charge and discharge system 中文意思是什麼

charge and discharge system 解釋
充放方式
  • charge : vt 1 填；裝（子彈）；充（電）；使飽和；使充滿；堆積，裝載。2 命令；促；諭示，指令。3 責備；告誡。...
  • and : n. 1. 附加條件。2. 〈常 pl. 〉附加細節。
  • discharge : vt 1 發射（炮等），打（槍），射（箭）。2 起，卸（貨）。3 排泄，排出，放出（水等）。4 釋放；解除，...
  • system : n 1 體系，系統；分類法；組織；設備，裝置。2 方式；方法；作業方法。3 制度；主義。4 次序，規律。5 ...
  1. In the first part of this paper, mn ( iii ) / mn ( ii ) couple in h2so4 was firstly applied as the positive couple to this system, i. e. redox flow cell. its chemical, electrochemical properties, redox kinetics and related parameters were characterized and discussed by rotating disc electrode ( rde ), cyclic voltammetry ( cv ), a. c. impedance ( a. c. imp ), chronoamperometry, tafel curve, and galvanostatic charge / discharge techniques. conclusions have been drawn as follows : 1. the electrochemical kinetics of mn ( iii ) / mn ( ii ) redox couple in 6. 3m h2so4 solution were studied by means of rotating disc electrode ( rde ) technique on platinum electrode

    本文第一部分首次成功地將酸性介質中的mn （ iii ） / mn （ ii ）電對應用於氧化還原液流電池這一新型儲能裝置的正極活性材料，通過旋轉圓盤（ rde ） 、循環伏安（ cv ） 、交流阻抗（ a . c . imp ） 、恆電位階躍、 tafel實驗以及mn （ iii ） / mn （ ii ）單電極的恆流充放電實驗，我們得出以下結論： 1 .在旋轉圓盤電極上，不同轉速范圍，不同的極化過電位， mn （ ） / mn （ ）體系氧化還原電極過程的控制步驟不同，電荷傳遞、擴散傳質可分別或聯合成為控制步驟。
  2. 4. through the galvanostatic charge / discharge experiments with different schedules, it was found that mn ( ) / mn ( ) in acidic media as half - cell in a novel redox flow system is practically feasible in that it has such advantages as low cost, high open voltage, a certain coulombic efficiency with low charge / discharge current, and long cycling life. in the second part, cosn alloy and cu - sn samples were synthesized firstly by h2 - reduction following solid - state reaction between co ( ii ) 、 cu ( ii ) 、 sn ( iv ) 、 and naoh at ambient temperature

    並研究了其分別作為鋰離子電池陽極材料在1mol / llipf6 / ec + dmc電解液中的恆流充放電性能，各樣品均存在較大的首次不可逆容量損失； 10個循環內cu - sn可逆放電容量可保持在280mah / g以上，而第十周時cosn 、 cu6sn5的可逆放電容量分別為50mah / g和60mah / g 。
  3. The charge and discharge performances of different composites were studied by the charge and discharge ; the structures of composites were characterized by sem ; the electrochemical properties of sulfur positive materials were characterized by cyclic voltammetry and eis. we studied the charge process, discharge process, charge - discharge efficiency, self heat, and self - discharge of lithium - sulfur system on system shuttle constant, conduct the mechanism of these processes and simply analyse them

    以充放電技術研究了不同類別復合正極的充放電性能;以掃描電鏡技術觀測了復合正極的表面形貌;以循環伏安技術和交流阻抗技術研究了復合正極電極的電化學性能;並初步探討了鋰-硫電池體系中充電過程、放電過程、充放電效率、自熱和自放電等對體系飛梭常數的影響，推導了這些過程的機理並簡要的進行了分析。
  4. If one cell fails, the whole battery fails. with use the normal battery management system, the difference between cells enlarge. it " s recommend that a cell management system which embedded a powerful microchip to manage the charge and discharge of cell will solve this problem well

    本文分析不一致性對蓄電池使用過程中的影響，試驗驗證不一致性隨著使用次數的增加而增大，造成在充電過程中，充電不均衡，容量未充足的電池在放電中過放電，造成了惡性循環，縮短蓄電池的壽命。
  5. 1. polybenzidine ( pbz ) was polymerized by using chemical method in organic system and with ( nh4 ) _ 2s _ 2o _ 8 as oxidant, hclo4 as dopant. the electrochemical behaviors of pbz electrode were studied by cyclic voltammetry, charge - discharge test and electrochemical impedance techniques

    1 .用化學直接氧化法在乙腈溶液中，以高氯酸為摻雜劑制備了聚聯苯胺，用循環伏安，交流阻抗，直流充放電對其電容行為進行了研究，聚聯苯胺電極比電容為150f / g 。
  6. The peripheral circuit includes charge and discharge circuit of permanent magnetic actuator ( pma ), extended circuit of memory, interface circuit of keyboard and display system, and interface circuit of input and output signal

    外圍電路包括永磁機構充、放電電路、存儲器擴展電路、鍵盤和顯示介面電路、輸入和輸出介面電路等。
  7. With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style

    控制器軟體採用實時多任務機制和模塊化的設計思想，通過對蓄電池化成充放電過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測，實現對蓄電池靜電、恆流、恆壓限流等多種充放電工作方式的控制。
  8. Design and realization of charge and discharge test system for notebook pc

    筆記本電腦充放電測試系統設計和實現
  9. This thesis researches hardware and arithmetic software scheme of an embedded controller system, which can control four charge / discharge devices and operate in distributed architecture

    本文研究一種具有多迴路、嵌入式特點的蓄電池化成充放電控制器的硬體實現方案和軟體控制演算法。
  10. Though it has complete technique and low price using that two method of rectifying, it also has many disadvantages. so, high frequency, high efficiency and small volume. a high - efficiency, high - power and energy - saving pwm storage battery charge and discharge system is presented in this paper

    傳統的充電機大多採用直接整流或晶閘管整流，雖然技術成熟、價格低廉，但存在許多缺點。為此本文針對實際需求，對pwm蓄電池充放電系統進行研究，設計了一種高效、高功率、節能的蓄電池充放電系統。
  11. The four units of unwind charge discharge and unwind adopts closed loop tensile control system which is composed floating roller and ac vector motors ( seven motor tensile control system )

    放卷、進料、出料、收卷採用擺動輥和交流矢量電機組成的閉環張力控制系統（ 7臺矢量變頻馬達） 。
分享友人
分享到 Line

分享到臉書