pulley or adjusting the axial displacement of pulley, the degree of misalignment of the metal belt was decreaed
本文在國家自然科學基金重點項目（編號： 59835160 ） ，國家教委重點項目（教技司（ 98 ） 121號） ，重慶市科委攻關等項目的資助下，對cvt傳動的若干關鍵問題進行了研究，本文的工作為cvt傳動的研究、應用和開發奠定了基礎。 -
In line with the characteristics of methanol synthesis, an axial - radial methanol synthesis reactor is developed on the basis of the organic combination of thermodynamics and kinetics, and its use under various pressure levels and in various regions gives satisfactory results
根據甲醇合成的特點，將熱力學和動力學有機結合起來所開發的軸徑向甲醇合成反應器，在不同壓力等級和領域中應用，均取得了令人滿意的效果。 -
The axial line of the rotation axes forms an angle with the moving direction of the shaped sections ranging from 70 degree to 110 degree
該轉動軸的軸線與型材運動方向成70和110度之間，刀具在隨轉動軸轉動過程中完成切斷任務，實現按照需要的設定長度進行管材或其它型材的不停機定長切斷。
分享友人