axial wall 中文意思是什麼
axial wall
解釋
軸壁-
Stress analysis of symmetrical and thick wall components with axial symmetry in geometry and load
幾何軸對稱及載荷軸對稱厚壁零件的應力分析 -
An axial filament, with a similar structure to a bacterial flagellum, is spirally wound about the protoplast inside the cell wall
在細胞壁內部，和細菌鞭毛有相同結構的軸向細絲包繞細胞質並使之螺旋化。 -
The effect of air distributor on the flow fields was studied with emphasis. the working conditions of the bubble column simulated in the numerical study were as same as in the experiments. the velocity profile at axial direction showed a peek in the center, and a backward flow near the wall when usl / usg < 19. 6
鼓泡塔內軸向液相速度的徑向分佈呈塔中心峰值、壁面附近倒流形式，且與氣相折算速度大小有關，當液相折算速度一定時，隨氣相折算速度增大而愈加陡峭，返混也劇烈。 -
Axial compression test on space truss - concrete combined sandwich wall plate
結構夾芯墻板中心受壓試驗研究 -
Experimental study on axial wall heat conduction for steel microtube under forced convection
過冷水環狀兩相流傳熱特性實驗研究 -
Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed
本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。 -
The temperature field along the axis, axial velocity, the turbulent energy, and the concentration of the particles were investigated when the temperature field varied. the numerical experiment shows that the thermophoresis force changes the concentration of the 2 - micron particle, decreasing in the main flow and increasing in the near - wall region
數值實驗的結果表明在兩相流模型中添加熱泳力源項會對2微米顆粒在流場中的濃度分佈有很大的變化，主流區的顆粒濃度降低，近壁區顆粒濃度在溫差不大的時候，提高幾十倍。 -
The study results reveal some laws : ( 1 ) two failure modes exist in different obliquity slope and influence the internal force of soil nailing ; ( 2 ) the connection between face shield and soil nailing determines the distribution of the axial force along length ; ( 3 ) the influence of face shield involves its connection with soil nailing and its stiffness on soil nailing wall ; ( 4 ) the transversal effect of soil nailing depended on the joint of nail head is little ; ( 5 ) the maximum axial forces of other soil nailings except the first soil nailing increase gradually with excavation
研究表明： （ 1 ）素土坡隨著坡角的變化，存在兩種破壞方式，破壞方式不同，土釘受力狀態不同； （ 2 ）土釘和面層的連接方式決定著土釘長度方向上的軸力分佈形態； （ 3 ）面層主要通過面層與土釘的連接和面層的本身剛度兩個方面對土釘內力和墻體變形產生影響； （ 4 ）土釘橫向抗剪抗彎作用的發揮程度和土釘釘頭的連接方式有關，但作用不大，實際設計時可以忽略其影響； （ 5 ）隨著坡體的開挖，第一排土釘的最大軸力變化不大，其它土釘的軸力都穩步增加。 -
Relaxation factors are adopted. a program is produced to simulate swirling air flow in a horizontal straight pipe and compare with experiment data. the simulation prove that the modified k - model can predict the core, annular and wall regions near entrance and axial velocity far from entrance, but it ca n ' t predict tangential velocity well in weak swirling area far from entrance
編程計算水平圓管內螺旋氣流的流動參數並與實驗數據對比，結果表明修正-湍流模型在近入口處基本上能預測出中心區、環形區和近壁區的流動特性，在遠離入口弱旋流區域對軸向速度的預測符合實際情況，但是出現對周向速度修正過大的現象。 -
Computed tomography ( ct ) and axial magnetic resonance ( mr ) imaging demonstrated an appendiceal mass with central fluid collection, disproportionate wall thickening and prominent infiltrations in the periappendiceal fat simulating a " gearwheel "
電腦斷層及軸狀面磁振造影顯示闌尾腫瘤，由於腫瘤中心部份有液體存留，中間有不成比例之厚壁及外圍有放射狀侵潤圍繞闌尾之脂肪，構成類似?齒輪?狀。 -
In static test, t - shaped and l - shaped specimens were respectively divided into four groups according to concrete strength grades, sectional height to thickness ratio, reinforcement ratio and ratio of axial compressive force to axial compressive ultimate capacity of section. how these factors affect the load - carrying and deformation of short - leg shear wall is known by analysis the result
在擬靜力試驗中對t形和l形短肢剪力墻分別進行了四組試驗，通過對試驗結果的分析，揭示了混凝土等級、截面配筋率、軸壓比和墻肢截面高厚比等因素對短肢剪力墻承載力和變形的影響。 -
As far as he hollow inclined column - wall transfer r. c joint is concerned, the stress state of transfer beam is very critical, because it bears not only the vertical load transferred from the wall, but also the axial load initiated by the inclined column
對有孔斜柱轉換節點而言，轉換梁的受力最為不利，它不僅承擔由薄壁柱傳來的垂直荷載，而且還承擔由斜柱水平分力引起的軸向拉力，即截面上有彎矩、剪力和軸力的共同作用。 -
The stepped surface milling cutters cut small materials layer by layer. this structure takes advantage of lighting cut - force, decentralizing axial force. it ' s suited for pieces with thinner wall and used in small power machines
階梯面銑刀是在切削過程中達到分層的目的，減輕切削力、分散軸向力，適應薄壁零件和小功率機床上的切削大余量。 -
In the experiment, the infrared radiation and axial distribution of wall temperature and near wall flow pressure were measured with and without film cooling
得到了各冷卻方案噴管的壁面壓力分佈、壁溫分佈和紅外輻射特性。 -
Fist we resarch local wall temperature ouside and inside of tube, local fluid temperature inside and outside of tube, local heat flux inside and outside of tube, local coefficient of convective heat transfer inside and ouside of tube along the tube axial direction
首先研究在這兩種情況下管內（外）壁溫、管內（外）流溫、管內（外）壁面局部熱流密度、管內（外）局部對流換熱系數沿管子軸向的變化。 -
Its test specimens are four hollow shear wall of reinforced concrete, which have the different the ratio of shear span to effective depth of section and the ratio of axial compressive force to axial compressive ultimate capacity of section
本課題為鋼筋混凝土空心剪力墻抗震試驗研究及非線性有限元分析，課題的對象為四片不同軸壓比以及不同剪跨比的鋼筋混凝土空心剪力墻板。 -
For three - short - pier shear wall under vertical loads, the results remain the same, and transfer beam at this moment will work with the middle pier, constituting a t - shape beam to sustain the moment and axial tensions together. 4. under the horizontal loads, the inner stress distribution in the frame supported short - pier shear wall shows similarities with that of the short - pier shear wall underneath the fastened supports
4 、水平荷載作用下，框支短肢剪力墻墻肢內的應力分佈形式接近於下部固支的短肢剪力墻的應力分佈;轉換梁承受上部墻肢傳遞的拉力、剪力和彎矩，當短肢剪力墻墻肢數量較多時，轉換樑上、下邊緣拉、壓應力交替出現，剪應力的最大值處于洞口下方的轉換梁體內。 -
The transport of macromolecules in curved tubes with permeable arterial wall was simulated numerically. the fields of axial velocity, the fields of secondary flow function and the distribution of wall shear stress along the transverse section of arterial wall were obtained under different dean number, 10
10800 ，計算了彎曲血管內的二次流軸向速度場和剪應力沿管壁分佈的情況。計算求得了在不同dean數和peclet數下，其中10 -
The energy equation of the thrust chamber wall was developed by omitting radical heat conduction and only considering the radiation heat transfer of the four chambers, the radiation leakage through nozzle exit, the axial and circular heat conduction
忽略徑向導熱，考慮推力室外向的相互及自身輻射交換、內壁經噴口的輻射泄漏以及周向和軸向的傳導熱量，建立了推力室壁的能量方程。 -
5 ) based on test results and going by ultimate balance theory, the paper drew anti - shear formula of the wall under eccentric loads, and discussed the main factors which influenced its anti - shear bearing capacity. 6 ) based on plain section assumption, the paper studied the normal section bearing capacity of the wall. stress, strain and deformation computation was combined to establish bearing capacity formulas for the normal section under moment, unaxial loads and axial loads respectively
6 ）以應變平截面假定為基礎，對密肋復合墻體正截面極限承載力進行研究，即將墻體從初始受荷到正截面極限狀態的各階段的應力、內力及變形計算貫通起來，建立了墻體正截面壓彎、拉彎承載力實用計算公式和軸心承載力計算公式。
分享友人