combustion control system 中文意思是什麼

combustion control system 解釋
燃燒調節系統
  • combustion : n. 1. 燃燒，發火，點火。2. （有機體內營養料的）氧化。3. 騷動。
  • control : n 1 支配，管理，管制，統制，控制；監督。2 抑制（力）；壓制，節制，拘束；【農業】防治。3 檢查；核...
  • system : n 1 體系，系統；分類法；組織；設備，裝置。2 方式；方法；作業方法。3 制度；主義。4 次序，規律。5 ...
  1. This thesis first studies the hydrokinetics, heat transfer characteristics, combustion and dynamics of cfbb. three types of single fuzzy controllers and a kind of synthetically fuzzy controller are designed, through the analysis of the control system of a certain plant

    本文通過對循環流化床的流體動力學特性、傳熱學特性、燃燒特性和動態特性等方面的研究，設計了三種單模糊控制器和一種綜合模糊控制器，分析了某一電廠實際控制系統，並對方案進行了比較。
  2. Through the study on the character of hydrokinetics and heat transfer and combustion and dynamic of cfbb, three kind of single fuzzy controllers and a kind of synthetically fuzzy controller are designed, and control system is analyzed in some one power plant, and the three kind of control scheme are simulated on deferent objects

    本文通過對循環流化床的流體動力學特性、傳熱學特性、燃燒特性和動態特性等的研究，設計了三種單模糊控制器和一種綜合模糊控制器，分析了某一電廠實際控制系統，並對這三種控制方案進行了變對象的模擬。
  3. A rational range of saturation pressure is proposed and a brief introduction of the combustion control system adopted in phase - change heaters is made

    研究了介質飽和壓力對相變換熱加熱爐受熱面布置的影響，提出了介質飽和壓力的合理范圍，對相變換熱加熱爐燃燒控制系統作了簡要介紹。
  4. According to the characters of the vibration of internal combustion engine and on bases of the theory of active vibrantion control which is carefully analyzed, the corresponding mathematical model suitable for the vibration of internal combustion engine is developed and the fuzzy control techniques are adopted. a new active vibration control system is developed w hich conclude mcu, the key part, and the equipment used to survey the vibrative acceleration of internal combustion engine

    本文根據內燃機振動的具體特點，在仔細分析了振動主動控制原理的基礎上，建立了適合內燃機整機振動的數學模型和採用了模糊控制方法，提出了一種新的內燃機整機振動主動控制減振系統，該系統以微控制器為核心，配以測加速度和控制機電轉換執行機構組成。
  5. Bed temperature and mainstream pressure are important parameter of circulating fluidized bed boiler ( cfbb ) combustion control system. to maintain them normal is key to the stable and economic operation of cfbb

    床溫和主汽壓是循環流化床鍋爐燃燒控制系統中的兩個重要參數，維持正常的床溫和主汽壓是循環流化床鍋爐穩定、經濟運行的關鍵。
  6. Presented in a newly developed measuring & control system used for internal combustion engine rig test

    摘要介紹了一種新開發的適用於發動機鑒定試驗的自動測量控制系統。
  7. Abstract : presented is a newly developed measuring & amp, control system used for internal combustion engine rig test

    文摘:介紹了一種新開發的適用於發動機鑒定試驗的自動測量控制系統。
  8. Boiler combustion control system based on model reference neural network

    基於參考模型神經網路的鍋爐燃燒系統控制
  9. I analyzed dynamic characteristics of vapor wraps water level and combustion control system, i compared the normal pi controller with combined controller of fuzzy controller and fuzzy - pi controller through the computer

    分析了鍋爐汽包水位動態特性和燃燒系統的動態特性。通過計算機把常規pi控制器與fuzzy控制器及fuzzy ? pi組合控制器進行了比較。
  10. First, the working principles of the combustion control system of marine main boiler in present use and its disadvantages are discussed in the paper ; in the light of the structure and motion traits of marine main boiler, the combustion control systems of single and double cross amplitude limits are designed. at the same time, the schematic diagram of system and recovery curves of some relative parameters are given, the system working principles and its advantages and disadvantages are discussed. based on the combustion control system of dual - crisscross amplitude limit, by selecting the independent variable, the fixed offset is improved into variable offset, the combustion control system of variable offset dual - crisscross amplitude limit is designed

    首先討論了目前船用主鍋爐燃燒控制系統的工作原理及存在的不足；針對船用主鍋爐的結構及運行特點，設計了單交叉限幅燃燒控制系統和雙交叉限幅燃燒控制系統，同時給出了系統原理圖及有關參數的過渡過程曲線，討論了系統工作原理及優缺點；在雙交叉限幅燃燒控制系統的基礎上，將固定偏置經過自變量的選取，改進成變偏置，設計了變偏置雙交叉限幅燃燒控制系統，給出了系統原理圖及有關參數的過渡過程曲線，同時也給出了空氣壓力和燃油流量正負偏置函數與變偏置折線函數的關系式。
  11. Based on simulation, 2 - dimension fuzzy control system was researched, which was used to control two correlative variables of circulating fluidized bed boiler " s combustion control system

    本論文在模擬的基礎上，研究用二維模糊控制實現流化床鍋爐燃料量控制系統的兩關聯變量的控制。
  12. Study and improvement of 300mw - unit coal - fired boiler combustion control system

    單元機組煤粉爐燃燒控制系統的研究及其改進
  13. Generally speaking, the boiler control equipment includes the vapor wraps water level control system and combustion control system

    一般說，鍋爐設備控制包括汽包水位控制系統和燃燒過程式控制制系統。
  14. Computerized intelligent combustion control system of heating furnace

    加熱爐燃燒的計算機智能控制系統
  15. This paper is aimed at studying and designing a new combustion control system according to the motion traits of marine main boiler and demands on combustion control system

    本文針對船用主鍋爐的運行特點及對燃燒控制系統的要求，研究並設計了一個新的燃燒控制系統。
  16. Abstract : design characteristics of the combustion control system for automatization retrofit of 200 mw unit in zhenhai power plant are demonstrated in detail. composition of the combustion control system is also introduced

    文摘:詳細介紹了鎮海發電廠200mw機組自動化改造中燃燒控制系統的設計特點及其系統構成。
  17. For big hysteresis control, response time is long and overmodulation is big, but dynamic performance figure is not good when we only use pi controller 。 so, i try to design the whole control project which composed of the vapor wraps water level control system and combustion control system use the control equipment of double cross - parameter fuzzy - pi controller

    單獨採用pi控制，對大滯后控制，響應時間及超調很大，但動態性能指標差。因此，嘗試採用雙交叉參數fuzzy - pi控制器。組成了汽包水位和燃燒雙交叉參數自調整fuzzy ? pi組合控制器的整體控制方案。
  18. Familiar with industrial kiln and combustion control system

    熟悉工業爐窯燃燒安全控制系統。
  19. Based on the furnace chamber flame monitoring system, this paper designed and analyzed a combustion control system with the main steam pressure as the primary adjusting parameter and the total radiant energy of the furnace chamber as the subsidiary parameter, and compared the advantages of the system with emulation research and the experimental test

    在爐膛火焰監測系統的基礎上，設計分析了以主蒸汽壓力為主調、以爐膛總輻射能為副調參數的燃燒控制系統，並通過模擬研究和試驗驗證，比較了該方法的優越性。
  20. It is important to raise heat efficiency of furnace and bring down the environment pollution. the target of my thesis is mainly to design the combustion control system of industry reheating furnace which based on the advanced control method

    提高工業加熱爐的熱效率，降低燃燒對環境造成的污染，採用先進的燃燒控制方法，應用自動化控制技術設計控制器是本論文工作的目的。
分享友人
分享到 Line

分享到臉書