change in microstructure 中文意思是什麼

change in microstructure 解釋
顯微構造變化
  • change : vt 1 改變，變更，變換，變革。2 交換；兌換；把（大票等）換成零錢；把（支票等）兌成現金。3 換（車、...
  • in : adv 1 朝里，向內，在內。 A coat with a furry side in有皮裡子的外衣。 Come in please 請進來。 The ...
  • microstructure : n. 顯微結構，微觀結構〈如金屬或合金放在顯微鏡下所看到的結構〉。
  1. The change of microstructure of intramuscular connective tissue in response to the tension stress during limb lengthening

    肢體延長中張應力對肌間結締組織顯微結構的影響
  2. The result shows that with the addition of rare earth elements, ultrasonic irradiation and magnetic field, the chemical component, surface configuration, microstructure and properties of electroless co - ni - b and co - fe - b alloy changes remarkably. such kind of change can be described as the followings. firstly the depositing speed of electroless alloy bath is raised while the polarizability and cathodic overpotential are reduced ; secondly the surface quality of the alloy coating and adhesion of the coating and matrix are improved ; thirdly in the coatings the content of the elements in the transient group increases, but the content of cobalt decreased ; fourthly the amorphous structure is transformed to microcrystal structure and polycrystal structure ; fifthly the microhardness and wear resistance of the coating are enhanced ; sixthly coercitive force is reduced, and magnetoconductivity of the coating is increased ; lastly the magnetic intensity of the coating increases with the addition of energy and light rare earth elements such as ce, la and decreases with the addition of heavy rare earth elements such as y. on the other side, when the alloy coatings passes through the heat treatment under the temperature of 250 or 500, their properties will change

    結果顯示化學沉積co - ni - b 、 co - fe - b工藝在稀土元素（ ce 、 la 、 y 、 dy ） 、能量（超聲波、磁場）介入后，沉積過程、合金成分、鍍層形貌結構和性能都有顯著變化，表現在：鍍液的陰極極化過電位和極化度降低，沉積速度提高；鍍層的結合力、表面質量改善；鍍層中過渡族元素的含量增加，輕元素硼的含量降低，同時證實了稀土元素與過渡族元素共沉積的可能性；鍍層的顯微結構由非晶態向微晶和多晶態轉變；鍍層的顯微硬度與耐磨性提高，力學性能優化；鍍層的矯頑力降低；磁導率提高；鍍層的磁化強度在能量（超聲波、磁場）和輕稀土元素ce 、 la介入后提高，重稀土元素y介入后降低。
  3. The results indicate that hp can promote the toughness and strength of cement mortar and concrete, and with the increase in hp mixture, compressive strength increases more obviously than bend resistant strength does ; with the hydrosoluble hp fibre added, the microstructure of mortar or concrete will change, the space web structure will be formed, which consists of mixed hydrates and hp films. as a result, the performance of mortar and concrete, with high strength and few apertures, can be improved

    結果表明， hp對水泥砂漿和混凝土有顯著的增韌、增強作用，且隨著hp摻量的增加抗壓強度提高的幅度增大，抗折強度提高的幅度降低； hp水溶性高分子纖維的加入可改變混凝土的微觀結構形態，在混凝土或砂漿中形成了水化產物與hp膜交織的空間網狀結構，使漿體緻密，減小孔隙率，從而影響其整體性能。
  4. The result of md simulation means that : ( 1 ) the microstructure in the amorphous carbon has no obvious change, the slippage which is parallel to the fiber axes in the graphite slices of the pyc interphase was found ; ( 2 ) bulk moduli of every part of interphase diminished, young ' s moduli in all three direction of amorphous carbon diminished, young ' s moduli of the graphite slices in the direction of parallel to the fiber radial decreased, and ones in the direction of parallel to the fiber axes increased

    分子動力學模擬結果表明， （ 1 ）界面相內部無定形碳部分微結構無明顯變化，石墨片層部分沿纖維軸向滑移； （ 2 ）界面相模量發生變化，界面相區域各部分的體積彈性模量降低，無定形碳部分及石墨片層部分垂直於纖維軸向的楊氏模量降低，平行於纖維軸向的楊氏模量升高。
  5. Change in microstructure of salty soil during crystallization

    析晶過程中鹽漬土的微觀結構變化
  6. The wearing resistance, microstructure, worn surface morphology and hardness change in wearing end - face and non - wearing end - face of cr - mn - cu alloy white cast iron were tested and analyzed

    摘要對鉻錳銅合金白口鑄鐵的耐磨性、無磨損端面及磨損端面的微觀組織、磨損形貌及硬度進行了試驗和分析。
  7. Microstructural change and thermal shock performance of metal / ceramic graded thermal barrier coatings in thermal shock experiments were studied by scanning electron microscope and energy - dispersive spectrometry. the results showed : 1 ) metal microstructure kept intact while ceramic microstructure had been destroyed ; 2 ) thermal shock performance of coatings was interrelated with its function to relax residual stresses, therefore thermal shock performance of gradient thermal barrier coatings was better than that of terraced thermal barrier coatings ; 3 ) thermal shock performance was concerned with metal content in metal / ceramic thermal barrier coatings, which would be improved when metal content was increased

    利用掃描電子顯微鏡和能譜成分分析技術研究了金屬/陶瓷梯度熱障塗層在熱震過程中的顯微組織變化及其抗熱震性能.結果表明： 1 ）金屬顯微組織保持完好，陶瓷顯微組織有明顯的破壞； 2 ）塗層抗熱震性能與其熱應力緩和功能密切相關，梯度熱障塗層比階梯熱障塗層具有更高的抗熱震性能； 3 ）金屬/陶瓷熱障塗層抗熱震性能與其中金屬相含量有關，金屬相含量增加可改善塗層抗熱震性能
  8. There are better performances in the films prepared by ba2ca2cu3ox target than by ba2cacu2ox target. the single - phase tl2ba2cacu2o8 hts thin film was obtained with a tc0 of 107k at the optimal tl2o partial pressure and thallination temperature 750. on excursion from the optimal conditions, there exist some impurities in the resultant films resulting in a reduction in tc0 and surface quality with change in the microstructure morphology

    研究結果表明，採用成分為ba2ca2cu3ox的靶材制備的薄膜性能要優于成分為ba2cacu2ox的靶材；使用組成式為tl1 . 9ba2ca2cu3oy的鉈片做鉈源時，形成的tl2o分壓達到最佳值；在最佳tl2o分壓和最佳鉈化溫度750的條件下，制備出了純相完全c軸取向的tl2ba2cacu2o8高溫超導薄膜，其tc0高達107k ，膜面均勻平整光滑，呈圓片狀組織；偏離最佳制備工藝參數的條件下，制得的薄膜中都含有一定量的雜相，雜相的生成使得tc0值下降，薄膜表面質量下降，薄膜組織形貌發生變化。
  9. Through the analysis of the evolution of the microstructure, the honey comb at the grain boundary and the pool in the grain, furthermore according to the phase change thermodynamic and kinetics, the conclusions of the globalization mechanism and the reheating parameters were drawn as follows. 1

    通過對半固態再結晶和半固態熔化過程中的組織轉變、晶界蜂巢及晶內液池現象的分析，結合相變熱力學和動力學原理，提出sima法制備鎂合金半固態球狀化組織的形成機制及工藝參數。
  10. In this dissertation, on the basis of researches on the mechanisms of electrorheological effect and the change in microstructure of composite dispersion under the applied electric field. the theoretical analysis to rheo - optic characteristics of an electrorheological fluid under an electric field is first conducted systematically. the light - controlling properties of an electrorheological fluid is ev aluated and an intelligent structure of electrorheological fluids - based smart windows ( erfsw ) is proposed and designed at the first time

    本論文在研究雙相復合懸浮液電流變效應機理，及場致微結構變化特徵的基礎上，首次對電流變體流變光學特性進行了較深入的理論分析，並對電流變體的光學調控特性進行測試，從而首次提出並設計了光學特性動態可調的電流變體靈巧窗（ electrorheologicalfluids - basedsmartwindow ， erfsw ）智能結構，為電流變體應用研究提出了一條新思路，開拓了電流變體在靈巧窗智能結構等方面的應用。
  11. Change of the hippocampus ultra - microstructure and protective effect of ligustrazine in chronic hypoxia - hypercapnia rats

    2致大鼠海馬超微結構改變及川芎嗪的保護作用
  12. The results showed that the interplanar spacing d values and relative x - ray diffraction intensity of the mixed lb films change with the ratio of ba / sa in a step - and w - shaped curve respectively, which indicates that only three kinds of longitudinal periodic structures can form in the mixed multilayer lb films of all ratios and each microstructure can be maintained in a certain ratio range. furthermore the mixed system always goes through a process of the longitudinal regularity decreasing when the ratio of ba / sa is out of the intermediate ratio range ( ba / sa : 1 / 5 ~ 1 / 1 )

    結果發現，對于sa ba混合膜，分相小而均勻，不出現單獨的衍射周期；隨比例不同，縱向面間距出現臺階效應，表明存在3類結構，其中在較大比例范圍內出現了長短鏈交錯的結構，這種結構具有高的穩定性和有序性；在ba較多的混合膜中，在脂鏈層間出現空洞結構，可以用來構造特殊的納米結構。
  13. Surface hardness is strengthened by use of plasma nitriding technique to change microstructure of mould surface. on the basis of that, the major research works accomplished in this paper are as follows. hardness, resistant attrition, fatigue strength, resistant erode and resistant die burn of the materials are enhanced and the life of the mould is increased by five to ten times

    本人根據近年來模具工業的快速發展，模具的表面工程越來越受到普遍重視，利用等離子滲氮技術可以改變模具表面的組織結構使表面硬度得到強化，提高了材料的硬度、耐磨性、疲勞強度、抗腐蝕能力及抗燒傷性，使模具的壽命提高5 - - 10倍。
  14. The change regularity for performance and microstructure of low carbon steel is summarized. the main characteristic of the process is pearlite spheroidizing, increasing of grain boundary width, element segregation and carbide in grain boundary. the change of those microstructure causes the variance of the merchant performance

    通過上述的研究工作，總結了火力發電廠用低碳鋼在長期運行期間性能與微觀結構的變化規律，提出以珠光體球化、晶界寬化、元素晶界偏聚及碳化物晶界析出為主要特徵的低碳鋼微結構變化規律，以及由此而引起的材料機械性能的變化。
  15. The change in microstructure and structure of the coating before and after wear have been investigated sem. the difference between nickel - iron alloy coating and nickel coating in wear - resistance is due to the effect of iron upon the oxidation and its products

    Ni - fe合金鍍層與ni鍍層耐磨性的差別是由於fe對氧化過程及產物的影響，搞清了ni - fe合金鍍層。
分享友人
分享到 Line

分享到臉書