axial pressure 中文意思是什麼
axial pressure
解釋
軸向壓力-
The dishing ring seals belong the end face sealing parts, and act as sealing by some axial compression. because of different distribution of internal pressure and temperature, the friction inside the end - face is also different at all area
碟形密封圈屬于端面密封元件，依靠一定的軸向壓縮量進行密封，由於端面內壓力分佈、溫度分佈不均，端面內的摩擦狀況也不是處處相同。 -
The hydrodynamic propulsor takes drill fluid as power source, with the aid of the axial load produced by the pressure drop of the bit nozzle, makes the axial force act on the bit to produce wob, making up for the insufficient wob, ensuring the bit feeding smoothly and improving the penetration rate
這種推進器以鉆井液為動力源，藉助鉆頭噴嘴壓降產生的軸向載荷，使軸向力直接作用於鉆頭產生鉆壓，彌補有效鉆壓不足，保證鉆頭平穩鉆進，提高機械鉆速。 -
A. hydraulic pressure adapts constant power variable axial piston pump for energy saving
液壓泵採用恆功率自動變量軸向柱塞泵，以節省能源。 -
Using the system designed in this thesis work, flow field calibration of the wind tunnel is accomplished, which covers dynamic pressure drop coefficient, dynamic pressure time stability, axial static pressure gradient, boundary layer, and degree of turbulence, etc. boundary layer measuring principle and method are especially described in detail, the relationship between boundary layer thickness, wind speed setting, and the depth of the experimental section is summarized, and finally the calibration data for th e model center zone under specific wind speed are given
然後利用本文設計的系統完成了落差系數、動壓時間穩定姓、軸向靜壓梯度、邊界層及湍流度等內容的流場校測。特別對邊界層測量的原理及方法做了較詳盡的敘述，總結出邊界層厚度與設定風速、實驗段深度的關系，然後給出模型中心區一定風速下校正數值。 -
The axial forces are related to oil supply pressure, and also to the square of rotary speed and the fourth power of effective diameter of circular circle
軸向力除了與供油壓力有關外，主要是與泵輪轉速的二次方和循環圓有效直徑的四次方有關。 -
Combined with the real example of monitoring pressure on the supporting system in the long span underground space of dk7 + 692 section at jiao - xin line of chongqing light railway, it is set forth the methods about choosing the support system and its parameter, digging methods of underground space, measuring and testing methods for the stress of the support system ; the testing results and variation pattern were analyzed for the stress of the initial supporting i - steel axial stress of bolt, stress of shot - concrete, supporting pressure of temporary i - steel and stress of steel of the second lining, then, the reason for deformation of the support system induced by sharp increase of i - steel was determined
摘要結合重慶市輕軌較新線大坪車站大跨度地下空間dk7 + 692斷面施工支護體應力監測的工程實例，闡述了該大跨度地下空間支護結構的參數選擇、地下空間的開挖方法、支護體結構的應力量測方法及測試手段；分析了支護體初期支護工字鋼拱應力、錨桿軸力、噴射混凝土內應力、臨時工字鋼支撐應力、二次襯砌鋼筋應力等測試結果和變化規律；確定了工字鋼拱應力急劇增大而可能引起支護體系失穩的原因。 -
In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data
為探討軸流壓氣機在工作流量、工作轉速及動?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律，並耦合進氣畸變的影響，同時與壓氣機氣動性能和氣動穩定性相關聯，作者利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機（ lsc ）試驗器，採取在靜子葉片表面埋入動態壓力傳感器的實驗方法，對葉尖、葉中和葉根三個截面的動態壓力進行了測量，獲得了大量的可靠的實驗數據。 -
The experimental study and numerical simulation have been done aiming at the problems of dieless thin - walled tube forming under combinatory action of internal pressure and axial force and loading control stability
摘要針對內壓和軸壓共同作用下的薄壁管無模內高壓成形及加載控制穩定性問題進行了實驗及數值模擬。 -
This paper studies the application of inductively coupled plasma ( icp ) technology to the etching compound semiconductor insb - in film. by means of single probe and double probe, the ion density and electron temperature of chamber ( 30mm and 50mm in height respectively ) under varied process condition were diagnosed. the spatial distribution of the axial position of the two parameters and the varied curve that the two parameters varies with the power and air pressure are obtained
利用單探針和雙探針診斷30mm高反應室和50mm高反應室在各種工藝條件下的離子密度和電子溫度，得到這兩個參數在反應室軸向位置的空間分佈、隨功率和氣壓的變化曲線、頂蓋接地和反應室體積對它們的影響，結果表明離子密度為10 ~ 8 10 ~ （ 10 ） cm ~ （ - 3 ） ，電子溫度在4 10ev之間；當頂蓋接地時，該處的等離子體密度明顯大於不接地；在同樣條件下， 50mm高反應室內的離子密度明顯大於30mm高反應室。 -
By analysing testing data, we do a study of relations between lateral swelling strain and water content, between lateral swelling strain and axial loading, and between swelling pressure and water content. 4
通過試驗資料整理分析，深入探討了膨脹巖的側向約束下軸向膨脹變形與含水率之間的關系、軸向膨脹變形與軸向荷載之間關系以及不同始末狀態膨脹壓力發展規律。 -
In order to predict high - strength bolts pretension and contact - friction in contact zone, status nonlinear in contact zone is adopted in fem model. the computation and analysis on the behavior of beam - to - column rigidity joints subjected to constant axial pressure on the top of column and cyclical load at tip of beam is carried out
實體模型的建立，考慮了接觸區的狀態非線性，以模擬高強螺栓的預拉力、螺栓連接區的摩擦接觸，對承受軸力的樑柱剛性連接方式在循環荷載作用下的滯回性能進行了計算分析。 -
Finally, the thesis primarily sets up the internal force model of the supporting structure system in the bi - arch tunnel, namely, the distribution model of the surrounding rock ' s pressure, the internal force model of the steel framework and the axial force model of the anchor bolt, and these results can have the guiding significance to the design and construction of the similar tunnel engineering
最後，結合有限元的理論計算及現場實測數據的分析，初步建立了雙連拱隧道支護結構體系的內力模型，即：圍巖土壓力模型、初期支護鋼拱架內力（主要為軸力和彎矩）模型以及錨桿軸力模型。充分理解和闡述了構件的工作狀態，對今後類似隧道工程的設計和施工具有一定的指導意義。 -
This kind of axial pressure gauge is well suited for measuring those gasses of liguids which will neither explode nor crystallize, nor presipitate, nor corrode copper copper or copper alloys
該表用於測量對銅和銅合金無腐蝕性、無爆炸性、且不結晶踢，不沉澱的氣體或液體的壓力。 -
A discretization equation is derived by using a finite volume method in three - dimensional cylindrical polar coordinate system. algebraic equations are solved by iteration with a line - by - line method that is a combination of tdma in axial and radial directions, ctdma in tangential direction and adi method in three directions. the pressure and velocity coupling are solved with the simple algorithm
在三維圓柱坐標下，利用有限體積法推導離散方程；在軸向與徑向用三對角矩陣法（ tdma ） ，在周向採用循環三對角矩陣法（ ctdma ） ，採用交替方向亞鬆弛疊代法（ adi ）求解方程；推導同位網格下的壓力修正方程，用simple演算法處理速度與壓力的耦合；為加速收斂，採用適當的鬆弛因子。 -
Fe - simulation shows that slower internal pressure increasing rate is helpful to restrain the wrinkle ' s development of the tube forming under relative higher axial pressure and lower internal pressure
有限元數值模擬證明，在軸壓偏高而內壓相對偏低的情況下，降低內壓的增長率有助於抑制起皺的發展。 -
Lastly, the author investigated the impact of the axial pressure gradient on three - dimensional chaotic mixing in eham by computing the mixing efficiency of a tracer
最後，通過計算三維eham混沌混合中代表性流體質點的拉伸效率行為，確定軸向壓力梯度的影響。 -
Reclosable child resistant packages ; plastic screw closures with press turn system axial pressure effect ; mechanical testing of trick system
可再封閉的防兒童打開的包裝.帶壓力轉動系統 -
Axial pressure load
軸向壓力負載 -
In this paper, thin wall tube initial yield under the pressure of hydraulic pressure, axial pressure, is discussed, the calculate formulae of initial deformation force is derived and experimental verification has been finished
摘要本文就有限長薄壁管在內壓、軸力作用下初始屈服問題進行了研究，推導出了初始力計算公式，並進行了實驗驗證。 -
Abstract : the present paper analyzes the axial pressure of the coil, the working principle of the coil drum and causes of slide scar on the strip head and advances the new method for the taper control of the coiling tension
文摘:針對單機架平整機的帶鋼頭部滑傷問題，分析了鋼卷徑向壓力、捲筒的工作原理，及帶鋼頭部滑傷形成原因，提出了卷取張力採用錐形控制的新方法。
分享友人