bar section 中文意思是什麼

bar section 解釋
桿剖面
  • bar : BAR = Browning automatic rifle 白朗寧自動步槍。n 巴爾〈南斯拉夫港市〉。n 1 棒,桿,條;棒狀物。2...
  • section : n 1 (外科、解剖的)切斷;切割;切開。2 【外科】切片,【金相】磨石。3 (果子的)瓣。4 【數學】截...
  1. The paper studied tests on three epiboly profiled bar concrete beams, bearing capacity of normal section, stiffness and behavior of cracks, and put forward formulas as advise. based on extant nonlinear concrete theory, a fem model was built by ansys program. the results of fem analysis was verified by tests data. some parameters in fem model were changed to build different models and the analysis results were compared with the advised formulas

    本文通過三根外包型鋼混凝土梁試驗,研究了其正截面承載能力、剛度以及裂縫方面的性質,並提出了一些相關建議公式。同時在現有混凝土非線性分析理論的基礎上,採用ansys有限元分析程序建立了外包型鋼混凝土梁的有限元模型,結合試驗數據對模型進行了驗證,另外還改變了一些參數建立了有限元模型,並和建議公式的結果進行了對比。
  2. Applying classical wave theory, a concept of equivalent elastic modulus on propagation speed modification of guided wave through " variable cross - section " of metal bar embeded layer was put forward

    摘要運用波動的經典理論,提出了導波在金屬桿嵌入層「變截面」傳播時波速改變的「等效彈性模量」的概念。
  3. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ ( ( ? ) )程序進行數值模擬、分析驗證的基礎上,對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究;計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響,得出其變化規律。
  4. The beyond is the simple notation of serial number of pricker, totaled 7 digits of codes, in which the first digit represents the diameter of needle - bar of pricker, the second digit represents the siding of triangle side on functional section of pricker, the third digit represent the length of functional section of pricker, whereas in standard notation, it represents the distance from needlepoint to gradual deflating small port ( lower port ), the fourth digit represents the total length of pricker, which is the distance from the inside of bending helve to the needlepoint, the fifth digit represents the total quantity of dents on the cording of functional section, and the sixth digit represents the model of barb on functional section, while the seventh digit represents the distance between barbs on functional section

    以上為刺針編號的簡單寫法,共7位代碼,第一位是刺針針桿的直徑;第二位是刺針工作段三角面的邊寬;第三位是刺針工作段的長度,同標準寫法所不一樣的是針尖到漸縮錐小口(下口)的距離;第四位是刺針的總長度,按彎柄內側至針尖的距離;第五位是工作段棱上的總齒數;第六位是工作段上鉤刺的型號;第七位是工作段上鉤刺與鉤刺之間的距離。
  5. 2 ) the structure elements should be laid out symmetrically and uniformly when designing steeve - arch structure, what ' s more, the reasonable selection of section geometric size near the arch foots of first beams is paid attention to and the arrangement difficulties of steel bar due to the big eccentric pressures 2, the analyses of anti - seismic features on transverse direction of the aqueduct l ) the method of adjusting the elements " mass can be harnessed in order to even the layout of seismic loads

    2 )設計吊桿式拱架支承結構時,各部分構件應當均勻對稱布置。另外,還應注意頭道梁拱腳附近截面的尺寸擬定,克服地震內力造成的大偏心受壓狀態給結構配筋設計增加的困難。 2 、橫槽向抗震性能分析1 )可利用調整構件質量的方法,使得結構的某些構件的地震荷載分佈均勻一些。
  6. Circular section torsion bar springs ; calculation and design

    圓截面扭桿彈簧.計算與設計
  7. The work in this thesis mainly includes following parts : 1. as for box girder cross section, the three - bar stimulation method under typical loads and supports has been introduced. the force and stress formulae for flanges have been derived from the three - bar method. by reasonable simplification for multi - cell box girder, the three - bar method has been applied in multi - cell box girder ' s shear lag analysis

    對于箱形截面主梁,本文介紹了三桿比擬法上、下翼板中比擬桿的計算公式,以及在典型荷載和支承的情況下翼板內各桿的應力計算公式,並對多箱式主梁截面進行合理簡化,使三桿比擬法應用於多室箱梁的剪力滯分析。
  8. The section loss of steel bars and degradation of bond intensity were taken into consideration in this study in order to establish the finite element model of corroded reinforced concrete beam through simulating the bond slip behavior between steel bar and reinforced concrete based on nonlinear spring element

    摘要在考慮銹蝕引起的鋼筋橫截面損失和粘結強度下降的前提下,利用非線性彈簧單元模擬銹蝕鋼筋與混凝土之間的粘結滑移性能,建立了銹蝕鋼筋混凝土梁的有限元分析模型。
  9. Let us consider a slender bar of the medium, with a constant cross - section area. a short axial disturbance is produced at one of the bar, resulting in the propagation of a wave

    此方法的原理在於考慮一個等橫截面的圓形細桿介質,在波傳播到桿的一端時,產生了微小的軸向干擾。
  10. The type of bar can be selected according to cross section area, performance of the member

    型鋼可以根據構件截面的大小、受力特點,靈活地選用。
  11. The bar can enhance the bearing capacity and stiffness of the member, so that the cross section area of member can be significantly reduced, and function area of the building can be increased

    由於截面中配置有型鋼,構件的承載能力、剛度大大提高,構件的斷面尺寸大大減少,房間的使用面積明顯增加,房間中的設備、傢具也能更好布置。
  12. People may be served inside, where there often is an all - you - can - eat salad bar, or they may order and pick up food without even getting out of the car, at the “ drive - thru ” section of the restaurant

    人們可以在店裡進餐,那裡通常設有讓你吃個夠的沙拉櫃臺;人們也能在餐館外面不用下車可以點菜並取走食物。
  13. Abstract : experimental researches on normal section ultimate fle xural strength of prestressed reverse - rib - slab with excessive steel bar were m ade, and according to chinese norm ( gbj10 - 89 ) and american norm ( aci ) in which s train harmony analysis method was adopted, its ultimate strength was calculated, these make us further realizse the ultimate flexural strength of prestressed r everse - rib - slab with excessive steel bar

    文摘:通過疊合結構中預應力超筋倒肋薄板正截面極限承載力的試驗研究,分別採用規范gbj10 - 89中的受彎構件、偏心受壓構件的計算公式及美國aci規范中的應變協調分析方法計算了極限承載力,從而更清楚地認識了配有高強鋼絲的超筋倒肋板的極限承載力計算問題。
  14. One of the best ways to protect yourself from vision loss that often accompanies aging may be frequent trips to the salad bar and the supermarket vegetable section, florida international university researchers say

    羅里達國際大學的研究人員說,防止老年視力下降的一個最佳方法,就是常光顧沙拉店和超市的蔬菜攤位。
  15. The analysis showed the strain of section is not plain under moment so that the moment is carried by force couple in the outer frame. 4. the paper gave the rigid frame - compression bar model for practical computation

    在試驗研究的基礎上,提出了密肋復合墻板實用設計的鋼架斜壓桿模型;通過線彈性有限元分析,就其優化設計進行了探討。
  16. This paper introduces the construction techniques of the box girder bottom - formwork making, steel bar handling, and concrete casting, etc., and expounds the applications of these techniques in the two box girder bridges in the 10th contract section of changhan superhighway

    介紹了箱梁底模製作、鋼筋加工、混凝土澆築等施工工藝及其在長邯高速公路第10合同段內的兩座箱梁大橋中的應用。
  17. The earlier case of block 6 at kwai fong estate and the subsequent 26 housing block case are the only two for which section 18a of the icac ordinance was evoked. in pursuit of justice side bar 2

    根據紀錄,廿六座公屋案及之前的葵芳第六座公屋案是至今僅有的兩宗廉署透過引用廉政公署條例18a ,取得豁免受特赦令限制而進行偵查的案件。
  18. A further research on the torsion problem of a straight bar with uniform cross section

    等截面直桿扭轉問題的進一步研究
  19. Our main products include central material supply system, series drier, automatic charging machine, single double screw extruder, series heating and cooling blending machine, crusher, cold water machine, mould temperature controller, pipe, bar section, board, pp - r pipe, pe fuel pipe, plastic dual tubing extrusion production line and granulation completed production line equipment, at same time, we also carry on various plastic machine and refrigeration engineering. the products are sold well in every province and city of the whole country and also exported to about 30 countries and areas with strong technical force, advanced equipment, scientific management system and perfect after - sales service

    公司主要產品有集中供料系統系列乾燥機自動加料機單雙螺桿擠出機粉料高速混合機粒料混合機螺旋上料機牽引機切割機離心脫水機化纖團粒機全自動擴口機全自動計量混合裝置破碎機磨粉機冷水機模溫機管材型材板材pvc管材pp - r管材pe供水燃氣管材中空壁纏繞管材硅芯管材生產線,雙管擠出電工穿線管材造粒等全套生產線設備。
  20. This area has 6 plots which divided in 8 functional areas including international highlights section, supermarket and general merchandise section, digital articles section, jewelry and eyeglass section, buffet and bar section, recreation section, leisure and amusement section, and children ' s center, etc

    擁有六大地塊, 8大功能區(國際名品區、超市百貨區、數碼區、珠寶眼鏡區、美食吧類區、游藝區、休閑娛樂區、兒童城) 。
分享友人