cavity stability 中文意思是什麼

cavity stability 解釋
諧振腔穩定度
  • cavity : n. 1. 【解剖學】穴,窩,盂,腔,空腔;【醫學】(空)洞。2. 【物理學】模槽;氣蝕區;空腔諧振器;【原子能】(反應堆中的)小室,暗盒。
  • stability : n. 1. 穩定,穩定性,穩度。2. (船等的)復原力。3. 鞏固;堅定,持久不變。
  1. Based on the bedding features of weak intercalations in sandstone plates near the top of underground cavity, the probable failure scale of bedding sliding, the probable settlement, the folding places and the critical length of sandstone beams are computed seperately, then the stability of underground cavity is analysed

    針對地下工程頂部層狀砂巖中存在順層發育軟弱夾層的情況,分別對開挖后可能出現的層間滑動破壞范圍、巖板的沉降、折斷和臨界長度進行計算,並分析其穩定性。
  2. The stability output second harmonic generation ( shg ) experiment results of single - longitudinal mode and multi - longitudinal mode with long cavity were explained reasonably with these rate equations. the high polarization of fundamental wave in the isotropic laser media nd : yag with type - i critical phase - matching lbo was studied with the rate equations including polarization of fundamental light. using the polarization function of lbo, a quartz full - wave plate was introduced into the cavity, a kind of birefringent filter by considering the combination of the polarization function of the type - i critical phase - matching doubling frequency crystal lbo and the quartz whole - wave plate was constructed

    將腔內多縱模倍頻速率方程推廣應用到準三能級藍光激光器中,分析了一個縱模、兩個縱模、多個縱模時的噪聲情況,合理地解釋了實驗中激光器單縱模運轉以及長腔多縱模運轉時穩定輸出的實驗現象,同時利用該速率方程分析了以各向同性激光晶體nd : yag為工作物質,類臨界相位匹配lbo為倍頻晶體的藍光激光器中基頻光偏振特性,合理利用類臨界相位匹配lbo倍頻晶體的偏振特性與引入的石英晶體全波片構成雙折射濾光片,通過選單頻來抑制噪聲,獲得了藍光低噪聲的穩定輸出。
  3. Three - dimensional numerical simulation of surrounding rock stability of underground cavity with variable cross - section

    變截面洞庫圍巖穩定性的三維數值模擬
  4. 2. we design a configuration of frequency - doubler according to the optimum focus condition and the cavity stability condition | a + d | < 2 and optimize it based on " mode - matching " and " optimum coupling ". 99. 96 % of optical impedance - match efficiency and over 95 % of spatial mode - matching efficiency are achieved eventually by using t = 10 % of input coupler in our experiment

    ( 2 )根據最佳聚焦條件和腔的穩定性條件( | a + d | 2 )對四鏡環型倍頻腔進行了設計,並分別從「模式匹配」和「最佳輸入耦合鏡透射率的選擇」兩方面著手對腔進行優化,在我們的實驗中採用10的輸入耦合鏡,獲得阻抗匹配效率為99 . 96 ,空間模式匹配效率高於95以上的模式。
  5. The nonuseful loss of cavity were got by measuring the threshold of laser under the different output mirrors. the loss was caused by prague angle unmatching. 3. the pulse train with minor pulse width 22ns and frequency 23khz, peak power 3. 5kw were obtained in cr4 " : yag passively q - switch experience. the stability of pulse is 6 %

    ( 3 )實現了在大功率泵浦、無水冷的情況下cr ~ ( 4 + ) : yag飽和吸收體被動調q ,得到了最小脈寬為22ns 、重復頻率為23khz 、峰值功率為3 . 5kw的激光脈沖輸出,脈沖的穩定性為6 。
  6. By using this system, we would not need to do complicated things. it can show us the result quickly and exactly. so it is a good way for engineering people to study the the stability of block of underground cavity

    本方法能夠得出塊體穩定性分析的確定性結果,開發出的軟體可以代替煩雜的手工勞動,並且準確率很高,為地下洞室的塊體穩定性分析提供了一種準確快捷的途徑。
  7. By means of controlling accurately temperature of f - p cavity used in the frequency - stabilizing system of laser, the frequency stability of laser is significantly improved. especially the long - term unidirectional frequency shift is essentially overcome

    從實驗結果,我們得出將作為頻率標準的f ? p腔精密控溫與對該腔不控溫對激光器振蕩頻率進行鎖定的結果相比較,清楚看到短期穩定性有一定提高,重要是對作為穩頻標準f ? p腔精密控溫,消除了由於溫度變化引起的頻率慢漂移。
  8. Firstly, the oscillator theory was researched as the base of the design of oscillator - type aia in this paper. the derivation of oscillation condition and stability condition were given ; at the same time, the cavity modeling theory of microstrip antenna was studied, which gave the relation between the size of microstrip antenna and the resonate frequency and that between the size and impedance of microstrip antenna

    首先,針對本文所討論的振蕩型有源集成天線,作為理論基礎,進行了振蕩器理論的研究,推導出有源集成天線的振蕩條件和穩定條件;同時利用空腔模理論,給出了天線尺寸與諧振頻率和輸入阻抗的關系。
  9. Stability analysis of the weak intercalation and stratified rock mass near the top of an underground cavity and their parameters ' inversion

    地下洞室頂部軟弱夾層和層狀巖體的穩定性分析及參數反演
  10. In the paper, we put forward the combination of micro electronic technology, mems technology and vacuum micro electronic technology to develop a micro electronic pressure sensor with overload protection. the pressure sensor consists. of elastic anode membrane, isolation layer, vacuum micro cavity and field emission catelectrode tip array with overload protection. such pressure sensor has many advantages, such as high temperature stability, radiation resistance, fast response, high sensitivity, small volume, simple secondary instruments and bulk production

    本文在重慶市科技「十五」項目的資助下,提出利用微電子技術、 mems技術和真空電子技術相結合的方法,研究一種帶過保護功能的真空微電子壓力傳感器,該壓力傳感器由帶過保護的場致發射陰極錐尖陣列、彈性陽極膜、絕緣層、真空微腔所構成,具有溫度穩定性好、抗輻射、快響應、高靈敏、體積小、二次儀表簡單、可批量生產等優點,具有廣泛的應用市場。
  11. The third, some groping researches are made on broadband coaxial line filter output circuit of klystron. a broadband output circuit - mode four coupling slots double - gap output cavity loaded with coaxial filter, which has a workable relative bandwidth bigger than 14 % and fits in with l - band multi - beam klystron, is designed. meanwhile some analysis of its stability and peak power capacity is made

    第三,對速調管同軸線濾波器寬帶輸出迴路進行研究和探索,設計出了一個適合用於l波段多注速調管、相對帶寬超過14的四耦合槽模強耦合雙間隙腔加載同軸線濾波器輸出迴路,並對其穩定性和峰值功率容限做了一些分析。
  12. The resonant box effect is the most important. in chapter five, we use the experimental setup constructed and the cavity decay time method to measure the total loss of a passive resonant cavity, and analyse the experimental data in very detail. we conclude that, in present experimental conditions it is the uniformity and stability of laser mirror to confine the precision and repeatability of experimental results

    第五章在建立起了連續光波時間衰減法測量裝置的基礎上,進行了無源諧振腔總損耗的測量,仔細分析了實驗過程中的誤差因素,並指出在目前的實驗條件下限制測量精度和重復性的主要原因是激光鏡片的均勻性和穩定性不理想。
  13. The high - voltage isolation optocoupler has been developed successfully, and its characteristics have been analyzed, it has some excellent merits, such as simple structure, working on stable status and high speed and so on. it will be extensive applied in high - voltage working environment extensively. 3 ) adopt hollow taper cavity to conduct the light in order to improve the stability and reliability of the high - voltage isolation and linearity optocoupler that can ’ t run very well

    3 、針對高壓隔離線性光電耦合器的穩定性、可靠性不佳的狀況進行研究,提出了解決辦法,設計了空心錐腔進行導光,研製出了高穩定性、高可靠性的高壓隔離線性光電耦合器,對該器件的性能進行了分析,與改進前相比,穩定性、可靠性都有較大提高。
  14. 4. the fundamental principles of both the linear cavity fiber laser and the ring cavity fiber laser and the stability criterion for multiwavelength oscillations are introduced. several kinds of techniques to achieve mulitwavelength oscillations are summarized

    4 .介紹了線形腔光纖激光器和環形腔光纖激光器的基本理論以及多波長激光器穩定振蕩的條件,並總結了幾種實現多波長摻鉺光纖激光器的穩定振蕩的方法。
  15. Dynamic balance process and instability process of rock - salt cavity roof are studied, and instability mechanism of rock - salt cavity roof is studied with catastrophe theory, and the influencing factor are analyzed, which will be theoretical basis of rock - salt cavity stability control

    為此,分析了巖鹽溶腔頂板動態平衡過程及失穩發展機制,並利用突變理論研究了巖鹽溶腔頂板失穩機理,探討了溶腔頂板穩定性的影響因素,從而為溶腔穩定性拉制打下一定的理論基礎。
  16. The stiffness of the bolts are added to the integer stiffness matrix. 44 5. the above theories are applied in the stability analysis of the 5 machine set of pubugou hydropower underground cavity group

    將錨桿的勁度加入到系統的整體勁度矩陣中,直接而又比較客觀的反映了錨桿對巖體的加固效果,並推導了相應的理論公式。
  17. And it also can not give the exact appearance place. aiming at this question, basing on studying the underground cavity in laxiwa hydroelectric station, through establishing entity model, combining model, slicing model, and vector analysis, article introduce a method of analyzing the stability of block and get the certain search. all the graph result is showed in autocad, which is a graph software

    針對此問題,本文以拉西瓦水電站地下洞室為研究場所,以autocad圖形軟體為平臺,建立地下洞室和結構面的實體模型,通過對實體模型的組合、剖切獲取結構面的洞頂及洞壁展示圖,再以結構面展示圖為基礎,應用矢量運算對塊體進行穩定性分析,並在autocad中顯示結構面展示圖和塊體展示圖。
分享友人