axial stress in compression 中文意思是什麼

axial stress in compression 解釋
軸向壓應力
  • axial : adj. 1. 軸的。2. 成軸的。3. 軸周圍的，軸向的。adv. -ly 在軸的方向，與軸平行地。
  • stress : n 1 壓力，壓迫，緊迫，緊張。2 【語音】重音；重讀；【詩】揚音；語勢，著重點。3 重要（性），重點，...
  • in : adv 1 朝里，向內，在內。 A coat with a furry side in有皮裡子的外衣。 Come in please 請進來。 The ...
  • compression : n. 1. 壓縮；壓緊；濃縮，緊縮。2. 加壓；壓抑。3. （表現的）簡練。4. 應壓試驗。
  1. It is determined that with accurate knowledge of the complete stress - strain curve of concrete in compression, steel in tension, and with an iterative computerized non ? linear method, it is possible to predict the entire moment - curvature, moment - flexural rigidity and axial rigidity relation ship of a cross - section of a structure member

    可以確定，只要知道混凝土受壓和鋼筋受拉的完整的應力應變關系，採用選代的非線性計算方法，就有可能預測結構截面彎矩一曲率、彎矩一彎曲剛度和軸向剛度的關系。
  2. Columns under axial compression and biaxial bending. in the beginning of the paper, it summarized the history and the actuality of the nonlinear analysis of special - shaped columns and the capability of the sliding of reinforcement anchoring. on the basis of related papers, the full path of stress - strain relation of concrete and the sliding of longitudinal reinforcement anchoring are all considered

    本論文主要內容是對鋼筋混凝土異形截面雙向壓彎柱（包括l形、 t形、十字形柱）進行非線形全過程分析，首先綜述了異形柱構件非線性分析以及粘結滑移性能研究的歷史與現狀，在有關文獻基礎上考慮了受拉縱筋和周圍混凝土的粘結滑移和混凝土應力?應變關系曲線的下降段。
  3. Using the general finite element programming package of ansys10. 0, the study of gabled frames beam - column end - plate connections is made, considering synthetically nonlinear ( material, geometry and contact ), bolt pretension forces and ratio of axial compression stress to strength. elastic - plastic finite element analyses are carried out among 28 species of 3 series under monotonic loads, in order to discuss the influence of parameters including stiffness of end - plate, bolt diameter, friction coefficients and so on

    本文使用通用有限元軟體ansys10 . 0綜合考慮了三重非線性（材料非線性、幾何非線性以及狀態非線性）的影響，同時考慮了螺栓預拉力的影響，對考慮端板厚度、端板加勁肋的設置、螺栓直徑、摩擦系數等參數不同的3個系列（端板系列，螺栓直徑系列，摩擦系數系列） 28個試件進行了有限元數值模擬，對連接節點的性能進行了分析研究。
  4. ( 2 ) based on deterioration model of owerage bond stress of beam reinforcement accounting for effect of axial compression ration and number of displacement loops, and stress - strain relationship of the concrete in the joint core accounting for effects of both softening and confinement, the modified compression field theory was employed to simulate behavior of the joint core under loading reversals. analysis by means of the program jap on the tested specimens in this paper and those obtained from other researchers produced consistent results

    根據本文建立的考慮軸壓比和位移循環次數影響的梁筋平均粘結應力退化模型和考慮軟化效應、約束效應的核心區混凝土應力應變關系，通過在試驗中得出的節點核心區混凝土、箍筋、節點正面、背面柱筋在反復荷載下的受力特點，利用斜壓場理論模擬節點核心區在反復受力過程中的受力狀態。
  5. Neglecting the influence of concrete stress - path, relative program is presented to make full - process analysis on compression - flexure members confined with cfrp in the compression zone, a key research is to analyze the effect of some parameters including axial compression ratio, thickness of cfrp, concrete strength on strength capacity and displacement ductility of reinforced compression - flexure members

    在忽略混凝土應力路徑的影響下，編制相應程序對碳纖維布粘貼鋼筋混凝土壓彎構件進行了全過程分析及相關參數研究，並把計算結果與試驗結果進行了對比，兩者吻合較好。
  6. The influence on the shear resistance of columns by the axial loads includes two aspects : the one is that the axial load enhances the concrete strength of column in the inclined compression zone and the other is that the axial load increase the stress of the concrete of column in the inclined compression zone so that the shear resistance of column turns down

    考慮軸力對柱抗剪承載力的影響，主要體現在軸力對斜壓帶混凝土強度折減系數提高的有利影響和軸力增加了斜壓帶混凝土的應力從而減少了柱的抗剪承載力的不利影響兩方面，提出了考慮軸力影響的用於受剪的斜壓帶混凝土抗壓強度f ~ （
分享友人
分享到 Line

分享到臉書