axial tension 中文意思是什麼

axial tension 解釋
軸向拉力, 軸向拉伸
  • axial : adj. 1. 軸的。2. 成軸的。3. 軸周圍的，軸向的。adv. -ly 在軸的方向，與軸平行地。
  • tension : n 1 拉緊；伸張。2 （精神、局勢等）緊張。3 【物理學】張力，拉力，牽力；（彈性體的）應力；（蒸氣等...
  1. It is determined that with accurate knowledge of the complete stress - strain curve of concrete in compression, steel in tension, and with an iterative computerized non ? linear method, it is possible to predict the entire moment - curvature, moment - flexural rigidity and axial rigidity relation ship of a cross - section of a structure member

    可以確定，只要知道混凝土受壓和鋼筋受拉的完整的應力應變關系，採用選代的非線性計算方法，就有可能預測結構截面彎矩一曲率、彎矩一彎曲剛度和軸向剛度的關系。
  2. Analysis of two - axial tension - compression stochastic damage constitutive equation of concrete

    壓隨機本構方程分析
  3. Test method of ferrocement panels in axial tension

    鋼絲網水泥板軸心受拉試驗方法
  4. Based on the axial tension test results of 20 concrete members reinforced with steel bars and fibers, the axial forces and stress were analyzed of steel fiber reinforced concrete ( sfrc ) members

    摘要根據20根鋼筋鋼纖維混凝土軸拉構件的試驗結果，分析了鋼筋鋼纖維砼軸拉構件在受力變形過程中，鋼纖維的摻量對構件性能的影響。
  5. The axial - symmetric ring - shaped interface crack problems are discussed under tension loading

    摘要討論受拉伸載荷作用的軸對稱環形片狀界面裂紋問題。
  6. Standard practice for constant - amplitude, axial, tension - tension cyclic fatigue of continuous fiber - reinforced advanced ceramics at ambient temperatures

    室溫下連續纖維增強高級陶瓷的等高度軸向的和雙向拉伸循環疲勞強度的標準規程
  7. Standard test method for multi - axial tension test for geosynthetics

    土工合成織物多軸抗拉試驗的標準試驗方法
  8. Theoretical calculation for the section design of the pre - stressed concrete members imposed to axial tension, offset tension of offset compression

    偏心受壓構件截面設計的理論設計計演算法
  9. Abstract : the present paper analyzes the axial pressure of the coil, the working principle of the coil drum and causes of slide scar on the strip head and advances the new method for the taper control of the coiling tension

    文摘:針對單機架平整機的帶鋼頭部滑傷問題，分析了鋼卷徑向壓力、捲筒的工作原理，及帶鋼頭部滑傷形成原因，提出了卷取張力採用錐形控制的新方法。
  10. 2. for frame supported double - short - pier shear wall under vertical loads, the non - noding area of transfer beams turns into a member of flexure and tension with small axial force, and bending stress dominates in the stress distribution on the cross - section. in the nodding area, the axial force increases while the bending effect is small

    2 、框支雙肢短肢剪力墻在豎向荷載作用下，轉換梁的非節點區為一拉彎構件，軸向拉力較小，截面的應力分佈以彎曲應力為主;在節點區，軸向拉力效應增大，而彎曲效應很小。
分享友人
分享到 Line

分享到臉書