bonding layer 中文意思是什麼

bonding layer 解釋
搭接層
  • bonding : 冰凍膠結
  • layer : n 1 放置者，鋪設者，計劃者。2 【賽馬】（一般）賭客。3 產卵的雞。4 【軍事】瞄準手。5 層；階層；地...
  1. Effect of heat treatment on induced apatite deposition and bonding strength of the alkali treated titanium oxide layer for carbon carbon composite

    碳復合材料上堿液處理氧化鈦鍍層誘導沉積磷灰石和結合強度的影響
  2. The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength

    對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明：碳化鎢體積分數為52時，復合層內基體為灰口鑄鐵組織，顆粒直接分佈在灰鐵基體上，部分碳化鎢顆粒有相互接觸的現象，基材與復合層之間沒有明顯的過渡；碳化鎢體積分數為36 、 27時，復合層內基體為高鉻鑄鐵，由面塊狀的奧氏體和白條狀碳化物組成，碳化鎢顆粒表面固溶於基體組織中，粒形基本保持完整，分佈均勻，與基體構成冶金結合，基材與復合層之間存在一個明顯的平緩過渡區。
  3. Ztfb photosensitive seal layer edge bonding machine is a special machine, which uses bonding die cavity to electric perm and spin to avoid ink infiltrate

    Ztfb型光敏機印章墊封邊機是利用封邊模腔對光敏墊周邊進行電燙，旋壓，使印章與章殼周端邊熔為一體，阻止印墨向外滲漏的一種專用機器。
  4. Sp cifications for particular types of winding wires - part 2 : solderable polyurethane enamelled round copper wire, class 130, with a bonding layer

    特種繞組線規范.第2部分: 130級帶粘合層的可軟焊聚氨酯漆包圓銅線
  5. It is shown that the effects of the stiffness and inertia of the piezoelectric element that lead to higher first natural frequency on the natural frequencies of the beam are significant, and that of the elastic modulus of the bonding layer is small

    研究表明，壓電元件的剛度和慣量對梁的頻率影響很大，變截面智能壓電梁的一階固有頻率總是高於等截面梁的固有頻率。
  6. The influence of the bonding layer thickness and material properties, piezoelectric layer thickness, placements and feed - back control parameters on the vibration suppression are investigated

    分析了粘彈層、壓電層厚度和壓電片位置等結構參數變化以及材料參數變化對控制效果及結構頻率的影響。
  7. Specifications for particular types of winding wires - polyesterimide enamelled round copper wire, class 180 with a bonding layer

    特種繞線規范. 180級帶粘結層的聚酰胺酯漆包圓銅線
  8. Specifications for particular types of winding wires - solderable polyurethane enamelled round copper wire, class 155, with a bonding layer

    特種繞線規范. 155級帶粘結層的可焊接聚氨酯漆包圓銅線
  9. Specifications for particular types of winding wires - solderable polyesterimide enamelled round copper wire, class 180, with a bonding layer

    特種繞組線規范. 180級帶粘結層的可焊接聚酰胺酯漆包圓銅線
  10. Specifications for particular types of winding wires - part 35 : solderable polyurethane enamelled round copper wire, class 155, with a bonding layer

    特種繞組線規范.第35部分: 155級有粘結層的可焊接聚氨酯漆包圓銅線
  11. Specifications for particular types of winding wires - part 36 : solderable polyesterimide enamelled round copper wire, class 180, with a bonding layer

    特種繞組線規范.第36部分: 180級有粘結層可焊接的聚酰胺酯漆包塗覆圓銅線
  12. Specifications for particular types of winding wires - part 37 : polyesterimide enamelled round copper wire, class 180, with a bonding layer ; amendment 2

    特種繞組線規范.第37部分:有粘結層的聚酰胺酯漆包圓銅繞組線. 180級.修改件2
  13. Specifications for particular types of winding wires - part 37 : polyesterimide enamelled round copper wire, class 180, with a bonding layer

    繞阻線特殊類型規范.第37部分: 180級帶粘合層的聚酯瓷漆園形銅線
  14. Specifications for particular types of winding wires - part 38 : polyester or polyesterimide overcoated with polyamid - imide enamelled round copper wire, class 200, with a bonding layer

    繞阻線特殊類型規范.第38部分: 200級的帶粘合層的聚酯或聚亞胺瓷漆園形銅線
  15. Specifications for particular types of winding wires - solderable polyurethane enamelled round copper wire, class 130, with a bonding layer

    特種繞組線規范. 130級帶粘合層的可焊接聚氨酯漆包圓銅線
  16. Specifications for particular types of winding wires - part 2 : solderable polyurethane enamelled round copper wire, class 130, with a bonding layer

    繞組線特殊類型規范.第2部分: 130級帶粘合層的可焊聚氨酯瓷漆圓形銅線
  17. Specifications for particular types of winding wires ; part 2 : solderable polyurethane enamelled round copper wire, class 130, with a bonding layer

    特種繞組線規范.第2部分:帶粘合層的可焊接的聚氨基甲酸乙酯漆包圓銅繞組線， 130級
  18. Specifications for particular types of winding wires - part 2 : solderable polyurethane enamelled round copper wire, class 130, with a bonding layer ; amendment 2

    特種繞組線規范.第2部分:帶粘合層的可焊接的聚氨基甲酸乙酯漆包圓銅繞組線， 130級.修改件2
  19. Specifications for particular types of winding wires - polyester or polyesterimide overcoated with polyamide - imide enamelled round copper wire, class 200, with a bonding layer

    特種繞線規范. 200級帶粘結層的塗覆有聚酯或聚酰胺酯的聚酰胺酰亞胺的漆包圓銅線
  20. Specifications for particular types of winding wires - part 38 : polyester or polyesterimide overcoated with polyamide - imide enamelled round copper wire, class 200, with a bonding layer

    特種繞組線規范.第38部分: 200級有粘結層的塗覆聚酰胺亞胺的聚酯或聚酯亞胺漆包圓銅線
分享友人
分享到 Line

分享到臉書