cohesion test 中文意思是什麼
cohesion test
解釋
抱合檢驗-
By means of statistical inference as well as hypothesis test method, it is determined that the variables of compressive stress and shearing stress are of extreme - value distribution and that the variables of frictional coefficient and cohesion coefficient are of logarithmic normal distribution
應用統計推理和假設檢驗方法分析得知，壓應力與切應力隨機變量呈極值型分佈，摩擦系數與粘結力系數隨機變量呈對數正態分佈。 -
Standard test method for fiber cohesion in sliver and top in static tests
靜態試驗條件下紗條和毛條中纖維粘附力的標準試驗方法 -
Slurry surfacing - test method - part 4 : determination of cohesion of the mix
泥漿表面塗抹.試驗方法.第4部分:混合物粘合性測定 -
Standard test method for adhesion or cohesion strength of thermal spray coatings
熱噴塗層的粘附力或粘結強度的標準試驗方法 -
Slurry surfacing - test methods - determination of cohesion of the mix
砂漿路面層.試驗方法.混合物黏合性的測定 -
Standard test method for cohesion adhesion of sprayed fire - resistive materials applied to structural members
結構構件上噴塗的防火材料的粘附性粘結性的標準試驗方法 -
Fillers for interior use. measurement of adhesion - cohesion by a pull - off test
室內用填充物.用撕裂試驗法對附著粘合力的測量 -
According to elasto - plasticity theory, with the help of finite - method program ansys, the paper undertakes the computer analogue tests about the bearing capacity of pile tip arranged by orthogonal principle, and attains the relations of pile - tip bearing capacity to embedment depth, pile diameter, cohesion, internal friction angle and modulus of deformation. by the means of mathematical statistic, regression equation of the ultimate bearing capacity calculated by finite element method is gained through the regression analysis of 81 group data from the computer analogue tests. by comparison and analysis of the values calculated by finite - element regression equation and the values of in situ loading test, the regression equation is gained which calculates the size effect for base resistance of large diameter pile
根據彈塑性理論，運用大型有限元軟體ansys按正交設計理論對樁端承載力進行模擬計算，獲得樁端承載力與樁長（埋置深度） 、樁徑、粘聚力、內摩擦角及變形模量等主要影響因素的關系，並採用數理統計方法，對81組ansys模擬試驗結果數據進行回歸分析，得到有限元法確定樁端極限承載力的回歸公式，並將有限元法回歸公式計算值與現場小壓板載荷試驗值進行比較分析，得到大直徑樁端阻的尺寸效應系數計算公式。 -
The static triaxial test of two engineerings shows that the breaking strength of asphalt concrete declines significantly as the temperature rises and the strain increases noticeably when breaking. increase in the asphalt content leads to decrease in tangent modulus and cohesion, but the internal friction angle tends to increase. increasing confining stress results in the augment of the maximum stress and the ultimate value of volumetric strain
兩個實際工程的靜三軸變形與強度試驗表明，隨著溫度升高瀝青混凝土破壞強度明顯降低，破壞時應變明顯加大；瀝青含量的增加會導致切線模量和凝聚力降低，但內摩擦角趨于增加；周圍壓力增大會導致最大應力_ d增大，其體變壓縮極限值也越大。 -
Test method for building sealants part 9 : determination of adhesion cohesion properties after immersion in water
建築密封材料試驗方法第9部分:浸水后拉伸粘結性的測定 -
Building and construction sealants with movement accommodation factors greater than 25 % - method of test for determination of adhesion cohesion properties at variable temperatures
移動適應因數大於25 %的房屋和建築物密封劑.在可變溫度下粘著特性的測定的試驗方法 -
Hockman standard test method for adhesion and cohesion of elastomeric joint sealants under cyclic movement hockman cycle
在循環運動條件下彈性接合密封料的粘著性和粘結力的標準試驗方法 -
Standard test method for bond and cohesion of one - part elastomeric solvent release - type sealants
單一成份彈性溶劑釋放型密封膠的粘結力及粘聚力的標準試驗方法 -
Methods of dust character test - part 9 : determination of cohesion - normal pull rift method
粉塵物性試驗方法第9部分：粘結性的測定垂直拉斷法 -
Slurry surfacing - test methods - part 4 : determination of cohesion of the mix ; german version en 12274 - 4 : 2003
泥漿表面處理.試驗方法.第4部分:混合物黏合性測定 -
Bitumen and bituminous binders - determination of cohesion of bituminous binders with pendulum test
瀝青和瀝青粘合劑.用擺動試驗測定瀝青粘合劑的粘性 -
Bitumen and bituminous binders - determination of cohesion of bituminous binders with pendulum test ; german version en 13588 : 2004
瀝青和瀝青粘合劑.用擺動試驗測定瀝青粘合劑的粘性
分享友人