axial load 中文意思是什麼

axial load 解釋
軸向負載
  • axial : adj. 1. 軸的。2. 成軸的。3. 軸周圍的，軸向的。adv. -ly 在軸的方向，與軸平行地。
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  1. Radial - thrust floating - ring hybrid bearing, which can not only sustain the radial load but also the axial load, colligate the strongpoints of pure dynamic and static bearings

    徑?推聯合浮環動靜壓軸承自二十世紀七十年代經提出后，已進行了較為系統的研究。
  2. Based on the past results, seismic behavior of r. c. frame structure with special - shaped column is studied, according to the members to the structure in sequence in this paper. the main contents are as follows aspects : first of all, aiming at the characteristics of special - shaped column, various control parameters including allowable value of drift angle, axial load ratio etc, are studied

    本文在前人研究成果的基礎之上，就鋼筋混凝土異形柱框架結構的抗震性能，按照從構件到結構的順序展開研究，主要內容如下：第一，針對異形柱的特點，對影響結構抗震性能的主要參數，如層間位移角、軸壓比等進行研究。
  3. Axial load fatigue testing for threaded fasteners

    螺紋緊固件軸向載荷疲勞試驗方法
  4. The hydrodynamic propulsor takes drill fluid as power source, with the aid of the axial load produced by the pressure drop of the bit nozzle, makes the axial force act on the bit to produce wob, making up for the insufficient wob, ensuring the bit feeding smoothly and improving the penetration rate

    這種推進器以鉆井液為動力源，藉助鉆頭噴嘴壓降產生的軸向載荷，使軸向力直接作用於鉆頭產生鉆壓，彌補有效鉆壓不足，保證鉆頭平穩鉆進，提高機械鉆速。
  5. Angle contact ball bearing can be subject to both radial and axial load, it also can be subject to pure axial load, its axial load capacity is depend on the contact angle and increased accordingly. it can be used for high speed and high precision application dueto high limit speed and pre - adjustable rigidity

    角接觸球軸承可同時承受徑向載荷和軸向載荷，也可以承受純軸向載荷，其軸向載荷能力由接觸角決定，並隨接觸角增大而增大，且極限轉速較高，剛性大還可預調，適用於高速、高精度場合。
  6. The influence of such parameters as axial load index, aspect ratio and percentages of lateral reinforcement, on seismic performance of reinforced concrete frame column in hong kong and analyses the distribution relationships of flexural deformation, shear deformation and slippage of longitudinal reinforcement in joint zone

    根據試驗結果，討論了軸壓比、配箍率、剪跨比等參數對其抗震性能的影響，分析了水平荷載作用時塑性鉸區的彎曲變形、剪切變形和縱向鋼筋粘結滑移變形所產生的位移在框架柱總水平側移中所佔的比例及其變化規律。
  7. The effect of axial load of bearing capacity on nomal section of prestressed concrete

    圓形截面鋼筋混凝土偏壓構件正截面承載力的精確演算法
  8. Axial load composed of five main kinds of vehicles was gained by eye - observing, and then the mean exchange coefficients of each kind of vehicles and equivalent standard axle load were obtained

    利用目測法得到各類車輛軸載組成，通過分析得到各類車輛平均軸載換算系數，然後求得標準軸載作用次數，採用空間換時間方法，最後建立了四個地區不同交通量等級下的路面使用性能預測方程。
  9. On the base of the anti - theory, the shear property of high - strength concrete column confined with high - strength continue compound spiral hoops is analyzed taking account of the advantage and disadvantage influence by the axial load

    在前述理論的基礎之上，考慮到軸力對抗剪的各種有利和不利的影響和連續復合螺旋箍筋對高強混凝土的約束作用，具體分析了高強混凝土高強連續復合螺旋箍筋柱的抗剪性能。
  10. Threaded fasteners - axial load fatigue testing - test methods and evaluation of results

    螺紋緊固件.軸向載荷疲勞試驗.試驗方法和結果評價
  11. Theoretical analysis on axial load transfer of single pile

    單樁軸向荷載傳遞的理論分析
  12. Elements of electrical and optical connection - test methods - optical elements - axial load

    電氣和光學連接元件.試驗方法.光學元件.軸向荷載
  13. In this part, it is also found that the equivalent prismatic column, which is obtained based on the equal elastic critical load as the non - prismatic member, is not actually equivalent to the tapered column in inelastic stability, and the latter has higher load carrying capacity. finally, the behavior of tapered beam - column acted by combined axial load and transverse load has been investigated. a bending - thrust interaction curve is established which is similar to the ones for the design of prismatic members

    三是研究了楔形變截面懸臂構件在大端固定，小端同時承受橫向及軸向荷載共同作用下的強度和彎矩平面內的穩定，同時參考等截面構件的設計公式，得到了用大端截面來表示的軸力p與彎矩m的之間的相關關系。
  14. Experiment on and analysis of force transfer of axial load in granular packs

    顆粒堆中軸向靜荷載力傳遞實驗分析
  15. Verification regulation of axial load fatigue testing machines

    軸向加荷疲勞試驗機檢定規程
  16. 9. some detail requirements, such as the maximum axial load ratio in columns, the minimum of confined transverse reinforcement within yield hinge regions and so on, are also proposed to modify chinese code ( gbj1o - 89 )

    本文還討論了現行《混凝土結構設計規范》 （ gbj10 ? 89 ）關于軸壓比限值及柱端加密區約束箍筋最小要求等構造方面存在的問題，提出了相應的修正建議。
  17. Firstly, the shear and normal stresses of tapered members under the transverse load or axial load are analysed, and the stresses formulas are obtained which are different from those of the prismatic ones. secondly, research is done on the in - plane inelastic stability of tapered members under axial loads about strong axis and weak axis. a new design method is suggested in which the tapered member is equivalent to the prismatic member with the cross - section at the larger end of the tapered member

    同時由分析可知，目前採用的將變截面壓桿按照彈性極限荷載等效的原則等效成以小端截面為準的等截面壓桿的設計方法，在彈塑性階段低估了壓桿的承載力，即彈性等效的壓桿在彈塑性階段並不等效，實際變截面壓桿的承載力比等效的等截面壓桿的承載力要高。
  18. This type of bearings is separable, which can only carry axial load

    是可分離型軸承，只能承受軸向載荷。
  19. The natural frequency of transverse vibration in axial load of simply supported beam

    軸向載荷作用下簡支梁橫向振動的固有頻率
  20. Axial load factor

    軸向載荷系數
分享友人
分享到 Line

分享到臉書