chamber gas 中文意思是什麼

chamber gas 解釋
鉛室氣
  • chamber : n 1 〈古、詩〉室，房間；寢室，臥室；〈pl 〉套房；〈pl 〉律師[法官]辦公室。2 會議室，會場；議會，...
  • gas : n （pl gases ）1 氣，氣體，氣態 〈cf fluid; solid〉 2 可燃氣，煤氣，沼氣；【礦物】瓦斯。3 【軍事...
  1. On august 7, 2003, after being thrown into a gas chamber to be euthanized along with other unwanted or unclaimed dogs at a city animal shelter in st. louis, missouri, usa, it seemed that a year - old basenji mix had run out of luck and time. but this pup had other ideas

    2003年8月7日，在美國密蘇里州聖路易的市立動物收容所中，一隻巴辛吉混種狗連同其他被棄養的狗兒，一起被丟入毒氣室接受安樂死，這只一歲大的混種狗似乎已沒有生還的機會了，但這只小狗卻不向命運投降。
  2. A gas-filled ionization chamber uses this principle.

    充氣電離室就是利用這一原理。
  3. The room was empty, and under the flare of the gas a solitary chamber pot stood forgotten among a heap of petticoats trailing on the floor

    屋子裡闃無一人，在煤氣燈光下，僅有一隻被人遺忘的便壺，放在被人胡亂扔在地上的裙子中間。
  4. Who ' s one fingerprint check away from the fast track to the gas chamber like i am

    只要一查指紋就會被直接送上絞刑架
  5. Everyone hopes the serial killers gets the gas chamber

    大家都希望將那連環殺人犯送進毒氣室。
  6. The murderer was executed in a gas chamber

    凶手在毒氣室被處死。
  7. Faiiure to answer wiii resuit in the gas chamber. do you understand

    答不出來的會被送到毒氣室.明白
  8. I helped you out of a tough spot. spared that long walk to the gas chamber room

    我幫你逃出過困境。讓你免於毒氣室的死罪。
  9. P36 gas furnace ; combustor ; sit valve chamber ; pulse ignition ; ceramic simulation wood ; simulation ceramics ashes, straight safety mini crystal ceramics glass ; flame regulator

    P36天然氣爐體; ；燃燒室； sit閥體；脈沖點火器；陶瓷模擬木材；陶瓷模擬灰燼，平直微晶陶瓷安全玻璃；火焰調節器。
  10. P33 - ng3 north american standard gas furnace ; combustor ; sit valve chamber ; electric pressure ignition ; ceramic simulation wood ; simulation ceramics ashes, safety mini crystal ceramics glass ; flame regulator

    Ng3北美製式天然氣爐體；燃燒室； sit閥體；壓電點火器；陶瓷模擬木材；陶瓷模擬灰燼，微晶陶瓷安全玻璃；火焰調節器。
  11. P48 - ng north america natural gas furnace ; combustor ; sit valve chamber ; pressure ignition ; ceramic simulation wood ; simulation ceramics ashes, straight safety mini crystal ceramics glass ; flame regulator

    Ng北美製式天然氣爐體; ；燃燒室； sit閥體；壓電點火器；陶瓷模擬木材；陶瓷模擬灰燼，平直微晶陶瓷安全玻璃；火焰調節器。
  12. The structure and operating principle of an air - charged split - type adjustable shock absorber was described, e non - linear parameterized mathematical model of this shock absorber ' s damping characteristics was established according to fluid mechanics theory and the main structural affection factors to shock absorber ' s damping performance, such as the diameter of piston valve orifice, the diameter of adjustable orifice, the initial volume of gas chamber, the diameter of piston rod, the inner diameter of oil pipe and so on, were analyzed by simulations

    摘要通過分析一種分體式充氣可調阻尼減振器的結構和工作原理，運用流體力學理論，建立了該減振器阻尼特性的非線性參數化模型，模擬分析了活塞阻尼閥孔徑、阻尼調節孔徑、氣室初始體積、活塞桿直徑、油管內徑等主要結構參數對減振器阻尼性能的影響，通過試驗測試，得到了減振器樣件的阻尼特性及其可調范圍。
  13. Experimental studies were conducted at the yucheng comprehensive experimental station of the chinese academy of sciences during the period from march to june in 2003. respiration of a pulverous sandstone soil was studied under cultivation of winter wheat over a growth season. soil ch4 was measured by the static - chamber method combined with gas chromatography ( gc ) technique. the results indicated that the soil of winter wheat field in rapid growth season is a weak sink of ch4

    本文利用靜態箱氣相色譜（ gc ）分析的方法，在中國科學院禹城綜合試驗站，對華北平原冬小麥生長旺季期間麥田土壤中ch _ 4氣體通量進行了測定，試驗起止時間為2003年3 6月，得出華北平原典型冬麥田土壤是大氣ch _ 4的弱吸收匯。
  14. Influence of ktb place on gas flow field in rh vacuum chamber

    真空室氣體流動的影響
  15. But the temperature difference at the vertical direction in combustion chamber in lead column, that is said by operator, is over 60 ?. ( 2 ) according to the experiences in the practice, the second layer air and the second layer gas had a little effect of support burning, and the third air has little effect for combustion, and the power to drawing exhaust gas can only be adjusted in limited range. the problems, it is said above, restricted more advance of some kinds of technology and economy target in spelter refining in new jersey furnace

    由於鋅精餾爐產量提高，一些問題開始暴露出來： （ 1 ）燃燒室?舶要求溫度差不超過10 ，而從現場反映的情況來看，燃燒室上、中、下部溫度差已超過60 ； （ 2 ）在生產實踐中，發現燃燒室第二層空氣、第二層煤氣作用甚小，第三層空氣失去助燃作用，廢氣出口的抽力可調范圍有限；以上這些問題在客觀上制約了精餾塔在鋅精煉中各項技術經濟指標的進一步提高。
  16. By arrangement of the control channels through which the hydraulic fluid flows from the discharge chamber into the oil reservoir, this allows any gas bubbles being released from the hydraulic fluid during the suction stroke to be expelled into the oil reservoir

    通過液壓油經控制通道由排出腔流入油槽的這種布置，使得任何在吸入沖程從液壓油中釋放出來的氣泡都被排到油槽中。
  17. The simple thoron chamber consists of three parts, they are the thoron accumulation box, the circuit of thoron source input and gas circulation, the circuit of thoron level measurement in the thoron accumulation box

    簡易（氣土）室由（氣土）積累箱、充源循環迴路、積累箱中（氣土）水平標定迴路三部分組成。
  18. Exemoo has developed a reputation for excellence in every area of industrial furnace design, construction, and installation. each job whether a small re - brick or the design and construction of a completely new system is individually tailored to the customers specific needs. our engineers are involved in every step of the process and our crews are specially trained to inspect all jobs to ensure the highest level of quality control. exemoo has worked with our french joint venture partner to bring their advanced technology to the products made in our china facility. these products include : double chamber gas or oil quenching vacuum furnace, low pressure vacuum nitriding furnace, high pressure sintering furnace, etc. we have gained iso9001 accreditation with registration number 0205q15647r0s

    易西姆公司在吸收法國技術基礎上，在中國實現國際先進的不同類型的真空爐設計與製造，以向中國客戶提供性價比優性能可靠的各種真空爐，並且致力於各種真空爐的銷售設計生產新工藝與新技術的研發，以及自動化生產線設備與工程的總成，在低壓真空滲碳爐真空高壓氣淬爐真空壓力燒結爐，低壓真空滲氮爐，以及真空爐自動化生產線方面，在國內乃至國際上都處于領先地位。
  19. Horizontal two chamber gas quenching vacuum furnace

    臥式雙室真空高壓氣淬爐dgf系列
  20. This essay has touched upon the following work : 1. has built up theoretic models including static mathematic models of air compressor, combustion chamber, gas turbine, waste heat recovery boiler and steam turbine which are deduced according to the feature and theory of the equipment of the object of study. upon establishment of each model based on the actual conditions, a method of multiple imitation and combination is applied to parts which have already got characteristic curves to have achieved quite accurate curves whilst the method of neural net is applied to the parts which have no characteristic curves for establishment of models

    本文進行了以下的主要工作：建立理論模型，根據對象的實際設備的特點和理論關系推導壓氣機、燃燒室、燃氣輪機、余熱鍋爐、汽輪機的靜態數學模型；根據本研究的實際情況，在建立各部件模型時，對已有特性曲線的部件，採用多項式擬合的方法，得到較為準確的特性，而對部分沒有曲線的特性，則採用神經網路的方法建立模型。
分享友人
分享到 Line

分享到臉書