axial position 中文意思是什麼

axial position 解釋
軸向位置
  • axial : adj. 1. 軸的。2. 成軸的。3. 軸周圍的，軸向的。adv. -ly 在軸的方向，與軸平行地。
  • position : n 1 位置；方位；地點。2 處境，情況；狀態，形勢，局面。3 姿態，姿勢。4 地位，身份；職位；職務。5 ...
  1. Besides, efficiency curves versus clocking positions can be improved globally by changing rotor ' s position from the middle of two stator rows or by reducing the distance between two stators in axial direction

    另外，處于兩靜葉排正中的動葉位置的前後移動或縮短靜葉排間的距離均能帶來時序效應影響下效率的整體提升。
  2. By comparing the results with relative experiment data, it is shown that rng k - is more exactly than the other turbulent model. 2 ) the influences of axial inflow position, radial outflow size, rotating reynold number, non - dimensional mass flowrate and axial inflow angle on the flow and heat transfer characteristics were numerically investigated for a typical rotator - stator cavity with axial inflow, radial inflow and radial outflow. the correlations for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established

    （ 2 ）針對一典型的徑向、軸向進氣，徑向出氣的轉-靜盤腔結構，系統研究軸向進氣位置、徑向出口大小、旋轉雷諾數、無量綱質量流量和軸向垂直預旋進氣等對盤腔內流動和換熱的影響，整理出轉-靜盤腔內轉盤平均努謝爾數與旋轉雷諾數無量綱質量流量之間的準則關聯式。
  3. Home - position axial compression method to be used for measuring the masonry strength

    原位軸壓法在砌體強度檢測中的應用
  4. Modal bode plot theory for diagnosing the rotor imbalance axial position and rotor imbalance type is presented based on advanced rotor dynamics theory and field balancing rotating machinery theory and comprehensive experience of field balancing steam - turbine generator set

    摘要基於轉子動力學理論、汽輪發電機組軸系現場動平衡理論和工程實踐經驗，提出可直接判斷軸系不平衡軸向位置及不平衡型式的振型波特曲線方法。
  5. This paper studies the application of inductively coupled plasma ( icp ) technology to the etching compound semiconductor insb - in film. by means of single probe and double probe, the ion density and electron temperature of chamber ( 30mm and 50mm in height respectively ) under varied process condition were diagnosed. the spatial distribution of the axial position of the two parameters and the varied curve that the two parameters varies with the power and air pressure are obtained

    利用單探針和雙探針診斷30mm高反應室和50mm高反應室在各種工藝條件下的離子密度和電子溫度，得到這兩個參數在反應室軸向位置的空間分佈、隨功率和氣壓的變化曲線、頂蓋接地和反應室體積對它們的影響，結果表明離子密度為10 ~ 8 10 ~ （ 10 ） cm ~ （ - 3 ） ，電子溫度在4 10ev之間；當頂蓋接地時，該處的等離子體密度明顯大於不接地；在同樣條件下， 50mm高反應室內的離子密度明顯大於30mm高反應室。
  6. Improper axial position and clearance of gears

    輪軸向位置和間隙不當
  7. The local pt diffusion is formed by the pt gettering by the hole defection deduced by hydrogen irradiation. the irradiation energy and dose definite the axial position and dose of the local pt diffusion respectively

    本課題研究提出了新型的局域鉑摻雜技術和電子輻照技術相結合的壽命控制技術，以期改善frd的綜合性能。
  8. Based on the modal analysis data of the displacement of the spatial grid structure getting by the structural finite element analysis software ansys, the modal analysis technology of the axial member straining rate is used to identify the damage of the spatial grid steel structure in different damaged conditions and is found to be able to accurately position the damaged places of the spatial grid member

    文中通過結構有限元分析軟體ansys得到網架結構位移模態分析數據，採用桿件軸向應變變化率的模態分析技術針對不同損傷狀況的鋼結構網架進行損傷識別，能夠較為準確地診斷出網架桿件的損傷位置。
  9. Firstly, the basic character of the remote filed eddy current is simulated and analyzed in case of two - dimension axial symmetry which approves the existence of remote filed eddy current phenomenon ; the full circumferential defect model is investigated to approve the feasibility of using the rfec techniques to detect the position and depth of defect ; the pit corrosion 、 circumferential and axial crack models are simulated, and the defect character based on voltage plane polar plot and the changes of phase and amplitude are analyzed to supply the standard for defect reconfiguration

    首先，在二維軸對稱情況下模擬與分析了遠場渦流的基本特性，證實了遠場渦流現象的存在;對全周向缺陷的遠場渦流檢測進行了詳細研究，證實了遠場渦流檢測缺陷位置和深度的可行性;對點狀腐蝕、軸向與周向裂紋三種非軸對稱缺陷進行三維有限元模擬，利用相位差和幅值變化曲線與電壓平面極坐標圖對缺陷特徵進行分析，為缺陷形狀重構提供了依據。
  10. Objectie. the aim of this study was to obtain proteoglycan distribution in human lumbar discs with high position resolution in the : 1 ) sagittal, 2 ) coronal, and 3 ) axial directions

    目的：本實驗的目的是獲得蛋白多糖在人類腰椎間盤矢狀位、冠狀位和軸狀位上分佈的高解析度位置。
  11. A program is produced to simulate the particle ' s tracks in swirling air flow in a horizontal straight pipe and find that the tendency of particle migration towards pipe center is not affected by initial position of a particle and all particles are sent into pipe by the axial motion of the swirling flow

    編程計算顆粒在管中螺旋氣流的運動軌跡，數值結果表明，無論顆粒初始位置如何，所有顆粒都被推向軸心位置，並被螺旋流的軸向運動推入管中。
  12. Axial position indicator

    軸向位置指示器
  13. Anatomic study on normal atlanto - axial joint in the functional position by using ct three - dimensional imaging method

    三維成像觀察正常寰樞關節功能位的解剖學研究
  14. Abstract : concerning the models for discribing aerodynamic stability of axial flow compressor, the original model is one - dimensional, and it is reasonable for the onset of surge only. for the onset of rotating stall, there are just some two - dimensional models at published literatures. a three - dimensional aerodynamic of compressor has been presented in this paper. an aerodynamic stability model concerning radial disturbance of compressor is presented. the calculated results show that the occurrence of radial disturbance is related to the axial velocity disturbance, which has important effect on aerodynamic stability of compressor. the position of onset of stall, in blade tip or hub, is dependent upon the characteristics of blade element. the comparisons of calculated results predicted by 2d and 3d aerodynamic stability model have also been made in this paper

    文摘:軸流壓氣機的氣動穩定性模型，最初為一維模型，僅適用於描述喘振發作.對于旋轉失速發作，在公開文獻中有一些二維模型發表.本文提出了一類考慮壓氣機徑向擾動對失速影響的新的氣動穩定性模型.計算結果表明壓氣機的軸向擾動往往隨著徑向擾動的產生，徑向擾動的強度影響壓氣機的氣動穩定性，在葉尖還是葉根首先產生失速與壓氣機基元葉柵特性密切相關.本文對軸流壓氣機二維和三維氣動穩定性模型的計算結果進行了對比分析
  15. Concerning the models for discribing aerodynamic stability of axial flow compressor, the original model is one - dimensional, and it is reasonable for the onset of surge only. for the onset of rotating stall, there are just some two - dimensional models at published literatures. a three - dimensional aerodynamic of compressor has been presented in this paper. an aerodynamic stability model concerning radial disturbance of compressor is presented. the calculated results show that the occurrence of radial disturbance is related to the axial velocity disturbance, which has important effect on aerodynamic stability of compressor. the position of onset of stall, in blade tip or hub, is dependent upon the characteristics of blade element. the comparisons of calculated results predicted by 2d and 3d aerodynamic stability model have also been made in this paper

    軸流壓氣機的氣動穩定性模型，最初為一維模型，僅適用於描述喘振發作.對于旋轉失速發作，在公開文獻中有一些二維模型發表.本文提出了一類考慮壓氣機徑向擾動對失速影響的新的氣動穩定性模型.計算結果表明壓氣機的軸向擾動往往隨著徑向擾動的產生，徑向擾動的強度影響壓氣機的氣動穩定性，在葉尖還是葉根首先產生失速與壓氣機基元葉柵特性密切相關.本文對軸流壓氣機二維和三維氣動穩定性模型的計算結果進行了對比分析
分享友人
分享到 Line

分享到臉書