cladding mode 中文意思是什麼

cladding mode 解釋
包層模
  • cladding : n. 【物理學】鍍；包層。
  • mode : n 1 法，樣，方法，方式。2 模，型；樣式，體裁，款式；習慣。3 風尚；〈the mode〉流行，時髦。4 【語...
  1. First, we use a simple three - layer - model to gain the expressions of the electric field of cladding mode and its dispersion equation, at the same time, we present the expressions of the electric field of the core mode and its dispersion equation

    因為要考慮包層模，所以首先用光纖的三層模型得到包層模的場分佈和色散方程，同時也給出單模光纖纖芯基模的場分佈和色散方程。
  2. Then we deduce the couple - mode equations that describe the mode coupling behaviors in this kind of gratings. based on this, we study the photosensitive inner cladding ' s influence on the core - mode - core - mode coupling and the core - mode - cladding - mode coupling in this kind of grating. a fiber bragg grating was experimentally fabricated with this kind of photosensitive fiber

    然後以第二章給出的耦合模理論為基礎，結合用帶光敏內包層的包層模抑制光纖的結構特性，推導出用這種光纖製作的光纖布拉格光柵的耦合系數和耦合模方程。
  3. Cladding mode ' s characteristic and its affects on transmission spectrum of long period fiber gratings

    長周期光纖光柵中纖芯導模與包層模耦合分析
  4. The side mode suppression ratio about 39db is realized. 5. a tunable cladding - pumped yb3 + - doped fiber laser system is reported

    55 m可調諧光纖光柵外腔半導體激光器，得到調諧范圍為7nm 、邊模抑制比達39db的激光輸出。
  5. Cladding mode stripper

    包層模清除劑
  6. Using large - area - mode yb3 + - doped photonics fiber, we realized laser operation and analyzed its output properties. the laser is cladding pumped and the output power is 2. 6w, with wavelength of 1074. 5 nm and slope - efficiency 54 %

    在選用二色鏡作為激光器后腔鏡的實驗中，在泵浦功率7 . 8w時獲得了2 . 6w激光輸出，波長為1074 . 5nm ，斜率效率為54 % 。
  7. The paper is concerned with the eigen functions of optical fields in dielectrics, the theories of optical waveguide eigen mode, the characteristics of optical waveguides diffracted field, the theories of mode coupling in optical waveguides and the spectral response theories and simulating method for arrayed waveguide grating. in this paper, a set of beam propagation theory based on eigen modes analysis is set up which afforded theoretical basis for designing and analyzing awg devices. experiment of fabricating sio _ ( 2 ) layer by using porus silicon is also carried out in this paper, which is a new method for fabricating waveguide cladding layer

    本文以設計陣列波導光柵器件為目標，對介質波導光場的本徵波函數，光波導本徵模理論，光波導衍射場特性，光波導模式耦合理論和awg器件的光譜響應特性及模擬方法進行了深入研究，建立了一套基於本徵模式場分析的光波導光束傳輸理論，為波導器件的設計提供正確的理論基礎，並嘗試了利用多孔硅生長厚的二氧化硅，用於製作波導包層材料。
  8. Details of dcfs with the rip is analyzed, including the relation of dispersion and wavelength, variation of dispersion in the c - band, cutoff wavelength of the basic mode, distribution of scalar field and power, macro - bending loss at 1550nm. based on the optimized rip, impaction of radius of core and width of depressed cladding is studied. at the s ame time, a wavelength devision multiplexing system is designed

    接著對這種結構的光纖作了分析，包括它的色散與波長之間的關系，色散在c - band的變動范圍，標量場的分佈，基模在光纖中的功率分佈，在1550處的宏彎損耗等。
  9. In modified fiber - optic sensing system, quantitative analysis of the interaction of the analytes with the cladding is the theoretical foundation of fiber - optic mode - filtered light chemo - and bio - sensing. in our study, we took example for the fused silica fiber that we used, to deduce a mathematical expression for mfld

    在修飾光纖體系定量獲取模式濾光信號的理論研究中，我們以我們所用的石英光纖為例，推導了光纖模式濾光信號的理論表達式。
  10. In chapter 3, fiber bragg grating fabricated with cladding mode suppression fiber is studied

    第三章研究用包層模抑制光纖製作的光纖布拉格光柵。
  11. Splicing between single - mode fiber and pcf are theoretically and experimentally investigated. the fiber bragg grating is written in grapefruit pcf. the multi - wavelength resonances are observed in the grating, and theoretical analysis shows that this phenomenon is caused by the resonances between core modes and cladding modes

    建立了光子晶體光纖和普通光纖的熔接方法，在柚子形光子晶體光纖上寫制了布拉格光柵，觀察到多波長諧振現象，理論分析表明這是由於纖芯基模和包層模之間的諧振造成的。
  12. Therefore, fiber gratings have numerous applications in almost all the realms of optical fiber, especially in wavelength - division multiplexing ( wdm ) all - optical networks. this dissertation presents a detailed study of the following three types of fiber gratings : fiber bragg grating fabricated with cladding mode suppression fiber, linearly chirped moir fiber grating, and long - period fiber grating with rectangular index modulation

    本文以目前在wdm全光網中有良好應用前景的三種類型的光纖光柵（用包層模抑制光纖製作的光纖布拉格光柵、線性啁啾moir光纖光柵、矩形折射率調制型長周期光纖光柵）的理論和設計為研究內容。
  13. Cladding - guided mode

    包層傳導模
  14. The term of mode - filtered light refers to the observation that light initially propagating down an optical fiber can be decoupled from that fiber by increasing the cladding ri at the core / clad interface with a permeating analyte, thus changing the allowable propagating modes within the fiber, resulting in a continuous and nearly linear increase in mode - filtered light with increasing cladding ri

    所謂模式濾光，是指分析對象進入光纖包層引起光纖芯包界面的折射率增加，導致光纖內的部分傳導模不滿足傳導條件而從光纖的包層中側漏出來的光學信號，它與包層折射率的增量在一定條件下線性相關。
  15. The theoretical model describing the output properties of double - cladding mof laser has been builded according to the mof ’ s extraordinary mode distribution

    光纖後端面直接輸出時獲得了最大11 . 6w的輸出功率，斜率效率達到了86 %以上。
分享友人
分享到 Line

分享到臉書