bridge beam 中文意思是什麼

bridge beam 解釋
橫梁
  • bridge : n 1 橋，橋梁；【造船】艦橋，船橋。2 鼻樑；（假牙上的）齒橋；【音樂】弦柱，弦馬；【電學】電橋；【...
  • beam : n 1 梁，棟梁，桁條；（船的）橫梁。2 船幅；（動物、人的）體幅。3 （秤）桿，杠桿，（織機的）卷軸，...
  1. The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection

    本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。
  2. The paper is based on an arcuated built - up system bridge - zhongshan no. one bridge to be built in guangzhou, adopts the large universal finite element programme ansys, takes spatial action among members into account, establishes a three - dimension finite element model, and discusses the following several aspects : firstly, when three - dimensional finite model of a complicated bridge is founded, a beam - lattice method is a kind of applied and effective spatial analysis method, which is used to analyze superstructures of a bridge

    本文以廣州市中山一橋為背景，採用大型通用有限元程序ansys ，考慮構件間的空間相互作用，建立了三維的有限元模型，重點對以下幾個方面進行深入探討：首先，在對復雜的橋梁結構進行三維的有限元模型建立時，梁格法是分析橋樑上部結構比較實用而且有效的空間分析方法。
  3. Theory analysis and practical project prove that the method of the reinforced concrete beam system bridge structure disease examination and structure damage evaluation is reasonable and viable

    理論分析與工程實例，都證明了本文的梁橋結構損傷識別及其評價方法體系的合理性與可行性；
  4. The manufacturing process of one beam bridge crane

    單梁橋式起重機的製造工藝
  5. Comparing with the same category overseas jointless bridges, the new type bridge has more reasonable structure, more simple and convenient construction, and better use effect etc. the main work in this paper is described as follows : ( 1 ) this paper introduces phylogeny and reseach survey of the joints bridge inland and abroad, and a new jointless bridge structure ? new type semi - integral abutment bridge is based on these, which characteristic of own structure and setting of primary component are expatiated. ( 2 ) this paper analyses influence of temperature effect, creep, shrinkage and circumambient soil of run - on slab on the new type structure, and analyses the forcing performance of beam, abutment and run - on slab of the new type semi - integral abutment bridge, and constrast to the same category joints bridges

    本文主要做了以下工作: （ 1 ）介紹了無縫橋梁在國內外的發展歷史、研究概況，並在此基礎上提出了一種新的無縫橋梁結構形式-新型半整體式無縫橋梁，闡述了它特有的結構形式以及主要構件的設置; （ 2 ）分析了溫度效應、徐變和收縮以及搭板周圍土體對這種新型結構的影響，對新型半整體式無縫橋主梁、橋臺以及搭板進行了受力性能分析，並和同類無縫橋梁進行了對比分析。
  6. A case study for nanning bridge, the first long span unsymmetrical extroversion arch bridge with curve beam in the world is given

    利用幾何方法推導了空間鋼箱拱肋節段拼裝誤差在拱肋最大懸臂端的累積規律。
  7. In the paper, the study of analysis method of internal force for curved - beam bridge structure analyzed by spacial method of curved - bar grillage finite element method is introduced

    本文對彎梁橋採用曲桿梁格有限元法進行空間結構分析時的內力計算方法進行了研究。
  8. Structural strength research for 64 type military - used beam joggle - type bridge layer

    窄幅整體橫移式架橋機在斜交橋中的應用
  9. Statistical analysis of live load on continuous beam bridge of cantilever casting during construction

    懸澆連續梁橋主梁施工活載統計分析
  10. Three - dimensional photoelastic test of beam - arch joint of open spandrel rigid - frame arch bridge

    空腹式剛架拱橋梁拱節點三維光彈性試驗研究
  11. Spatial static behaviors analysis on beam - arch joint of new - type rigid - framed arch bridge with open spandrel

    空腹式新型鋼架拱橋梁拱節點空間受力分析
  12. Prospect dtzziii series weight - load controller sensor part adopt bridge - type strain piece sensor, and applies steady installation technology to insure sensors running steady and long - range. we provide multi - kinds of sensor installation method. sensor can be installed under the car bottom, on elevator rope hitch plate, on car top wheel and axle and car top beam to work together with controller

    前景dtzziii系列稱重控制儀的稱重傳感器部分採用橋式應變片傳感器，應用平穩安裝技術確保長期穩定運行稱重傳感器提供多種安裝方式，可以安裝于活轎底電梯的轎廂轎底電梯繩頭板處電梯轎頂輪軸處電梯轎頂橫樑上面等，與控制儀配合使用。
  13. This paper presents the structural design of the main bridge of lhasa river bridge, makes a deep - going study of the key techniques for design of the bridge, such as the reasonable span length ratio of each span of the 5 - span girder and arch hybrid structure, mechanical behaviour of the dual arch ribs, and section of the continuous girder tie beam, and also works out rigidity and stress conditions of the continuous girder tie beam and stress conditions of the concrete - filled steel tube arches of the main bridge

    摘要介紹了拉薩河特大橋主橋結構設計情況，對於五跨梁拱組合橋梁各孔跨合理的跨度比、疊拱的受力行為及連續梁系桿截面形式等設計中的關鍵性問題進行了深入的研究，給出了主橋連續梁系桿的剛度和應力情況、鋼管混凝土拱的應力情況。
  14. Typically, there are three kinds of different structures of micro - switch : cantilever beam, fixed - fixed beam ( air bridge ) and torsion beam, all of these are actuated by electrostatic force

    常見的開關結構有懸臂梁、空氣橋和扭轉擺三種，目前均採用靜電驅動方式。
  15. The basic theory and step of whole process analysis of reinforced concrete beam section flexural rigidity is stated, the realization program is worked out and the academic example is analyzed. 4. based on the static - state load test result of two practical projects, the application of the reinforced concrete beam system bridge structure disease examination and structure damage evaluation method is stated, and satisfaction result is gained

    1 、綜述了當前混凝土橋梁結構檢測及損傷識別的各種方法體系，並簡要評價了各方法體系的應用與不足； 2 、論述了基於靜載試驗的梁分段剛度系統識別的基本原理，編制了實現程序，並進行了數值算例分析，提出基於本原理的梁橋結構損傷識別與結構評價方法體系； 3 、闡述了鋼筋混凝土梁截面抗彎剛度全過程分析的基本原理和方法步驟，編制了實現程序，並進行了相關算例分析； 4 、結合兩片工程實例梁的靜載試驗，詳述了梁橋結構損傷識別與結構評價方法的應用過程，得到了預期的效果。
  16. Construction of cast - in - place box beam of dongshengbei interchange bridge

    東勝北互通立交匝道橋現澆箱梁施工
  17. Crack analysis and assessment of a pc continuous rigid frame box beam bridge

    大跨徑連續剛構箱梁剪力滯效應分析
  18. In the railroad oblique continual box beam bridge design key question studies

    鐵路斜交連續箱梁橋設計中的關鍵問題研究
  19. In order to get an better control in horizontal displacement of tower top and the internal strength and displacement in beam, the theme take an circulating forth piece together means and get to a good target. the theme carry the theory through bsap program in design of the large highway bridge in anqing and prove the theory of the theme ' s useful and availability

    結合在安慶長江公路大橋的設計工作，論文採用了bsap系列程序有針對性的進行了實際應用，實際生產的使用表明了本文所採用理論與方法的有效性，為斜拉橋施工控制的模擬計算過程提供了一種參考與依據。
  20. Finite element analysis on the cracks on the bottom plate of bridge beam of reinforced concrete

    鋼筋混凝土橋梁底板裂紋成因的有限元分析
分享友人
分享到 Line

分享到臉書